A 5MW direct-drive generator for floating spar-buoy wind turbine: Development and analysis of a fully coupled Mechanical model

Abstract

This work forms the first of a two-part investigation aimed at identifying the challenges and opportunities of implementing a direct-drive generator for a spar-buoy type floating wind turbine. Preliminary specifications are presented for a fully coupled aero-hydro-servo-elastic model of a floating wind turbine with a 5 MW direct-drive generator. The drive-train model uses a low-speed, high-torque radial flux permanent magnet generator supported by two main-shaft bearings. The mechanical properties of the drive-train, including the main dimensions, mass of major nacelle equipment and details for the hub/nacelle assembly are presented. The rationale behind the adjustments to the tower and platform properties and the motivation to selection of best arrangement that is appropriate for supporting the developed system is explained. A discussion on the development of the variable speed-variable pitch control system suitable for the direct-drive system including modifications to avoid negative damping and blade-pitch instability are presented. Fully coupled simulations for the developed aero-hydro-servo elastic model were carried out in HAWC2 for the normal operating conditions of the wind turbine. The aerodynamic response of the model was verified and compared with that of a geared floating wind turbine system. Some initial results comparing the main shaft loads of the land-based and floating versions of the direct-drive wind turbine suggest satisfactory dynamic behaviour of the drive-train. The results prompt further research using a detailed drive-train model to verify the internal response, loading and durability of the components to assess their compatibility with a floating wind turbine system.

Keywords

Floating wind turbine direct-drive generator drive-train controller tower platform

Get full access to this article

View all access options for this article.

References

Floating Offshore Wind Foundations: Industry Consortia and Projects in the United States, Europe and Japan. May 2013 update. An Overview by Main(e) International Consulting LLC, http://maine-intl-consulting.com/resources/Floating+Offshore+Wind+Platforms+Consortia+for+web.pdf (accessed October 2013).

Jonkman JM. Dynamics modeling and loads analysis of an offshore floating wind turbine. NREL/TP-500-41958, November 2007.

Skaare B, Hanson TD, Nielsen FG, et al. Integrated dynamic analysis of floating offshore wind turbines. In: European wind energy conference, Milan, Italy, 2007.

Karimirad

Moan

. Wave and wind induced dynamic response of a spar-type offshore wind turbine. J Waterway Port Coastal Ocean Eng 2012; 138: 9–20.

Robertson AN and Jonkman JM. Loads analysis of several offshore floating wind turbine concepts. In: The international society of offshore and polar engineers conference, Maui, Hawaii, 19–24 June 2011.

Utsunomiya T, Matsukuma H, Minoura S, et al. At sea experiment of a hybrid spar for floating offshore wind turbine using 1/10-scale model. Offshore Mechanics and Arctic Engineering, June 2013, p. 135.

Sethuraman L, Venugopal V and Mueller MA. Drive-train configurations for floating wind turbines: On the assessment of key design parameters and technology option. In: Eighth international conference & exhibition on ecological vehicles and renewable energy, Monte Carlo, 26–30 March 2013.

Link H, LaCava W, Van Dam J, et al. Gearbox reliability collaborative project report: Findings from Phase 1 and Phase 2 testing, NREL/TP-5000-51885, 2011.

Xing Y, Karimirad M and Moan T. Effect of spar-type floating wind turbine nacelle motion on drivetrain dynamics. In: Proceedings of EWEA 2012 annual event, Copenhagen, Denmark, 16–19 April 2012.

10.

Xing Y, Karimirad M and Moan T. Modelling and analysis of floating spar-type wind turbine drivetrain. Wind Energy 2012: 1–23. DOI: 10.1002/we.

11.

Advanced Wind Turbine Drive Train Concepts: Workshop report. US Department of Energy, Energy Efficiency and Renewable Energy, Wind and Water Program. NREL, Wind and Hydropower Technologies Program, www.nrel.gov/docs/fy11osti/50043.pdf (accessed October 2013).

12.

Leban K, Ritchie E and Argeseanu A. Design preliminaries for direct drive underwater wind turbine generator, In: XXth international conference on electrical machines (ICEM), Marseille, 2–5 September 2012.

13.

Boulder Wind Power. Advanced Gearless Drivetrain - Phase I Technical Report. U.S. DOE Wind and Water Power Program, www.osti.gov/bridge/servlets/purl/1050994/ (accessed October 2013).

14.

Larsen TJ and Hansen AM. How2 HAWC2. User Manual, Risø National Laboratory Riso-R-1597(ver. 4-3), Technical University of Denmark, Lyngby, Denmark, 2012.

15.

Welcome to Simpack, http://www.simpack.com/ (accessed October 2013).

16.

Dubois MR, Polinder H and Ferreira JA. Comparison of generator topologies for direct-drive wind turbines. In: Proceedings of Nordic countries power & industrial electronics conference, Aalborg, Denmark, June 2000.

17.

Direct Drive (Gearless) Wind Turbine Market, By Permanent Magnet (PMSG) & Electrically Excited (EESG) Generator Technology, Turbine Size/Capacity Range - Global Trends & Forecasts to 2017, http://www.marketsandmarkets.com/Market-Reports/direct-drive-gearless-wind-turbine-market-805.html (accessed October 2013).

18.

Bang D, Polinder H, Shrestha G, et al. Review of generator systems for direct drive wind turbines. In: 2008 European wind energy conference, Brussels, 2008.

19.

Paulsen US, Vita L, Madsen HA, et al. 1st DeepWind 5 MW baseline design. Energy Procedia 2012; 24: 27–35.

20.

Borgen E. Introduction of the sway turbine ST10. In: IQPC 3rd international conference drivetrain concepts for wind turbines, Germany, 22–24 October 2012.

21.

Sethuraman

Venugopal

Zavvos

. Structural integrity of a direct-drive generator for a floating wind turbine. Renew Energy 2014; 63: 597–616.

22.

Stander

Venter

Kamper

. Review of direct drive radial flux permanent magnet generator mechanical design. Wind Energy 2012; 15: 459–472.

23.

Poore R and Lettenmaier T. Alternative design study report: WindPACT advanced wind turbine drive train designs study, 2002.

24.

Smith EB. Nacelle design for a 10MW reference wind turbine. M.S. Thesis, NTNU, 2012.

25.

Jonkman J. Definition of the floating system for phase IV of OC3. NREL/TP-500-47535, May 2010.

26.

Jonkman J, Butterfield S, Musial W, et al. Definition of a 5-MW reference wind turbine for offshore system development. NREL/TP-500-38060, February 2009.

27.

Zavvos A, McDonald AS and Mueller M. Structural optimisation tools for iron cored permanent magnet generators for large direct-drive wind turbines. In: Renewable power generation conference (RPG 2011), Edinburgh, UK, 6–8 September 2011.

28.

Bang D and Polinder H. Electromagnetic optimization of direct-drive generators. Upwind Deliverable No.: D 1B2.b.hp2, www.upwind.eu/media/832/Deliverable_1B2.b.hp2.pdf (accessed October 2013).

29.

http://www.mtoi.es/en/productos-y-servicios/index.aspx (accessed October 2013).

30.

Spooner E, Gordon P and French CD. Lightweight, ironless-stator, PM generators for direct-drive wind turbines. In: Second international conference on power electronics, machines and drives (PEMD), Edinburgh, 2004.

31.

Turi MB and Marks CS. Bearing selection techniques as applied to main shaft direct and hybrid drives for wind turbines. TIMKEN Technical Paper, http://www.whereyouturn.com/ja-jp/about/NewsRoom/MediaKits/Documents/MainShaftTechPaper.pdf (accessed October 2013).

32.

Jonkman JM. Dynamics modeling and loads analysis of an offshore floating wind turbine. PhD Thesis, University of Colorado-Boulder, 2007.

33.

Fingersh L, Hand M and Laxson A. Wind turbine design cost and scaling model. NREL/TP-500-40566, 2006.

34.

Malcolm DJ and Hansen AC. WindPACT turbine rotor design study June 2000–June 2002. NREL/SR-500-32495, Revised April 2006.

35.

Kooijman HJT, Lindenburg C, Winkelaar D, et al. DOWEC 6 MW pre-design: Aero-elastic modeling of the DOWEC 6 MW pre-design in PHATAS DOWEC-F1W2-HJK-01-046/09, Energy Research Center of the Netherlands, September 2003.

36.

SolidWorks 2013. http://www.solidworks.com/launch/solidworks-2013-overview.htm (accessed October 2013).

37.

Hau E. Vibration characteristics. Wind Turbines 2013. Springer Berlin Heidelberg, 2013, pp.233–268.

38.

Ferdinand P, Beer E, Russell Johnston J, et al. Mechanics of materials. New York: The McGraw-Hill Companies, 2002.

39.

https://wind.nrel.gov/forum/wind/viewtopic.php?f=4&t=743 (accessed October 2013).

40.

Versteegh Kivi CJA and Voordracht N. Direct driven generators in wind turbines: Experience with the 5 MW prototype. XEMC Darwind, 7 November 2011, https://afdelingen.kiviniria.net/media-afdelingen/DOM100000223/Verslagen_presentaties/2011/20111107_XEMC-Darwind_symposium/KeesV-Presentatie_Kivi_TUE_7112011.pdf (accessed July 2013).

41.

http://www.goldwindamerica.com/technology-capabilities/2-5-mw-pmdd/ (accessed February 2014).

42.

Johannessen K, Meling TS and Haver S. Joint distribution for wind and waves in the northern North Sea. In: International Offshore and Polar Engineering Conference, International Society of Offshore and Polar Engineers (ISOPE), Cupertino, CA, 2001.

43.

Zavvos A, McDonald AS and Mueller MA. Optimized mechanical structures of direct-drive generators. Upwind Research report (Deliverable No.: D 1B2.b.5), http://www.upwind.eu/media/823/Deliverable_1B2.b.5.pdf (accessed August 2013).

44.

Zavvos

Bang

McDonald

. Structural analysis and optimisation of transverse flux permanent magnet machines for 5 and 10 MW direct drive wind turbines. Wind Energy 2012; 15: 19–43.

45.

McDonald

Mueller

. A light-weight low speed permanent magnet electrical generator for direct-drive wind turbines. Wind Energy 2009; 12: 768–780.

46.

Shrestha G. Structural flexibility of large direct drive generators for wind turbines. PhD Thesis, Delft University of Technology, 2013.

47.

Maples B, Hand M and Musial W. Comparative assessment of direct drive high temperature superconducting generators in multi-megawatt class wind turbines. Technical Report NREL/TP-5000-49086, October 2010.

48.

Matha D. Model development and loads analysis of an offshore wind turbine on a tension leg platform, with a comparison to other floating turbine concepts. NREL/SR-500-45891, 2009.

49.

Jonkman JM and Buhl ML Jr. FAST user’s guide, NREL/EL-500-38230, August 2005.

50.

http://www.statoil.com/en/TechnologyInnovation/NewEnergy/RenewablePowerProduction/Offshore/Hywind/Downloads/Hywind%20Fact%20sheet.pdf (accessed October 2013).

51.

Polinder H, Bang D, Van Rooij RPJOM, et al. 10 MW wind turbine direct-drive generator design with pitch or active speed stall control. In: IEEE international electric machines & drives conference, IEMDC ‘07, Antalya, 3–5 May 2007.

52.

Johnson K, Fingersh L, Balas M, et al. Methods for increasing region 2 power capture on a variable speed HAWT. In: Proceedings of the 23rd ASME wind energy symposium, Reno, 2004.

53.

Wright AD and Fingersh L. Advanced control design for wind turbines. Part I: Control design, implementation, and initial tests. NREL/TP-500-42437, March 2008.

54.

Larsen TJ and Hanson TD. A method to avoid negative damped low frequent tower vibrations for a floating, pitch controlled wind turbine. J Phys: Conf Ser 2007. DOI:10.1088/1742-6596/75/1/012073.

55.

Larsen TJ. A practical guide to tuning of a controller for a floating pitch regulated turbine. Risø National Laboratory, Technical University of Denmark, September 2007.

56.

Mann J. Models in micrometeorology. Technical Report, Riso National Laboratory. 1994.

57.

Faltinsen OM. Sea loads on ships and offshore structures. 1st ed. Cambridge: Cambridge University Press, 1990.

58.

Karimirad

Meissonnier

Gao

. Hydro-elastic code-to-code comparison for a tension leg spar-type floating wind turbine. Marine Struct 2011; 24: 412–435.

59.

IEC 61400-3: Design requirements for offshore wind turbines. 1st ed., 2009.

60.

Faltinsen

. Sea loads on ships and offshore structures, 1st ed. Cambridge: Cambridge University Press, 1990.

61.

Recommended Practice DNV-RP-C205. Environmental conditions and environmental loads, October 2010.

62.

Sethuraman L, Xing Y, Gao Z, et al. A multi-body model of a direct drive generator for a wind turbine. In: The proceedings of EWEA 2014, Barcelona, 10–13 March 2014.

63.

Whittle M, Trevelyan J and Wu J. A parametric study of the effect of generator misalignment on bearing fatigue life in wind turbines. In: The proceedings of EWEA 2011, Brussels, 14–17 March 2011.