Experimental research on stability enhancement for centrifugal compressors using active control casing treatment system

Abstract

Centrifugal compressors are widely used in many fields, where they become unstable when operated at the edge of the surge line. This paper presents a method, which is based on the active control casing treatment to enhance the operating stability of the centrifugal compressor. To investigate the effect of the active control casing treatment system on the performance of a centrifugal compressor, a test rig with rotating speed of 15,000 r/min was built up. The experimental results show that the active control casing treatment system can significantly decrease the surge flow rate and extend the envelope of stable operation via injecting gas (so-called the control gas) into the casing of the centrifugal compressor. The tested maximal enhancement ability is 30.55% at the condition of 10,586 r/min when the flow rate of the control gas is 2.5 m³/min. It was found that the enhancement ability increases with the decrease of the rotating speed of the centrifugal compressor. The increment of the control gas flow rate results in a smaller surge flow rate of the centrifugal compressors.

Keywords

Centrifugal compressor surge active control casing treatment stability enhancement

Get full access to this article

View all access options for this article.

References

Zhang

Mao

. Experimental investigation and improvement of the inlet guide vane with plate vane in a centrifugal fan. Proc IMechE, Part A: J Power and Energy 2009; 223: 401–413.

Coppinger

Swain

. Performance prediction of an industrial centrifugal compressor inlet guide vane system. Proc IMechE, Part A: J Power and Energy 2000; 214: 153–164.

Fisher FB. Application of map width enhancement devices to turbocharger compressor stages. SAE paper no. 880794, 1988.

Sun

. Numerical and experimental investigation of a compressor with active self-recirculation casing treatment for a wide operation range. Proc IMechE, Part D: J Automobile Engineering 2013; 227: 1227–1241.

Sun

Zhang

. Switchable dual-port casing treatment scheme for an enhanced turbocharger compressor operating range. Proc IMechE, Part D: J Automobile Engineering 2014; 228: 235–244.

Zheng

Lan

. Improvement in the performance of a high-pressure-ratio turbocharger centrifugal compressor by blade bowing and self-recirculation casing treatment. Proc IMechE, Part D: J Automobile Engineering 2014; 228: 73–84.

Hunziker

Dickmann

H-P

Emmrich

. Numerical and experimental investigation of a centrifugal compressor with an inducer casing bleed system. Proc IMechE, Part A: J Power and Energy 2001; 215: 783–791.

Ding

Wang

Yang

. Experimental investigation of the casing treatment effects on steady and transient characteristics in an industrial centrifugal compressor. Exp Therm Fluid Sci 2013; 45: 136–145.

Tamaki H. Effect of recirculation device on performance of high pressure ratio centrifugal compressor. In: Proceedings of ASME turbo expo, UK, 2010, GT2010-22570.

10.

Zheng

Lan

11.

Nie

Tong

Geng

. Experimental investigations of micro air injection to control rotating stall. J Therm Sci 2007; 16: 1–6.

12.

Lim

H-S

Bae

H-J

Lim

Y-C

. Injection profile effects on low speed axial compressor stability enhancement. J Mech Sci Technol 2011; 25: 1501–1507.