An investigation of the combustion process and emissions of CI engines powered by Simarouba glauca oil,hydrogen and acetylene induction,and hydrotreated Simarouba oil (green diesel)
Restricted accessResearch articleFirst published online 2024
An investigation of the combustion process and emissions of CI engines powered by Simarouba glauca oil,hydrogen and acetylene induction,and hydrotreated Simarouba oil (green diesel)
The current test was carried out on a single-cylinder engine that was water-cooled, naturally aspirated, direct injection with injector pump on the head, compression ignition (CI), and operating at a speed of 1500 r/min under varying loads. While diesel, Simarouba glauca oil (SO) and hydrotreated fuel (HTSO) were immediately fed into the cylinder as the primary fuel whereas acetylene and hydrogen were pumped into the intake port as a secondary gaseous fuel at a flow rate of 200 g/h and 30 l/min respectively with S. glauca as primary fuel. Experiments were carried out with loads of 25%, 50%, 75%, and 100% for various fuels. The results were analysed and compared in terms of the parameters of the combustion process. An increased brake thermal efficiency (BTE) was observed for HTSO fuel around 2.08% compared with diesel. When compared to conventional diesel combustion, the NO emission is increased for HTSO fuel but drastically decreased for SO + C2H2 fuel of around 19.79% compared to diesel and other emissions like CO, HC and smoke emission are decreased for HTSO fuel of around 22%, 4.16%, and 7.69% respectively compared to diesel.
ShrigiriBMHebbalODReddyKH. Performance, emission and combustion characteristics of a semi-adiabatic diesel engine using cotton seed and neem kernel oil methyl esters. Alexandria Eng J2016; 55: 699–706.
2.
FernandesDMSerqueiraDSPortelaFM, et al.Preparation and characterization of methylic and ethylic biodiesel from cottonseed oil and effect of tert-butylhydroquinone on its oxidative stability. Fuel2012; 97: 658–661.
3.
DatlaRPuliRKVelayudhan ParvathyC, et al.Effect of start of main injection timing on performance, emission, and combustion characteristics of a VGT CI engine fueled with neem biodiesel. Environ Sci Pollut Res2021; 28: 11942–11953.
4.
RakopoulosDC. Combustion and emissions of cottonseed oil and its bio-diesel in blends with either n-butanol or diethyl ether in HSDI diesel engine. Fuel2013; 105: 603–613.
5.
RakopoulosDCRakopoulosCDGiakoumisEG, et al.Comparative environmental behavior of bus engine operating on blends of diesel fuel with four straight vegetable oils of Greek origin: sunflower, cottonseed, corn and olive. Fuel2011; 90: 3439–3446.
6.
PradhanPRahemanHPadheeD. Combustion and performance of a diesel engine with preheated Jatropha curcas oil using waste heat from exhaust gas. Fuel2014; 115: 527–533.
7.
NabiMNHoqueSNAkhterMS. Karanja (Pongamia pinnata) biodiesel production in Bangladesh, characterization of karanja biodiesel and its effect on diesel emissions. Fuel Process Technol2009; 90: 1080–1086.
8.
SinhaDMurugavelhS. Biodiesel production from waste cotton seed oil using low cost catalyst: engine performance and emission characteristics. Perspect Sci2016; 8: 237–240.
9.
SahooPKDasLM. Process optimization for biodiesel production from Jatropha, Karanja and Polanga oils. Fuel2009; 88: 1588–1594.
10.
DevanPKMahalakshmiNV. Performance, emission and combustion characteristics of poon oil and its diesel blends in a DI diesel engine. Fuel2009; 88: 861–867.
11.
BajpaiSSahooPKDasLM. Feasibility of blending karanja vegetable oil in petro-diesel and utilization in a direct injection diesel engine. Fuel2009; 88: 705–711.
12.
Venkata SubbaiahGRaja GopalK. An experimental investigation on the performance and emission characteristics of a diesel engine fuelled with rice bran biodiesel and ethanol blends. Int J Green Energy2011; 8: 197–208.
13.
ZhangGDLiuHXiaXX, et al.Effects of dimethyl carbonate fuel additive on diesel engine performances. Proc IMechE, Part D: J Automobile Engineering2005; 219: 897–903.
14.
SahooPKDasLM. Combustion analysis of Jatropha, Karanja and Polanga based biodiesel as fuel in a diesel engine. Fuel2009; 88: 994–999.
15.
AgarwalAK. Biofuels (alcohols and biodiesel) applications as fuels for internal combustion engines. Prog Energy Combust Sci2007; 33: 233–271.
16.
KarabektasMHosozM. Performance and emission characteristics of a diesel engine using isobutanol–diesel fuel blends. Renewable Energy2009; 34: 1554–1559.
17.
YilmazNVigilFMBenalilK, et al.Effect of biodiesel–butanol fuel blends on emissions and performance characteristics of a diesel engine. Fuel2014; 135: 46–50.
18.
AjavEASinghBBhattacharyaTK. Experimental study of some performance parameters of a constant speed stationary diesel engine using ethanol–diesel blends as fuel. Biomass Bioenergy1999; 17: 357–365.
19.
HeBQShuaiSJWangJX, et al.The effect of ethanol blended diesel fuels on emissions from a diesel engine. Atmos Environ2003; 37: 4965–4971.
20.
AkarMAKekilliEBasO, et al.Hydrogen enriched waste oil biodiesel usage in compression ignition engine. Int J Hydrogen Energy2018; 43: 18046–18052.
21.
BosePKMajiD. An experimental investigation on engine performance and emissions of a single cylinder diesel engine using hydrogen as inducted fuel and diesel as injected fuel with exhaust gas recirculation. Int J Hydrogen Energy2009; 34: 4847–4854.
22.
AkcayMYilmazITFeyziogluA. Effect of hydrogen addition on performance and emission characteristics of a common-rail CI engine fueled with diesel/waste cooking oil biodiesel blends. Energy2020; 212: 118538.
23.
OzcanliMAkarMACalikA, et al.Using HHO (hydroxy) and hydrogen enriched castor oil biodiesel in compression ignition engine. Int J Hydrogen Energy2017; 42: 23366–23372.
24.
SerinHYıldızhanŞ. Hydrogen addition to tea seed oil biodiesel: performance and emission characteristics. Int J Hydrogen Energy2018; 43: 18020–18027.
25.
CoronadoCRTunaCEZanziR, et al.Development of a thermoeconomic methodology for the optimization of biodiesel production—part I: biodiesel plant and thermoeconomic functional diagram. Renewable Sustainable Energy Rev2013; 23: 138–146.
26.
VijayaragavanMLalgudi RamachandranGS. Effect of synergistic interaction between hydrogen inductions with Simarouba glauca-diesel blend for CI engine application. Heat Mass Transfer2020; 56: 1739–1752.
27.
OzcanliMAkarMACalikA, et al.Using HHO (hydroxy) and hydrogen enriched castor oil biodiesel in compression ignition engine. Int J Hydrogen Energy2017; 42: 23366–23372.
28.
AldhaidhawiMChiriacRBădescuV, et al.Investigation on the mixture formation, combustion characteristics and performance of a diesel engine fueled with diesel, biodiesel B20 and hydrogen addition. Int J Hydrogen Energy2017; 42: 16793–16807.
29.
JavedSMurthyYSSatyanarayanaMRS, et al.Effect of a zinc oxide nanoparticle fuel additive on the emission reduction of a hydrogen dual-fuelled engine with Jatropha methyl ester biodiesel blends. J Cleaner Prod2016; 137: 490–506.
30.
RajkumarSThangarajaJ. Effect of biodiesel, biodiesel binary blends, hydrogenated biodiesel and injection parameters on NOx and soot emissions in a turbocharged diesel engine. Fuel2019; 240: 101–118.
31.
GurusamyMPonnusamyC. Experimental evaluation of cottonseed oil-camphor binary blends on diesel engine performance, combustion, exhaust and cyclic variance parameters. Biofuels2023; 14: 645–654.
32.
GurusamyMPonnusamyC. Assessment of engine characteristics of compression ignition engine fuelled with Polanga oil and camphor oil blend. Int J Environ Sci Technol2024; 21: 603–616.
33.
GurusamyMSubramaniyanM. Evaluation of CI engine characteristics using Jatropha-camphor oil blends with diethyl ether as an additive. Environ Prog Sustain Energy2024; 43: e14414.
34.
GurusamyMVijayaragavanMVaruvelEG. Experimental investigation of features of CI engine fueled with blends of camphor oil with biomass waste Simarouba glauca oil. Energy Sources Part A2024; 46: 3884–3901.
35.
HuangHLiZTengW, et al.Effects of EGR rates on combustion and emission characteristics in a diesel engine with n-butanol/PODE3-4/diesel blends. Appl Therm Eng2019; 146: 212–222.
36.
ThoddaGKathapillaiAMadhavanVR, et al.Experimental analysis on the influence of compression ratio, flow rate, injection pressure, and injection timing on the acetylene — diesel aspirated dual fuel engine. Environ Sci Pollut Res2023; 30: 61217–61233.
37.
samir NajeAYuvarajanDabed Al-RidahZ, et al.Ignition study of neat biodiesel in dual fueled research engine. Fuel2020; 281: 118673.
38.
MuthuswamySVeerasigamaniM. Comparative experimental analysis on dual fuel with biodiesel-acetylene in reactivity controlled compression ignition engine. Int J Ambient Energy2022; 43: 6317–6328.
39.
BashaSKRaoNNShaikM, et al.Performance analysis and control of NOx emissions in diesel engine using on-board acetylene gas from calcium carbide. Mater Today Proc2020; 33: 4887–4892.
40.
DongYXuBLiaoT, et al.Application of local-feature-based 3D point cloud stitching method of low-overlap point cloud to aero-engine blade measurement. IEEE Trans Instrum Meas2023; 72: 1008913.
41.
SuFQHeXLDaiMJ, et al.Estimation of the cavity volume in the gasification zone for underground coal gasification under different oxygen flow conditions. Energy2023; 285: 129309.
42.
LiuLMeiQJiaW. A flexible diesel spray model for advanced injection strategy. Fuel2022; 314: 122784.
43.
LiuLWuJLiuH, et al.Investigation of combustion and emissions characteristics in a low-speed marine engine using ammonia under thermal and reactive atmospheres. Int J Hydrogen Energy2024; 63: 1237–1247.
44.
MeiQLiuLYangW, et al.Combustion model development of future DI engines for carbon emission reduction. Energy Convers Manage2024; 311: 118528.
45.
HouYChengMShengZ, et al.Unsteady conjugate heat transfer simulation of wall heat loads for rotating detonation combustor. Int J Heat Mass Transfer2024; 221: 125081.
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
