Evaluation of flow-induced vibration suppression performances of magneto-rheological damping pipe clamp using PID algorithm

Abstract

In order to suppress the low-frequency flow-induced vibration of fluid conveying pipeline, this paper develops a magnetorheological damping (MRD) pipe clamp due to its simple structure and strong dynamic adjustability. The mechanical dynamic model of MRD pipe clamp is established, and the vibration control algorithm based on PID is simulated. Comparison analysis on the vibration damping performance of the MRD pipe clamp under uncontrol, passive control, and PID control are conducted. The damping performances of MRD pipe clamp are tested under uncontrol, passive control, and PID control algorithm. The experiment results exhibited that the attenuation rate of each axial displacement and acceleration of pipe system using PID algorithm were more than 80% under sinusoidal excitation force of 600 N and excitation frequency of 2.5 Hz. The experiment results have verified the correctness of the simulation analysis in terms of value and trend. This research will provide the guide for the design and engineering application of MRD pipe clamp system.

Keywords

Pipeline vibration MRD pipe clamp PID control MATLAB/Simulink simulation vibration suppression

Get full access to this article

View all access options for this article.

References

Dyke

Spencer

Sain

, et al. (1996) Modeling and control of magnetorheological dampers for seismic response reduction. Smart Materials and Structures 5: 565–575.

Gong

Nie

, et al. (2022) Pipeline vibration control using magnetorheological damping clamps under fuzzy-PID control algorithm. Micromachines 13(4): 531.

Tong

, et al. (2020) Development and evaluation of a MR damper with enhanced effective gap lengths. IEEE Access 8: 156347–156361.

Huang

Nie

, et al. (2020) Research on semi-active vibration control of pipeline based on magneto-rheological damper. Applied Sciences 10(7): 2541.

Khot

Yelve

Tomar

, et al. (2012) Active vibration control of cantilever beam by using PID based output feedback controller. Journal of Vibration and Control 18(3): 366–372.

Lin

(2009) Instantaneous optimal semi-active control of MR damper based on trust region method. Engineering Mechanics 9: 36–42.

Deng

Wang

, et al. (2021) Active vibration control of secondary suspension based on high-temperature superconducting maglev vehicle system. Physica C: Superconductivity and its Applications 585(2): 1353872.

Marchi

Morgenstern

(2017) Controlling noise and vibration from a pipeline pump station. Sound and Vibration 5: 8–11.

Miah

Chatzi

Weber

(2015) Semi-active control for vibration mitigation of structural systems incorporating uncertainties. Smart Materials and Structures 24(5): 55016.

10.

Nie

Xin

, et al. (2019) Optimization and performance analysis of magnetorheological fluid damper considering different piston configurations. Journal of Intelligent Material Systems and Structures 30(5): 764–777.

11.

Oke

Khulief

(2018) Effect of internal surface damage on vibration behavior of a composite pipe conveying fluid. Composite Structures 194: 104–118.

12.

Praveen

Kuchibhatla

SAR

Singh

, et al. (2020) Performance of magnetorheological elastomer based torsional vibration isolation system for dynamic loading conditions. Journal of Central South University 27(1): 144–154.

13.

Wang

(2009) Analysis of the influence of pipeline system structure and its parameters on impact response. Ship Engineering 5: 58–61.

14.

Zhang

Schmidt

Qin

(2015) Active vibration control of piezoelectric bonded smart structures using PID algorithm. Chinese Journal of Aeronautics 28(1): 305–313.

15.

Zhang

Zhao

, et al. (2017) Experimental and numerical studies on a composite MR damper considering magnetic saturation effect. Engineering Structures 132: 576–585.