This paper describes the dither control system used for suppressing drum brake squeal. The dither force is generated by a piezoceramic actuator installed on the back plate of a drum brake system and successfully quenches the drum brake squeal to background noise level above the critical dither actuation level. The dither is represented as a forcing function in sine waveform in a bi-axial two degrees of freedom mathematical model of drum brake squeal. The model parameters are based on the complex eigenvalue obtained from the mobility measurement and verified with the measured frequency response function. The numerical results show that dither control is more efficient at low sliding speed where lower dither force is needed to quench the brake squeal. Both measured and simulated results show that dither tends to excite the sidebands of the squeal peak with equal frequency spacing at both sides, and these sidebands shift closer to the squeal peak with increase in the dither actuation force.
BadertscherJCunefareKAFerriAA (2007) Braking impact of normal dither signals. Journal of Vibration and Acoustics129: 17–23.
2.
BrandtA (2010) Noise and vibration analysis: signal analysis and experimental procedures, UK: John Wiley & Sons.
3.
ChanSNMottersheadJECartmellMP (1995) Instabilities at subcritical speeds in discs with rotating frictional follower loads. Journal of Vibration and Acoustics, Transactions of the ASME117: 240–242.
4.
ChoS-HAhnS-TKimY-H (2002) A simple model to estimate the impact force induced by piston slap. Journal of Sound and Vibration255: 229–242.
5.
CunefareKGrafA (2002a) Experimental active control of automotive disc brake rotor squeal using dither. Journal of Sound and Vibration250: 579–590.
6.
CunefareKAGrafAJ (2002b) Experimental active control of automotive disc brake rotor squeal using dither. Journal of Sound and Vibration250: 579–590.
EhrichFF (1988) High order subharmonic response of high speed rotors in bearing clearance. Journal of Vibration, Acoustics Stress and Reliability in Design110: 9–16.
9.
EwinsDJ (1984) Modal testing: theory and practice, London: Research Studies Press Letchworth.
10.
GerberTMartinN (2013) Identification of harmonics and sidebands in a finite set of spectral components. In: tenth international conference on condition monitoring and machinery failure prevention technologies, Kraków, Poland.
11.
HamidMNATeohC-YRipinZM (2013) The operational deflection shapes and transient analysis of the brake shoes in drum brake squeal. Proceedings of the Institution of Mechanical Engineers Part D-Journal of Automobile Engineering227: 866–884.
12.
HaverkampMKoopmannN (2004) Acoustic quality control of drum brake shoes. In: conference - joint congress CFA/DAGA '04, Strasbourg, France, pp. 22–25.
13.
HoffmannNGaulL (2004) A sufficient criterion for the onset of sprag-slip oscillations. Archive of Applied Mechanics73: 650–660.
14.
HoffmannNFischerMAllgaierR (2002) A minimal model for studying properties of the mode-coupling type instability in friction induced oscillations. Mechanics Research Communications29: 197–205.
15.
HoffmannNWagnerNGaulL (2005) Quenching mode-coupling friction-induced instability using high-frequency dither. Journal of Sound and Vibration279: 471–480.
16.
HuangJKrousgrillCMBajajAK (2009) An efficient approach to estimate critical value of friction coefficient and sensitivity analysis for brake squeal. International Journal of Vehicle Design51: 21–38.
17.
HulténJ (1995) Some drum brake squeal mechanisms. SAE International951280: 377.
18.
JearsiripongkulTHochlenertD (2006) Disk brake squeal: modeling and active control. In: robotics, automation and mechatronics IEEE conference (RAM2006), Bangkok, Thailand: IEEE, pp. 1–5.
19.
KangJKrousgrillCMSadeghiF (2009a) Analytical formulation of mode-coupling instability in disc-pad coupled system. International Journal of Mechanical Sciences51: 52–63.
20.
KangJKrousgrillCMSadeghiF (2009b) Comprehensive stability analysis of disc brake vibrations including gyroscopic, negative friction slope and mode-coupling mechanisms. Journal of Sound and Vibration324: 387–407.
21.
KeitzelHHoffmannN (2006) Influence of the contact model on the onset of sprag-slip. Proceedings in Applied Mathematics and Mechanics6: 311–312.
LiuWPfeiferJL (2003) Introduction to brake noise & vibration. SAE Annual Brake Colloquium and Exhibition, Phoenix, USA.
24.
Michaux MA (2005) Suppression of friction-induced oscillations through use of high-frequency dither signals. PhD Thesis, Georgia Institute of Technology, Georgia.
25.
MichauxMAFerriAACunefareKA (2007) Effect of tangential dither signal on friction induced oscillations in an sdof model. Journal of Computational and Nonlinear Dynamics2: 201–210.
26.
MottersheadJEChanSN (1995) Flutter instability of circular discs with frictional follower loads. Journal of Vibration and Acoustics, Transactions of the ASME117: 161–163.
27.
NeubauerMOleskiewiczR (2008) Brake squeal control with shunted piezoceramics–efficient modelling and experiments. Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering222: 1141–1151.
28.
OuyangHMottersheadJECartmellMP (1998) Friction-induced parametric resonances in discs: Effect of a negative friction-velocity relationship. Journal of Sound and Vibration209: 251–264.
29.
PervozvanskiAACanudas-de-WitC (2002) Asymptotic analysis of the dither effect in systems with friction* 1. Automatica38: 105–113.
ShinKBrennanMJOhJE (2002) Analysis of disc brake noise using a two-degree-of-freedom model. Journal of Sound and Vibration254: 837–848.
32.
SinouJJJezequelL (2007) Mode coupling instability in friction-induced vibrations and its dependency on system parameters including damping. European Journal of Mechanics a-Solids26: 106–122.
33.
SinouJJThouverezFJezequelL (2003) Analysis of friction and instability by the centre manifold theory for a non-linear sprag-slip model. Journal of Sound and Vibration265: 527–559.
34.
TeohCYRipinZM (2011) Transient analysis of drum brake squeal with binary flutter and negative friction-velocity instability mechanisms. Journal of Vibroengineering13: 275–287.
35.
Teoh CY, Mohd. Ripin Z and Abdul Hamid MN (2011) Modeling of brake shoe in drum brake squeal. Regional Tribology Conference. Bayview Hotel, Langkawi Island, Malaysia.
36.
ThomsenJJ (1999) Using fast vibrations to quench friction-induced oscillations. Journal of Sound and Vibration228: 1079–1102.
37.
ThomsenJJ (2002) Some general effects of strong high-frequency excitation: stiffening, biasing and smoothening. Journal of Sound and Vibration253: 807–831.
