Design point analysis of the turbofan-driven turboelectric distributed propulsion system with boundary layer ingestion

Abstract

The performance benefits of boundary layer ingestion in the case of air vehicles powered by distributed propulsors have been documented and explored extensively by previous study. However, the increased inlet flow distortion and the system total weight would dramatically reduce the expected benefits. In this paper, a novel turboelectric distributed propulsion module on the N3-X airframe has been developed. It includes two direct-shaft-driven turbofans (each drives a free power turbine) and a propulsors array, and therefore both the direct-shaft-driven turbofan and the propulsors unit produce thrust. Secondly, a parametric and quasi two-dimensional study at component and at system level is carried out so that the effects of these two aerodynamic issues over the system performance can be assessed. The figure of merit in this study is the thrust-specific fuel consumption and the system parameters examined are: the thrust split between propulsors and engines, the capture height and the direct-shaft-driven turbofan parameters. Preliminary results found optimum configurations at around 60–90% thrust split ratio, when installation effects were neglected. The final value depends on the propulsor intake pressure loss and the bypass ratio of the propulsion system.

Keywords

Distributed propulsion TeDP BLI N3-X

Get full access to this article

View all access options for this article.

References

Del Rosario R, Follen G, Wahls R, et al. subsonic fixed wing project overview and technical challenges for energy efficient environmentally compatible subsonic transport aircraft. In: 50th AIAA aerospace science meeting. Nashville, TN, 9–12 January 2012.

Kim HD, Berton JJ and Jones SM. Low noise cruise efficient short take-off and landing transport vehicle study. In: 6th AIAA Aviation Technology, Integration and Operations Conference (ATIO), Wichita, Kansas, 25–27 September 2006. NASA Center for AeroSpace Information.

Hileman JI, Spakovszky ZS, Drela M, et al. Airframe design for silent aircraft. In: 45th AIAA Aerospace Sciences Meeting and Exhibit, Reno, Nevada, 8–11 January 2007.

de la Rosa Blanca E, Hall CA and Crichton D. Challenges in the silent aircraft engine design. In: 45th AIAA Aerospace Sciences Meeting and Exhibit, Reno, Nevada, 8–11 January 2007.

Kawai R, Brown D, Roman D, et al. (Oct. 2008), Acoustic prediction methodology and test validation for an efficient low-noise hybrid wing body subsonic transport. NASA Contract NNL07AA54C, Phase 1 Final Report PWDM08-006A.

Felder JL, Kim HD and Brown GV. Turboelectric distributed propulsion engine cycle analysis for hybridwing-body aircraft. In: 47th AIAA Aerospace Sciences Meeting Including: The New Horizons Forum and Aerospace Exposition, Orlando, Florida, 5–8 January 2009.

Plas AP, Sargeant MA, Madani V, et al.(2007). Performance of a boundary layer ingesting (BLI) propulsion system. In: AIAA 2007-450, Reno, Nevada, 8–11 January 2007.

Brown GV. Weights and efficiencies of electric components of a turboelectric aircraft propulsion system. In: 49th AIAA Aerospace Sciences Meeting including: The New Horizons Forum and Aerospace Exposition, Orlando, Florida, 4–7 January 2011.

Liu

Ihiabe

Laskaridis

. A preliminary method to estimate impacts of inlet flow distortion on boundary layer ingesting propulsion system design point performance[J]. Proc IMechE, Part G: J Aerospace Engineering 2014; 228: 1528–1539.

10.

Mantič-Lugo

Doulgeris

Gohardani

. Computational analysis of the aerodynamic performance of a jet-flap airfoil in transonic flow. Proc IMechE, Part G: J Aerospace Engineering 2012; 226: 664–678.

11.

Felder JL, Kim HD and Brown GV. An examination of the effect of boundary layer ingestion on turboelectric distributed propulsion systems. In: 49th AIAA Aerospace Sciences Meeting including the New Horizons Forum and Aerospace Exposition, Orlando, Florida, 4–7 January 2011.

12.

Walsh PP and Fletcher P. Gas turbine performance. John Wiley & Sons, 2004.

13.

Smith LH. Wake ingestion propulsion benefit. Journal of Propulsion and Power 1993; 9(1): 74–82.

14.

Longley JP and Greitzer EM. Steady and Transient Performance Prediction of Gas Turbine Engines. In: AGARD-LS-183, Advisory Group for Aerospace Research and Development, Chatillon/ Bagneux, France, 11–12 June 1992.

15.

Liu

Doulgeris

Laskaridis

. Thermal cycle analysis of turboelectric distributed propulsion system with boundary layer ingestion. Aerosp Sci Technol 2013; 27: 163–170.

16.

Flouriot L. A CFD simulation of an inlet S-duct used with distributed propulsion and boundary layer ingestion. Cranfield MSc thesis. School of Engineering, Cranfield University, Bedfordshire, UK, 2012.