A Pressurized Spherical Elastomeric Membrane Undergoing Temperature Induced Scission and Crosslinking

Abstract

When an elastomeric material is held at a fixed state of stretch at a sufficiently high temperature, macromolecular network junctions undergo time-dependent scission and the applied force relaxes with time. The affected molecules recoil and crosslink to form a new network that is stress-free in a new reference configuration. A constitutive equation that accounts for this process as the elastomer undergoes a time-dependent deformation has been presented elsewhere. This constitutive equation is used to study the response of a pressurized spherical elastomeric membrane at a temperature high enough for the scission-crosslinking process to occur. It is shown that the membrane diameter increases with time. Moreover, there can be a finite time when the membrane diameter increases at an infinite rate, i.e. there is “runaway inflation”. This event depends on the elastic properties of the molecular networks, the rate of scission, the rate of formation of new networks, and the history of the increase in the membrane diameter. Numerical results are presented that illustrate these phenomena.

Get full access to this article

View all access options for this article.

References

[1] Tobolsky, A. V.: Properties and Structures of Polymers, Wiley, New York , Chapter V, 223-265 (1960).

[2] Septanika, E. G. and Ernst, L. J.: Application of the network alteration theory for modeling the time-dependent constitutive behaviour of rubbers. Part I. General Theory . Mech. Mater., 30, 265-273 (1998).

[3] Septanika, E. G. and Ernst, L. J.: Application of the network alteration theory for modeling the time-dependent constitutive behaviour of rubbers. Part II. Further evaluation of the general theory and experimental verification . Mech. Mater., 30, 253-263 (1998).

[4] Wineman, A. and Min, J.-H.: Time-dependent scission and crosslinking in an elastomeric cylinder undergoing circular shear and heat conduction . Int. J. Non-Linear Mech., 38, 969-983 (2003).

[5] Wineman, A. S, and Shaw, J. A.: Scission and healing in a spinning elastomeric cylinder at elevated temperature . J. Appl. Mech., 69, 602-609 (2002).

[6] Beatty, M. F.: Topics in finite elasticity: hyperelasticity of rubber, elastomers and biological tissues-with examples . Appl. Mech. Rev., 40, 1699-1734 (1987).

[7] Wineman, A.: Bifurcation of response of a nonlinear viscoelastic spherical membrane . Int. J. Solids Struct., 14, 197-212 (1978).

[8] Scanlan, J. and Watson, W. F.: The interpretation of stress-relaxation measurements made on rubber during aging . Trans. Faraday Soc., 54, 740-750 (1958).

[9] Tobolsky, A. V., Prettyman, I. B., and Dillon, J. H.: Stress relaxation of natural and synthetic stocks . J. Appl. Phys., 15, 380-395 (1944).

10.

[10] Neubert, D. and Saunders, D. W.: Some observations of the permanent set of crosslinked natural rubber samples after heating in a state of pure shear . Rheologica Acta, 1, 151-157 (1958).

11.

[11] Fong, J. T. and Zapas, L. J.: Chemorheology and the mechanical behavior of vulcanized rubber . Trans. Soc. Rheology, 20, 319-338 (1976).

12.

[12] Wineman, A. S., Jones, A., and Shaw, J. A.: Life-cycle and durability predictions of elastomeric components. Modeling and Simulation-Based Life Cycle Engineering, K. P. Chonget al., eds, Spon, New York , 155-169 (2002).

13.

[13] Bernstein, B. and Zapas, L. J.: Stability and cold drawing of viscoelastic bars . J. Rheology, 25, 83-94 (1981).

14.

[14] Green, A. E. and Adkins, J. E.: Large Elastic Deformations and Non-Linear Continuum Mechanics, Oxford University Press, Oxford (1960).

15.

[15] Carroll, M. M.: Pressure maximum behavior in inflation of incompressible elastic hollow spheres and cylinders . Q. Appl. Math., 45, 141-154 (1987).