Abstract
A study on the working characteristics of a variable speed DC compressor for variable solar irradiance has been carried out. Two compressors (total cooling capacity of 300 W) were directly connected to the solar photovoltaic (PV) panel, with both having the ability to start when solar irradiance reached 700 W/m2. When individually connected, the minimum solar irradiance required for a single compressor to start and run were 400 W/m2 and 200 W/m2. However, when two compressors in the loop were at rest, and when the solar irradiance was just above 400 W/m2, it was not sufficient to start both compressors. As a result, single compressor only began to run and another one took more time to start. Thus, a load management circuit is necessary for starting and sustaining the load for two compressors. A starting circuit is essential for the supply of the required starting current so that the single compressor and double compressors can start with the minimum irradiance of 200 W/m2 and 400 W/m2 respectively. Lab test (LTs) were performed using a regulated DC power supply (RPS) for the same test conditions as the field tests (FTs). The PV output was predicted using the PVsyst software and fed into the RPS. The results reveal the discrepancies in the behavioral characteristics of the DC compressors between FT and LT conditions.
Keywords
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
