Cellular plastics insulation was used in sandwich panel construction in Australia several decades ago. This paper reviews the field performance of such systems and discusses the lack of growth into urban housing construction. The slow development of appropriate standards is considered to be a contributory cause and the current situation is discussed in detail particularly in relation to performance in fire of the materials used and the composite panels.
Bromilow, F.J., "Industrialized Building," Third Australian Building Research Congress, Melbourne. Session F ( 1967).
2.
Leyendecker, E.V., "A General Preview of Operation Breakthrough ," in Performance Concept in BuildingsNational Bureau of Standards Special Publication 361, Vol. I, 255 (1972).
3.
The Housing Commission, Victoria, A new conception in villa housing (1969).
4.
Plastics Institute of Australia, Panelized Construction Seminar, Melbourne (1969).
5.
Lipscombe, D. , "Shay Gap: Challenging Traditional Building Techniques," Plastic News (Australia) (May 28, 1974).
Martin, K.G. and Souprounovich, A.N. , "Rigid Foamed Plastics. 2: Thermal Degradation ," CSIRO Australia Division of Building Research Report ( 1972 ).
8.
Keough, J.J., "Examination of the Fire Hazard of Foamed Polystyrene Panels," Australian Commonwealth Experimental Building Station Technical Record 42-75/386 ( 1968).
9.
Roberts, A.F. , "The Behaviour of Polyurethane Foam in Fire ," Insulation, 10 (November/December 1974).
10.
Patten, G.A. , "Ignition Temperatures of Plastics," Modern Plastics , 38 , 119 (1961).
11.
Scott, K.A., "Curently Accepted Materials and Future Trends," Plastics in Fire Conference Plastics Institute Agreement Board, London (1971).
12.
Dichert, E.A. and Toone, A.C., "Chemistry and Flame Retardancy of Rigid Urethane Foam," Modern Plastics , 42 (5) ( 1965).
13.
Dowling, V.P., Fire test methods in standards and regulations relating to cellular plastics CSIRO Australia Division of Building Research Report ( 1978 ).
14.
Australian Government Task Force to Investigate Modern Housing Techniques, "Interim Report to Minister for Housing and Construction," Australian Government Publishing Service (1974).
15.
Plastics Institute, Plastics in Building StructuresSymposium Publication Division, Pergamon Press (1966).
16.
Paper 28-"Optimum Design of Sandwich Struts and Beams" by H. G. Allen.
17.
Paper 29-"Plastics Sandwich Panels with Various Foamed Core Materials and their Behaviour Under Load," by B. Hughes and R. K. Wajda.
18.
Paper 30—"Structural Behaviour of Sandwich Panels with Foamed Plastics Cores," by W. W. O'Dell, Jr. and D. L. Graham.
19.
Paper 31-"Structural Potentials of Paper-Skin Polyurethane Foam Board," by J. J. Crandall.
20.
Paper 32-"Structural Building Panels with Expanded Polystyrene Cores," by R. L. Hummel.
21.
Paper 33—"The Physical Properties of Rigid Urethane Foam Sandwich Panels," by D. J. Doherty, G. W. Ball, and M. G. Walker.
22.
Paper 34-"The Design and Structural Applications of Urethane Cored Sandwich Panels," by B. H. Fisher.
23.
Platts, R.E. , Structural Sandwich Components in BuildingCanadaNRC, Division of Building Research Technical Paper 267 ( 1968).
24.
Allen, H.G.Analysis and Design of Structural Sandwich PanelsPergamon (1969).
25.
Plantema, F.J.Sandwich Construction. The Bending and Buckling of Sandwich Beams, Plates and ShellsWiley ( 1966).
26.
Pielert, J.H. , Reichardt, T.W., and Masters, L.W., "Structural Evaluation of Steel Faced Sandwich Panels," National Bureau of Standards Building Science Series51 (1974).
27.
Ferris, J.E. , "Fire Hazards of Combustible Wallboards," Department of Works, Commonwealth Experimental Building Station Special Report 18 (1955).
28.
Rogowski, B.F. , "The 'Fire Propagation Test' Its Development and Application," Fire Research Technical Paper 25, HMSO (1970 ).
29.
Rose, A., "Flammability of Lining and Insulating Materials," CANADA NRC, Division of Building Research Canadian Building Digest 141 (1972 ).
30.
Martin, K.G. , "Degradation of Rigid Cellular Plastics Under Fire Conditions in Buildings," Rev. Pure and Applied Chemistry , 21, 121 (1971).
31.
Gross, D., Loftus, J.J., Lee, T.G., and Gray, V.E., "Smoke and Gases Produced by Burning Aircraft Interior Materials," US National Bureau of Standards Building Science Series 18 (1969).
32.
Martin, K.G. and Powell, D.A., "Toxic Gas and Smoke Assessment Studies on Vinyl Floor Coverings with the Fire Propagation Test," Journal of Fire and Flammability , 3, 132 ( 1979).
33.
Eichner, H.W. , "Fire Endurance of Wood Frame and Sandwich Wall Panels," Journal of Fire and Flammability , 6, 155 (1975).
34.
Kaplan, M., Harris, R., Coglianese, F., Kujawa, F., and Ashe, W., "Cellular Plastics in Construction Applications and Fire Protection ," Journal of Cellular Plastics, 355 (July 1965).
35.
Briber, E.A. , "Flammability Requirements for Cellular Plastics as Materials of Construction," Journal of Cellular Plastics , 112 (March 1966).
36.
Gross, D., "Field Burnout Tests of Apartment Dwelling Units," US National Bureau of Standards Building Science Series10 (1967).
37.
Joint Fire Research Organization, Fire Research1969, HMSO (1970).
38.
Plastics Institute of Australia, "Full Scale Fire Test," Condensed Report of Commonwealth Experimental Building Station. Sponsored Investigation No. 446 (1970 ).
39.
Lie, T.T., "Contribution of Insulation in Cavity Walls to Propagation of Fire ," Canada NRC Division of Building Research Study 29 (1972 ).
40.
Underwriters Laboratories, "Flammability Study of Cellular Plastics," File NC 522. Project 68 NK 2927 (1969).
41.
Factory Mutual Research, "A Fire Study of Rigid Cellular Plastic Materials for Insulated Wall and Roof Ceiling Constructions," Project No. 22000 (1973).
42.
Maroni, W.F. , "Large Scale Fire Tests on Rigid Cellular Plastic Wall and Roof Insulations," National Fire Protection Association Convention, St. Louis (1973).
43.
Maroni, W.F. , "SLRP Analyses of Recommended Protection for Foamed-Plastic Wall-Ceiling Building Insulations," Fire Journal (Sept. 1974).
44.
Underwriters Laboratories, "Fact Finding Report on Enclosed Corner Testing of Expanded Polystyrene," File NC 554, Project 74NK 868 3 (1975).
