Inertial Stick-Slip Actuator for Active Control of Shape and Vibration

Abstract

A newly proposed actuator concept, that uses an inertial mass driven by a piezoelectric element to cause stick-slip motion of a tube whose movement is resisted by friction, is found to be suitable for use as active struts in truss structures. The actuator is capable of performing shape control to correct for static and quasi-static distortion by changing its length by large amounts. It is also capable of controlling vibration by changing length by small amounts at varying speed. A simple, singledegree-of-freedom analytical model of the actuator is set up as a design tool and compared to the actual behavior of a prototype. Different driving waveforms have been investigated experimentally under various working conditions and it has been found that an asymmetric 2 kHz waveform produces good results over a wide range of different parameters. Finally, the open loop behavior of the prototype actuator has been measured by following triangular and sinusoidal paths at various frequencies. It is found that the actuator compares favorably with the best long stroke actuators available at present, and has two key advantages over them. It is mechanically much simpler, since it requires a single piezoelectric element and no high-precision machining, and its performance does not deteriorate after extensive use.

Get full access to this article

View all access options for this article.

References

Anderson, E.H. , Moore, D.M. , Fanson, J.L. and Ealey, M.A. , 1990, "Development of an Active Truss Element for Control of Precision Structures," Optical Engineering, Vol. 29, No. 11, pp. 1333-1341.

Blackford, B.L. , Jericho, M.H. and Boudreau, M.G. , 1992, "A Vertical/Horizontal Two-dimensional Piezoelectric Driven Inertial Slider Micropositioner for Cryogenic Applications," Review of Scientific Instruments, Vol. 63, No. 4, pp. 2206-2209.

Burleigh Instruments Inc. , 1993, "Micropositioning Systems," Fishers, NY, USA.

Darby, A. P. and Pellegrino, S. , 1997, "Active alignment control of a payload using non-linear, long-stroke actuators." In Proc. IUTAM Symposium on Interaction between Dynamics and Control in Advanced Mechanical Systems, 21-26 April, 1996, Eindhoven University of Technology (Edited by D. H. van Campen ), pp. 91-100. Kluwer.

Darby, A. P. and Pellegrino, S. , 1998, "Modelling and control of a flexible structure incorporating inertial stick-slip actuators." To appear in: Journal of Guidance, Control, and Dynamics.

Geng, Z. and Haynes, L.S. , 1992, "Multiple Degree-of-Freedom Active Vibration Control Using a Stewart Platform," Third International Conference on Adaptive Structures, pp. 499-513.

Morgan Matroc Ltd. , "Piezoelectric Ceramics," Thornhill, Southampton, U.K.

Newton, D. , Garcia, E. and Horner, G. C. , 1994, "Development of a Linear Piezoelectric Motor," AIAA/ASME Adaptive Structures Forum, 21-22 April 1994, Hilton Head, SC, pp. 101-106.

Renner, C. , Niedermann, P. , Kent, A.D. and Fischer, O. , 1990, "A Vertical Piezoelectric Inertial Slider," Review of Scientific Instruments, Vol. 61, No. 3, pp. 965-967.

10.

Sekine, K. , Shibayama, Y. , Iwasawa, N. , Tagawa, N. , Sunahara, S. , Yoshida, S. and Arikabe, T. , 1990, "Identification and Adaptive Control of Flexible Truss Structures," First Joint US./Japan Conference on Adaptive Structures, pp. 458-484.

11.

Takahara, K. , Kuwao, F. , Shigehara, M. , Katoh, T. , Motohashi, S. and Na-1010 tori, M. , 1989, "Piezo Linear Actuators for Adaptive Truss Structures." In Adaptive Structures, (Edited by B.K. Wada ), ASME, pp. 83-88.

12.

Umland, J.W. and Chen, G.-S. , 1992, "Active Member Vibration Control for a 4 Meter Primary Reflector Support Structure," 33rd AIAA/ ASME/ASCE/AHS/ASC Structures, Structural Dynamics & Materials Conference, pp. 393-401.

13.

Welland, M.E. , 1994, Personal Communication.

14.

Wietharn, M.E. , 1991, "Motion Control Systems: Electromechanical Linear Actuators," Mechanical Engineering, September, pp. 87-90.

15.

Woodburn, C.N. , McKinnon, A.W. , Roberts, D.A. , Taylor, M.E. and Welland, M.E. , 1993, "A One-dimensional Piezoelectric-Driven Inertial Micropositioner with Vertical Capabilities," Measurement, Science and Technology, No. 4, pp. 535-537.