Damping Properties of Epoxy Films with Nanoscale Fillers

Abstract

This study demonstrates improved damping in epoxy films using nanoscale fillers. The mechanism for damping improvement is related to frictional energy dissipation arising from interfacial sliding at the nanofiller-matrix interface. The combination of extremely large interfacial contact area, high aspect ratio, many interfaces, and low density implies that nanoscale fillers could be far more efficient with regard to damping augmentation than traditional fillers. In this study, three categories of nanoscale fillers are investigated; (1) silica nanoparticles, (2) silicon nanorods, and (3) silicon nanosprings. The nanofillers are dispersed in an epoxy matrix and the nanocomposite film is tested dynamically (in the shear mode) using an MTS-858 servohydraulic test facility. The results indicate that nanospring fillers generate greater energy dissipation than nanoparticles or nanorods. The material loss factor (or damping ratio) of the epoxy film (with silicon nanospring fillers) showed a 150% increase compared to the baseline (pure) epoxy. The nanocomposite damping materials developed here show the potential to overcome the limitations of traditional viscoelastic polymers and could help to efficiently deliver significant levels of damping to structural components.

Keywords

damping energy dissipation interfacial sliding nanoscale fillers

Get full access to this article

View all access options for this article.

References

Ajayan, P.M. , Shadler, L.S. , Giannaris, C. and Rubio, A. 2000. “Single-Walled Carbon Nanotube-Polymer Composites: Strength and Weakness,” Advanced Materials, 12(10): 750-753 .

Anderson, G.L. and Garg, D.P. 2000. “Research in Active Composite Materials and Structures: An Overview,” In: SPIE Proceedings on Smart Structures and Materials Conference, Newport Beach, CA, March 5-9, pp. 2-12 .

Baz, A. and Ro, J. 1994. “The Concept and Performance of Active Constrained Layer Damping Treatments,” Journal of Sound and Vibration, 28(3): 18-21 .

Biggerstaff, J.M. and Kosmatka, J.B. 1998. “Damping Performance of Cocured Graphite/Epoxy Composite Laminates with Embedded Damping Materials,” Journal of Composite Materials, 33(15): 1457-1469 .

Huang, S.C. , Inman, D.J. and Austin, E.M. 1996. “Some Design Considerations for Active and Passive Constrained Layer Damping Treatments,” Smart Materials and Structures, 5(3): 301-313 .

Karabacak, T. , Singh, J.P. , Zhao, Y.-P. , Wang, G.-C. and Lu, T.-M. 2003. “Scaling During Shadowing Growth of Isolated Nanocolumns,” Phys. Rev. B, 68(12): 125408-1-125408-5 .

Kosamata, J.B. and Liguore, S.L. 1993. “Review of Methods for Analyzing Constrained layer Damping Structures,” Journal of Aerospace Engineering, 6(4): 268-283 .

Lakhtakia, A. and Messier, R. 2001. “Sculptured Thin Films,” Optics & Photonics News, 12(9): 26-31 .

Liao, W.H. and Wang, K.W. 1996. “A New Active Constrained Layer Configuration with Enhanced Boundary Actions,” Smart Materials and Structures, 5(5): 638-648 .

10.

Liao, W.H. and Wang, K.W. 1997. “On the Analysis of Viscoelastic Materials for Active Constrained Layer Damping Treatments,” Journal of Sound and Vibration, 207(3): 319-334 .

11.

Liao, W.H. and Wang, K.W. 1998. “Characteristics of Enhanced Active Constrained Layer Damping Treatments with Edge Elements,” ASME Journal of Vibration and Acoustics, 120(4): 886-893 .

12.

Liu, Y. and Wang, K.W. 1999. “A Non-dimensional Parametric Study of Enhanced Active Constrained Layer Damping Treatments,” Journal of Sound and Vibration, 223(4): 611-644 .

13.

Liu, Y. and Wang, K.W. 2000. “Active-passive Hybrid Constrained Layer for Structural Damping Augmentation,” ASME Journal of Vibration and Acoustics, 122(3): 254-262 .

14.

Malac, M. , Egerton, R. and Brett, M. 2001. “Thin Films Deposited at Glancing Incidence and their Applications,” Vacuum Technology & Coating, 2: 48-52 .

15.

Maly, J.R. and Johnson, C.D. 1996. “Cocured Viscoelastic Composites,” In: SPIE Proceedings on Smart Structures and Materials Conference, San Diego, CA, February 26-27, pp. 365-376 .

16.

Painter, P. and Coleman, M. 1997. Fundamentals of Polymer Science, CRC Press, New York .

17.

Panda, B. , Mychalowycz, E. and Tarzanin, F.J. 1996. “Application of Passive Dampers to Modern Helicopters,” Journal of Smart Materials and Structures, 5(5): 509-516 .

18.

Schadler, L.S. , Giannaris, S.C. and Ajayan, P.M. 1998. “Load Transfer in Carbon Nanotube Epoxy Composites,” Applied Physics Letters, 73(26): 3842-3844 .

19.

Shen, I.Y. 1994. “Hybrid Damping through Intelligent Constrained Layer Treatments,” ASME Journal of Vibration and Acoustics, 116(3): 341-349 .

20.

Singh, J.P. , Yang, G.R. , Lu, T.-M. and Wang, G.-C. 2002. “Retardation of Oxidation in Co Nano-columns,” Applied Physics Letters, 81(24): 4601-4603 .

21.

Thostenson, E.T. and Chou, Y.-W. 2002. “Aligned Multi-walled Carbon Nanotube-reinforced Composites: Processing and Mechanical Characterization,” J. Phys. D: Appl. Phys., 35(16): L77-L80 .

22.

Wagner, H.D. , Lourie, O. , Feldman, Y. and Tenne, R. 1998. “Stress-induced Fragmentation of Multiwall Carbon Nanotubes in a Polymer Matrix,” Applied Physics Letters, 72(2): 188-190 .

23.

Ye, D.-X. , Zhao, Y.-P. , Yang, G.-R. , Wang, G.-C. and Lu, T.-M. 2002. “Manipulating the Column Tilt Angles of Nanocolumar Films by Glancing-angle Deposition,” Nanotechnology, 13(5): 615-618 .

24.

Zhao, Y.-P. , Ye, D.-X. , Wang, G.-C. and Lu, T.-M. 2002a. “Novel Nano-column and Nano-flower Arrays by Glancing Angle Deposition,” Nano Letters, 2(4): 351-354 .

25.

Zhao, Y.-P. , Ye, D.-X. , Wang, P.-I. , Wang, G.-C. and Lu, T.-M. 2002b. “Fabrication of Si Nanocolumns and Si Square Spirals on Self-assembled Monolayers Colloid Substrates,” International Journal of Nanoscience, 1(1): 87-97 .

26.

Zhou, X. , Wang, K.W. and Bakis, C. 2004. “The Investigation of Carbon Nanotube Based Polymers for Improved Structural Damping,” In: SPIE Proceedings on Smart Structures and Materials Conference, San Diego, CA, March 14-18, pp. 18-29 .