Computational study to predict the thermal performance and optimal design parameters of a T-shaped fin subjected to natural convection

Abstract

The present paper aims to predict the optimal design parameters of a T-shaped fin subjected to natural convection using constructal theory. Both analytical and computational investigations are performed to determine its thermal performance for a wide range of thermo-physical and geometric parameters. Power law type temperature-dependent heat transfer coefficient is assumed for natural convection. For analytical solution Adomian decomposition method is adopted to evaluate the temperature distribution in both the stem and flange part of the fin. A numerical scheme called finite difference method is implemented to validate the analytical results. The temperature distribution obtained from the computational analysis using ANSYS FLUENT 14.0 is lower than that obtained from the analytical calculations. Moreover, the actual heat transfer rate is also compared between the two methods which reveal that the computational analysis gives higher value as compared to the analytical results. Further, optimization study has also been carried out in a generalized way so that either the fin volume or the heat transfer rate can be taken as a constraint. It is found that with the increase in length ratio, the optimum effectiveness is obtained at a higher value of aspect ratio whereas the optimum efficiency is obtained at a lower value of it. Though, a decrease in thickness ratio predicts a higher value of actual dimensionless heat transfer rate.

Keywords

Thermal performance optimization ADM convection numerical study

Get full access to this article

View all access options for this article.

References

Gardner

. Efficiency of extended surfaces. Trans ASME 1945; 67: 621–631.

Torabi

Aziz

Zhang

. A comparative study of longitudinal fins of rectangular, trapezoidal and concave parabolic profiles with multiple nonlinearities. Energy 2013; 51: 243–256.

Mokheimer

EMA

. Performance of annular fins with different profiles subject to variable heat transfer coefficient. Int J Heat Mass Transf 2002; 45: 3631–3642.

Ganji

Dogonchi

. Analytical investigation of convective heat transfer of a longitudinal fin with temperature-dependent thermal conductivity, heat transfer coefficient and heat generation. Int J Phys Sci 2014; 9: 466–474. B.

Kundu

Bhanja

. An analytical prediction for performance and optimum design analysis of porous fins. Int J Refrig 2011; 34: 337–352.

Khani

Aziz

. Thermal analysis of a longitudinal trapezoidal fin with temperature-dependent thermal conductivity and heat transfer coefficient. Commun Nonlinear Sci 2010; 15: 590–601.

Bhanja

Kundu

Aziz

. Enhancement of heat transfer from a continuously moving porous fin exposed in convective-radiative environment. Energy Convers Manage 2014; 88: 842–853.

Threlkeld

. Thermal environment engineering. New York: Prentice-Hall, 1970.

Bejan

. Constructal-theory network of conducting paths for cooling a heat generating volume. Int J Heat Mass Transf 1997; 40: 799–816.

10.

Bejan

Almogbel

. Constructal T-shaped fins. Int J Heat Mass Transf 2000; 43: 2101–2115.

11.

Lorenzini

Rocha

LAO

. Constructal design of Y-shaped assembly of fins. Int J Heat Mass Transf 2006; 49: 4552–4557.

12.

Lorenzini

Rocha

LAO

. Geometric optimization of T-Y-shaped cavity according to constructal design. Int J Heat Mass Transf 2009; 52: 4683–4688.

13.

Almogbel

. Constructal tree-shaped fins. Int J Therm Sci 2005; 44: 342–348.

14.

Kundu

Bhanja

. Performance and optimization analysis of a constructal T-shaped fin subject to variable thermal conductivity and convective heat transfer coefficient. Int J Heat Mass Transf 2010; 53: 254–267.

15.

Bhanja

Kundu

. Thermal analysis of constructal T-shaped porous fin with radiation effects. Int J Refrig 2011; 34: 1483–1496.

16.

Bhanja

Kundu

. Radiation effect on optimum design analysis of constructal T-shaped fin with variable thermal conductivity. Heat Mass Transf 2012; 48: 109–122.

17.

Torabi

Aziz

. Thermal performance and efficiency of convective–radiative T-shaped fins with temperature dependent thermal conductivity, heat transfer coefficient and surface emissivity. Int Commun Heat Mass Transf 2012; 39: 1018–1029.

18.

Hazarika

Bhanja

Nath

, et al. Analytical solution to predict performance and optimum design parameters of a constructal T-shaped fin with simultaneous heat and mass transfer. Energy 2015; 84: 303–316.

19.

Hazarika

Bhanja

Nath

, et al. Geometric optimization and performance study of a constructal T-shaped fin under simultaneous heat and mass transfer. Appl Therm Eng 2016; 109: 162–174.

20.

Hazarika

Deshamukhya

Bhanja

, et al. Thermal analysis of a constructal T- shaped porous fin with simultaneous heat and mass transfer. Chin J Chem Eng 2017; 25: 1121–1136.

21.

Hazarika

Bhanja

Nath

, et al. Accurate predictions for optimum design of a T-shaped fin under an actual wet load condition. Int J Refrig 2017; 82: 141–162.

22.

Das

. Forward and inverse solutions of a conductive, convective and radiative cylindrical porous fin. Energy Convers Manage 2014; 87: 96–106.

23.

Chen

Fang

. Simple computational method for conjugate conduction-natural convection along a vertical plate fin. Eng Anal Boundary Elem 1992; 10: 93–98.

24.

Dogan

Sivrioglu

. Experimental investigation of mixed convection heat transfer from longitudinal fins in a horizontal rectangular channel: in natural convection dominated flow regimes. Energy Convers Manage 2009; 50: 2513–2521.

25.

Dogan

Sivrioglu

Yılmaz

. Numerical analysis of natural convection and radiation heat transfer from various shaped thin fin-arrays placed on a horizontal plate-a conjugate analysis. Energy Convers Manage 2014; 77: 78–88.

26.

Lorenzini

Moretti

. Numerical analysis on heat removal from Y-shaped fins: efficiency and volume occupied for a new approach to performance optimization. Int J Therm Sci 2007; 46: 573–579.

27.

Elatar

Teamah

Hassab

. Numerical study of laminar natural convection inside square enclosure with single horizontal fin. Int J Therm Sci 2016; 99: 41–51.

28.

Shen

Sun

, et al. Natural convection heat transfer along vertical cylinder heat sinks with longitudinal fins. Int J Therm Sci 2016; 100: 457–464.

29.

Senapati

Dash

Roy

. Numerical investigation of natural convection heat transfer over annular finned horizontal cylinder. Int J Heat Mass Transf 2016; 96: 330–345.

30.

Huang

Wong

Lin

. Enhancement of natural convection heat transfer from horizontal rectangular fin arrays with perforations in fin base. Int J Therm Sci 2014; 84: 164–174.

31.

Razera

da Fonseca

RJC

Isoldi

, et al. Constructal design of a semi-elliptical fin inserted in a lid-driven square cavity with mixed convection. Int J Heat Mass Transf 2018; 126: 81–94.

32.

Razera

Quezada

Fagundes

, et al. Fluid flow and heat transfer maximization of elliptic cross-section tubes exposed to forced convection: a numerical approach motivated by Bejan’s theory. Int Commun Heat Mass Transf 2019; 109: 104366, pp.1–9.

33.

Laor

Kalman

. Performance and optimum dimensions of different cooling fins with a temperature dependent heat transfer coefficient. Int J Heat Mass Transf 1996; 39: 1993–2003.

34.

Holman

. Heat transfer (SI metric edn). New York: McGraw-Hill, 1989.