Determination of three-dimensional joint loading within the lower extremities in snowboarding

Abstract

In the biomechanical literature only a few studies are available focusing on the determination of joint loading within the lower extremities in snowboarding. These studies are limited to analysis in a restricted capture volume due to the use of optical video-based systems. To overcome this restriction the aim of the present study was to develop a method to determine net joint moments within the lower extremities in snowboarding for complete measurement runs. An experienced snowboarder performed several runs equipped with two custom-made force plates as well as a full-body inertial measurement system. A rigid, multi-segment model was developed to describe the motion and loads within the lower extremities. This model is based on an existing lower-body model and designed to be run by the OpenSim software package. Measured kinetic and kinematic data were imported into the OpenSim program and inverse dynamic calculations were performed. The results illustrate the potential of the developed method for the determination of joint loadings within the lower extremities for complete measurement runs in a real snowboarding environment. The calculated net joint moments of force are reasonable in comparison to the data presented in the literature. A good reliability of the method seems to be indicated by the low data variation between different turns. Due to the unknown accuracy of this method the application for inter-individual studies as well as studies of injury mechanisms may be limited. For intra-individual studies comparing different snowboarding techniques as well as different snowboard equipment the method seems to be beneficial. The validity of the method needs to be studied further.

Keywords

Snowboarding inverse dynamics joint loading inertial measurement ground reaction forces

Get full access to this article

View all access options for this article.

References

Bladin

Giddings

Robinson

. Australian snowboard injury data base study-a four year prospective study. Am J Sports Med 1993; 21(5): 701–704.

Davidson

Laliotis

. Snowboarding injuries: a four-year study with comparison with alpine ski injuries. West J Med 1996; 164(3): 231–237.

Made

Elmqvist

. A 10-year study of snowboard injuries in Lapland Sweden. Scand J Med Sci Sports 2004; 14(2): 128–133.

Sutherland

Holmes

Myers

. Differing injury patterns in snowboarding and alpine skiing. Injury 1996; 27(6): 423–425.

Kirkpatrick

Hunter

Janes

. The snowboarder’s foot and ankle. Am J Sports Med 1998; 26(2): 271–277.

Pino

Colville

. Snowboard injuries. Am J Sports Med 1989; 17(6): 778–781.

Krüger

Edelmann-Nusser

Krinowsky

. Safety binding for a snowboard. Patent pending, WO 2010043206, 2010.

Krüger

Wolfsperger

Edelmann-Nusser

. Design and evaluation of a safety snowboard binding. In: XVIII International Society for Skiing Safety Congress, University of Munich, Garmisch-Partenkirchen, Germany, 26 April–2 May 2009, p. 46. Munich: Technical University of Munich, Department of Sport Equipment and Materials.

Herzog

Read

. Anterior cruciate ligament forces in alpine skiing. J Appl Biomech 1993; 9: 260–278.

10.

Klous

. Three-dimensional joint loading on the lower extremities in alpine skiing and snowboarding. PhD Thesis, University of Salzburg, Austria, 2007.

11.

Read

Herzog

. External loading at the knee joint for landing movements in alpine skiing. Int J Sports Biomech 1992; 8: 62–80.

12.

Van den Bogert

Read

Nigg

. An analysis of hip joint loading during walking, running and skiing. Med Sci Sports Exerc 1999; 31(1): 131–142.

13.

McAlpine

. Biomechanical analysis of snowboard jump landings – a focus on the ankle joint complex. PhD Thesis, The University of Auckland, New Zealand, 2010.

14.

Stricker

Scheiber

Lindenhofer

. Determination of forces in alpine skiing and snowboarding: validation of a mobile data acquisition system. Eur J Sport Sci 2010; 10(1): 31–41.

15.

Brodie

Walmsley

Page

. Fusion motion capture: a prototype using inertial measurement units and GPS for the biomechanical analysis of ski racing. Sports Technol 2008; 1(1): 17–28.

16.

Krüger

Edelmann-Nusser

. Application of a full body inertial measurement system in alpine skiing – a comparison to an optical camera based system. J Appl Biomech 2010; 26(4): 516–521.

17.

Supej

. 3D measurements of alpine skiing with an inertial sensor motion capture suit and GNSS RTK system. J Sports Sci 2010; 28(7): 759–769.

18.

Krüger

Edelmann-Nusser

. Biomechanical analysis in freestyle snowboarding: application of a full-body inertial measurement system and a bilateral insole measurement system. Sports Technol 2009; 2(1–2): 17–23.

19.

Klous

Müller

Schwameder

. Collecting kinematic data on a ski/snowboard track with panning, tilting, and zooming cameras: is there sufficient accuracy for a biomechanical analysis? J Sports Sci 2010; 28(12): 1345–1353.

20.

Delp

Loan

Hoy

. 3D Gait Model 2354, available with the OpenSim software, https://simtk.org/home/opensim (Accessed 17 October 2011).

21.

Anderson

Pandy

. A dynamic optimization solution for vertical jumping in three dimensions. Comput Meth Biomech Biomed Eng 1999; 2: 201–231.

22.

Anderson

Pandy

. Dynamic optimization of human walking. J Biomech Eng 2001; 123: 381–390.

23.

Delp

Loan

Hoy

. An interactive graphics based model of the lower extremity to study orthopaedic surgical procedures. IEEE Trans. Biomed Eng 1990; 37(8): 757–767.

24.

Yamaguchi

Zajac

. A planar model of the knee joint to characterize the knee extensor mechanism. J Biomech 1989; 21: 1–10.

25.

Isman

Inman

. Anthropometric studies of the human foot and ankle. Bull Prosthes Res 1969; 10–11: 97–129.

26.

Wright

. A simulation study of the contribution of several factors to ankle sprain susceptibility. PhD Thesis, University of Calgary, Canada, 1999.

27.

O’Connor

. Bone position estimation from skin marker co-ordinates using global optimisation with joint constraints. J Biomech 1999; 32: 129–134.

28.

Kuo

. A least squares estimation approach to improving the precision of inverse dynamics computations. J Biomech Eng 1998; 120: 148–159.

29.

Brodie

Walmsley

Page

. Dynamic accuracy of inertial measurement units during simple pendulum motion. Comput Meth Biomech Biomed Eng 2008; 11(3): 235–242.

30.

Cloete

Scheffer

. Benchmarking of a full-body inertial motion capture system for clinical gait analysis. In: 30th annual international conference of the IEEE Engineering in Medicine and Biology Society, Vancouver, Canada, 20–24 August 2008, Piscataway, NJ: IEEE Engineering in Medicine and Biology Society, pp. 4579–4582.

31.

McCaw

DeVita

. Errors in alignment of centre of pressure and foot coordinates affect predicted lower extremity torques. J Biomech 1995; 28(8): 985–988.