Application of a diagnostic technique for evaluating the quality of the air–fuel mixture and the ignition quality of a spark-ignition reciprocating aircraft piston engine

Abstract

The performance characteristics of an aircraft piston engine are affected mainly by the air–fuel mixture quality (i.e. condition of the fuel injection system) and by the spark timing and spark duration (i.e. condition of ignition system). Thus, the present work focuses on investigating the effect of both fuel injection and spark ignition systems on performance characteristics of two aircraft piston engines which are of the same type but have overhauled by two different workshops. The investigation is conducted by applying an existing diagnostic technique, which is based on the simultaneous recording and processing of two electric signals: one corresponding to cylinder pressure and the second corresponding to the ignition system. The basic characteristics of the proposed methodology are simplicity and field applicability on engines of this type. A detailed experimental investigation has been conducted on the aforementioned two aircraft piston engines on a dedicated test bench. From the results, it is revealed that the proposed diagnostic methodology provides reliable information for the effect of both the ignition and fuel injection systems on engine performance characteristics. The results derived from the specific work enable the comparative evaluation of the engines and their ignition and fuel injection systems. Finally, based on this first investigation, the proposed methodology seems to be promising, because it can be easily applied on any type of spark-ignited engine and especially on aircraft piston engine, where due to its geometry and multicylinder nature, the application of lab techniques on the field is, if not impossible, extremely difficult.

Keywords

Piston engine condition monitoring diagnosis

Get full access to this article

View all access options for this article.

References

Jones

Y-H

. A review of condition monitoring and fault diagnosis for diesel engines. Int J Tribotest 2000; 6.

Antory

Kruger

Irwin

et al.

Fault diagnosis in internal combustion engines using non-linear multivariate statistics. Proc. IMechE, Part I: J Systems and Control Engineering 2005; 219: 243–258.

Twiddle

Jones

. A high-level technique for diesel engine combustion system condition monitoring and fault diagnosis. Proc IMechE, Part I: J Systems and Control Engineering 2002; 216: 125–134.

Collacot

. Mechanical fault diagnosis and condition monitoring, London: Chapman and Hall, 1997.

Chen

Taniguchi

Toyota

et al.

Fault diagnosis method for machinery in unsteady operating condition by instantaneous power spectrum and genetic programming. Mech Syst Signal Process 2005; 19: 175–194.

Shiyuan

Fengshou

Ball

. Detection of engine valve faults by vibration signals measured on the cylinder head. Proc IMechE, Part D: J Automobile Engineering 2006; 220: 379–386.

Kouremenos

Hountalas

Kotsiopoulos

. Development of a thermodynamic method for diagnosis and tuning of diesel engines and its application on marine engines. Proc IMechE, Part A: J Power and Energy 1995; 209.

Kouremenos

Hountalas

. Diagnosis and condition monitoring of medium speed marine diesel engines. Int J Tribotest 1997; 4.

Hountalas

Kouremenos

. Development and application of a fully automatic trouble-shooting method for large scale marine diesel engines. Appl Therm Eng 1999; 19.

10.

Hountalas

. Prediction of marine diesel engine performance under fault conditions. Appl Therm Eng 2000; 20.

11.

Hountalas

Kouremenos

Sideris

. A diagnostic method for heavy-duty diesel engines used in stationary applications. J Eng Gas Turbines Power 2004; 126.

12.

Lamaris VT and Hountalas DT. Possibility to determine diesel engine condition and tuning from the application of a diagnostic technique at a single operating point. In: SAE 2009 world congress, Detroit MI, USA, paper no. SAE2009-01-0681.

13.

Lamaris

Hountalas

. Validation of a diagnostic method for estimating the compression condition of digital injection diesel engines via detailed laboratory measurements. Proc IMechE, Part A: J Power and Energy 2009; 224.

14.

Lamaris

Hountalas

. A general purpose diagnostic technique for marine diesel engines – Application on the main propulsion and auxiliary diesel units of a marine vessel. Energy Convers Manage 2010; 51: 740–753.

15.

Papagiannakis RG, Antonopoulos AK, Nikita C, et al. Use of a diagnostic methodology for spark ignited engines to investigate the effect of AFR on the performance and combustion characteristics of a reciprocating aircraft engine. In: ASME 2012 internal combustion engine division spring technical conference, Torino, Piemonte, Italy, 6–9 May 2012, paper no ICES2012-81105.

16.

Rakopoulos CD, Larintzakis M and Hountalas DT. Modelling the cycle of Otto engines for pressure, carbon monoxide and nitrogen oxides prediction and comparison with experimental results. In: International AMSE-France conference on “Modelling and Simulation”, Tunisia, 25–28 November 1985, Vol. 3B, pp.59–69.

17.

Rakopoulos CD and Hountalas DT. A two-zone simulation model of the combustion process in Otto engines. In: International AMSE-France conference on “Modelling and Simulation”, Naples, Italy, 29 September to 1 October 1986, Vol. 3.3, pp.219–228.

18.

Kouremenos

Rakopoulos

Hountalas

. Thermodynamic analysis of indirect injection diesel engines by two-zone modeling of combustion. J Eng Gas Turbines Power 1990; 112: 138–149.

19.

Rakopoulos

. Evaluation of a spark ignition engine cycle using first and second law analysis techniques. Energy Convers Manage 1993; 33: 1299–1314.

20.

Rakopoulos CD and Hountalas DT. Analysis of Otto engine combustion by processing of the measured cylinder pressure diagram. In: 1st meeting of the combustion institute, Athens, 28–29 November 1997, pp.293–298.

21.

Hountalas DT and Kouremenos AD. Evaluation of a thermodynamic method for the determination of the TDC position in reciprocating internal combustion engines. In: ECOS’95 ASME international conference, Istanbul, Turkey, 1995, paper no. C4-60.

22.

Stas MJ. Thermodynamic determination of TDC in piston combustion engines. In: SAE world congress, Detroit, MI, USA, 1996, paper no. 960610.

23.

Lloyd G. Type Approval Certificate for product “testo 365 EMDS” emission measurement and diagnosis system. Certificate no. 37 974-12HH, Hamburg, 2012.

24.

Benson

Whitehouse

. Internal combustion engines, Oxford: Pergamon, 1979.

25.

Heywood

. Internal combustion engine fundamentals, New York: McGraw-Hill, 1988.

26.

Kouremenos DA, Rakopoulos CD, Kotsos KG, et al. Modeling the blow-by rate in a reciprocating internal combustion engine. In: Proceedings of the 16th IASTED IMS international conference, Paris, 1984, pp.465–486..

27.

Assanis

Heywood

. Development and use of a computer simulation of the turbo-compounded diesel system for engine performance and component heat transfer studies. Trans SAE J Engines 1986; 95.

28.

Hountalas DT. The effect of operating parameters on the net and gross heat release rates of a direct injection diesel engine. In: Proceedings of 2nd biennial ASME-ESDA international conference on “Design of Energy Systems”, London, 1994, pp.27–34.