On the development of a new flexible drill for orthopedic surgery and the forces experienced on drilling bovine bone

Abstract

This article presents the construction of a flexible drill which is designed to cut a curved canal in the bone or remove bone materials, to improve the outcome of orthopedic surgery and to facilitate minimally invasive. This article reports the design of the flexible drill and uses it in an experimental rig to evaluate the drilling force generated when cutting bovine bone. The experiments facilitate the measurement of action forces between the mill bits when moving the tip toward or across a bone sample in various configurations caused by bending the flexible drill sheath to enable cutting of a curved path of variable radius in the bone. The reaction force represents the force trying to deflect the mill bit tip away from the bone sample surface and must be resisted in order to continue cutting without deflection or buckling of the tip during the drilling of curved pathways. The experiment shows the flexible drill can cut bones in both configurations and experienced a maximal force of 3.4N in the vertical configuration and 0.54N in lateral configuration. The experimental results show that the flexible drill designed is able to produce sufficient force at variable bending angles to perform the required tasks for bone cutting.

Keywords

Flexible drill force evaluation orthopedic surgery

Get full access to this article

View all access options for this article.

References

Wagner

Revision prosthesis for the hip joint in severe bone loss. Orthopade 1987; 16: 295–300.

Watanabe

Kanou

Kobayashi

et al . Development of a “Steerable Drill” for ACL reconstruction to create the arbitrary trajectory of a bone tunnel. In: Proceedings of the international conference on intelligent robots and systems, San Francisco, CA, 25–30 September 2011, pp.955–960. New York: IEEE.

Dario

Carrozza

Marcacci

et al . A novel mechatronic tool for computer-assisted arthroscopy. IEEE T Inf Technol B 2000; 4: 15–29.

Yao

Elangovana

Nicolaides

Design of a flexible fetoscopy manipulation system for congenital diaphragmatic hernia. Med Eng Phys 2014; 36: 32.

Reddy

Neuzil

Malchano

et al . View-synchronized robotic image-guided therapy for atrial fibrillation ablation: experimental validation and clinical feasibility. Circulation 2007; 115: 2705–2714.

Wigins

Malkin

Orthogonal machining of bone. J Biomech Eng: T ASME 1978; 100: 122–130.

Krause

Orthogonal bone cutting: saw design and operating characteristics. J Biomech Eng 1987; 109: 263–271.

Yeager

Nazari

Arola

Machining of cortical bone: surface texture, surface integrity and cutting forces. Mach Sci Technol 2008; 12: 100.

Dillon

Kratchman

Dietrich

et al . An experimental evaluation of the force requirements for robotic mastoidectomy. Otol Neurotol 2013; 34: e93–e102.

10.

Alam

Mitrofanova

Silberschmidta

VV.

Experimental investigations of forces and torque in conventional and ultrasonically-assisted drilling of cortical bone. Med Eng Phys 2011; 33: 234–239.

11.

Arda

Burak

Modeling and experimentation of bone drilling forces. J Biomech 2012; 45: 1076–1083.

12.

Moghaddam

Nahvi

Arbabtafti

et al . A physically realistic voxel-based method for haptic simulation of bone machining. In: Ferre

(ed.) Haptics: perception, devices and scenarios. Berlin: Springer, 2008, pp.651–660.