A Damage Analysis of Steel-Concrete Composite Beams Via Dynamic Methods: Part I. Experimental Results

Abstract

This paper is an experimental investigation on damage-induced changes in modal parameters of steel-concrete composite beams subject to small vibrations. Dynamic tests have been performed on two pairs of composite beams, whose connections have different linear densities, and three damage configurations for each beam have been analyzed. Damage was induced by removing concrete around some elements connecting the steel beam and the reinforced concrete slab and consequently causing a lack of structural solidarity between the two beams. Experiments revealed that: (i) unlike axial frequencies, flexural frequencies show a rather high sensitivity to damage and therefore can be considered as a valid indicator upon a diagnostic analysis; (ii) induced damage causes the nodes of flexural vibration modes to displace towards the damaged area; (iii) in addition to hindering relative sliding on the concrete-steel interface, the elements connecting the slab and the metallic beam play a key role in reducing transversal motions between the two beams. These experimental results were crucial to outline an accurate analytical model of the dynamic behavior of composite beams with damaged connectors and to formulate a diagnostic problem from dynamic test data. Part II of this research will deal with mechanical modeling of damaged composite beams and damage identification.

Get full access to this article

View all access options for this article.

References

Adams, R.D., Cawley, P., Pye, C.J., and Stone, B.J., 1978, “A vibration technique for non-destructively assessing the integrity of structures,” Journal of Mechanical Engineering Science 20(2), 93-100 .

Ansourian, P. and Roderick, J.W., 1978, “Analysis of composite beams,” ASCE Journal of Structural Division 104(10), 1631-1645 .

Biscontin, G. and Wendel, P., 1998, “Structural diagnostics of steel-concrete beams via dynamic methods,” Thesis (in Italian), University of Udine, Udine, Italy.

Biscontin, G., Morassi, A., and Wendel, P., 2000, “Vibrations of steel-concrete composite beams,” Journal of Vibration and Control 6, 691-714 .

Casas, J.R. and Aparicio, A.C., 1994, “Structural damage identification from dynamic-test data,” ASCE Journal of Structural Engineering 120(8), 2437-2450 .

Cerri, M.N. and Vestroni, F., 2000, “Detection of damage in beams subjected to diffused cracking,” Journal of Sound and Vibration 234(2), 259-276 .

Davini, C., Gatti F., and Morassi, A., 1993, “A damage analysis of steel beams,” Meccanica 28, 27-37 .

Davini, C., Morassi, A., and Rovere, N., 1995, “Modal analysis of notched bars: Tests and comments on the sensitivity of an identification technique,” Journal of Sound and Vibration 179(3), 513-527 .

Dilena, M., 2001, “Vibrations of steel-concrete beams with damage in the connection. Analytical models and damage detection,” Thesis (in Italian), University of Udine, Udine, Italy.

10.

Dilena, M. and Morassi, A., 2003, “A damage analysis of steel-concrete composite beams via dynamic methods: Part II. Analytical models and damage detection,” Journal of Vibration and Control 9, 529-565 .

11.

Ewins, D.J., 1984, Modal Testing: Theory and Practice, Research Studies Press, New York .

12.

Gattesco, N., 1999, “Analytical modeling of nonlinear behavior of composite beams with deformable connection,” Journal of Constructional Steel Research 52(2), 195-218 .

13.

Gattesco, N., Giuriani, E., and Gubana, A., 1997, “Low-cycle fatigue test on stud shear connectors,” ASCE Journal of Structural Engineering 123(2), 145-150 .

14.

Gelfi, P. and Giuriani, E., 1987, “Theoretical constitutive law for stud shear connectors,” Studi e Ricerche 9, 323-341 .

15.

Giuriani, E., 1983, “Deformable connectors in steel-concrete composite beam,” Studi e Ricerche 5, 259-295 .

16.

Gladwell, G.M.L. and Morassi, A., 1999, “Estimating damage in a rod from changes in node positions,” Inverse Problems in Engineering 7, 215-233 .

17.

Hassiotis, S. and Jeong, G.D., 1995, “Identification of stiffness reductions using natural frequencies,” ASCE Journal of Engineering Mechanics 121(10), 1106-1113 .

18.

Hearn, G. and Testa, R.B., 1991, “Modal analysis for damage detection in structures,” ASCE Journal of Structural Engineering 117(10), 3042-3063 .

19.

Johnson, R.P., 1994, Composite Structures of Steel and Concrete, Blackwell Scientific, Oxford, UK .

20.

Kristek, V. and Studnicka, J., 1982, “Analysis of composite girders with deformable connectors,” Proceedings of the Institution of Civil Engineers 73(2), 699-712 .

21.

Liang, R.Y., Hu, J., and Choy, F., 1992, “Quantitative NDE technique for assessing damages in beam structures,” ASCE Journal of Engineering Mechanics 118(7), 1468-1487 .

22.

Morassi, A., 2001, “Identification of a crack in a rod based on changes in a pair of natural frequencies,” Journal of Sound and Vibration 242(4), 577-596 .

23.

Morassi, A. and Rollo, M., 2001, “Identification of two cracks in a simply supported beam from minimal frequency measurements,” Journal of Vibration and Control 7, 729-739 .

24.

Morassi, A. and Rovere, N., 1997, “Localizing a notch in a steel frame from frequency measurements,” ASCE Journal of Engineering Mechanics 123(5), 422-432 .

25.

Narkis, Y., 1994, “Identification of crack location in vibrating simply supported beams,” Journal of Sound and Vibration 172(4), 549-558 .

26.

Oehlers, D.J. and Foley, L., 1985, “The fatigue strength of stud shear connections in composite beams,” Proceedings of the Institution of Civil Engineers 79(2), 349-364 .

27.

Oehlers, D.J., Ghosh, A., and Wahab, M., 1995, “Residual strength approach to fatigue design and analysis,” ASCE Journal of Structural Engineering 121(9), 1271-1279 .

28.

Rocchetto, L., 2000, “Vibrations of steel-concrete beams with damage in the connection. Experimental results,” Thesis (in Italian), University of Udine, Udine, Italy.

29.

Rovere, N., 1992, “Application of an identification technique for damage detection in one-dimensional elements,” Thesis (in Italian), University of Udine, Udine, Italy.

30.

Ruotolo, R., 1997, “Tecniche basate sulle vibrazioni per l'identificazione del danno strutturale,” PhD Thesis (in Italian), Polytechnic of Turin, Turin, Italy.

31.

Ruotolo, R. and Surace, C., 1997, “Damage assessment of multiple cracked beams: numerical results and experimental validation,” Journal of Sound and Vibration 206(4), 567-588 .

32.

Vestroni, F. and Capecchi, D., 1996, “Damage evaluation in cracked vibrating beams using experimental frequencies and finite element models,” Journal of Vibration and Control 2, 69-86 .