Abstract
The mixed-mode strength of bonded joints can be predicted by techniques such as cohesive zone models (CZM), which requires the estimation of the adhesive strength and fracture toughness (GC). Under the scope of fracture properties, the tensile and shear fracture toughness (GIC and GIIC, respectively) and the corresponding mixed-mode behaviour are particularly relevant. Moreover, these parameters highly depend on the adhesive thickness (tA), making it relevant to validate and propose CZM laws for bonded joint design. This work numerically addressed the tA influence on the mixed-mode fracture process of adhesive joints. For this purpose, single-leg bending (SLB) test experimental data was used, considering joints with composite adherends and a ductile adhesive, and tA from 0.1 to 2.0 mm. A numerical CZM analysis was performed, including the experimental and numerical load-displacement (P-δ) curves’ comparison for validation, followed by the CZM law estimation and fracture envelope validation, for all tA. The effect of the different CZM parameters on the results was finally evaluated. Overall, it was possible to numerically ascertain the tA effect on the fracture behaviour of adhesive joints and to propose a numerical technique for mixed-mode bonded joint analysis.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
