Heat transfer augmentation in a radial curved microchannel

Abstract

Rapid advancement toward miniaturization has emerged with confront for superior heat dissipation techniques. Of all the available cooling systems, microchannel-based cooling systems stand out to provide better cooling performance through superior heat removal abilities. In the present study, the cooling performance and hydraulic flow characteristics of a radial curved microchannel with three curvature ratios were numerically investigated and compared with a radial straight microchannel. Unlike the conventional straight microchannels, curved channels possess better fluid mixing as a result of the centrifugal force caused due to curvature. This phenomenon has a significant effect on heat transfer and fluid flow characteristics. Work on radial curved microchannels has been scarce and there is a lot of potential to augment the heat transfer with lower pumping power particularly with a central inlet. A three-dimensional conjugate heat transfer analysis was carried out for three radial curved microchannels and a radial straight microchannel using the ANSYS Fluent commercial software with the Reynolds number range of 125–275. The results showed a Nusselt number increment of 36.38% for radial curved microchannels when compared to the radial straight microchannel. Further, the lowest average wall temperature was noted for the radial curved microchannel with a curvature ratio of 0.17 which was 15.63 °C lower when compared to that in a radial straight microchannel for the same Reynolds number. Contours of velocity and temperature are presented at various locations along the stream to aid the results. The overall performance of all three radial curved microchannels was found to be higher than that of the radial straight microchannel in the Reynolds number range considered, out of which the maximum performance factor of 1.245 was obtained for the radial curved microchannel with a curvature ratio of 0.17 as compared to the radial straight microchannel.

Keywords

Circular heat sink radial curved microchannel radial straight microchannel single-phase liquid cooling heat transfer

Get full access to this article

View all access options for this article.

References

Tuckerman

Pease

RFW

. High-performance heat sinking for VLSI. IEEE Electron Device Lett 1981; EDL-2: 385–411.

Mudawar

. Experimental and numerical study of pressure drop and heat transfer in a single-phase micro-channel heat sink. Int J Heat Mass Transfer 2002; 45: 2549–2565.

Kandlikar

Grande

. Evaluation of single phase flow in microchannels for high heat flux chip cooling-thermohydraulic performance enhancement and fabrication technology. Heat Transfer Eng 2004; 25: 5–16.

Kandlikar

. History, advances, and challenges in liquid flow and flow boiling heat transfer in microchannels: a critical review. J Heat Transfer 2012; 134: 034001.

Lee

Garimella

Liu

. Investigation of heat transfer in rectangular microchannels. Int J Heat Mass Transfer 2005; 48: 1688–1704.

Qidwai

Hasan

. Effect of variation of cylindrical pin fins height on the overall performance of microchannel heat sink. Proc IMechE, Part E: J Process Mechanical Engineering 2019; 233: 980–990.

Wang

Chen

Gao

. Influence of geometric parameters on flow and heat transfer performance of micro-channel heat sinks. Appl Therm Eng 2016; 107: 870–879.

Zhu

, et al. Fluid flow and heat transfer characteristics of microchannel heat sinks with different groove shapes. Int J Therm Sci 2021; 161: 106721.

Zhu

, et al. Computational study of rib shape and configuration for heat transfer and fluid flow characteristics of microchannel heat sinks with fan-shaped cavities. Appl Therm Eng 2021; 195: 117171.

10.

Rostami

Abbassi

Saffar-Avval

. Optimization of conjugate heat transfer in wavy walls microchannels. Appl Therm Eng 2015; 82: 318–328.

11.

Ranjith Kumar

Balasubramanian

Kiran Kumar

, et al. Numerical investigation of fluid flow and heat transfer characteristics in novel circular wavy microchannel. Proc IMechE, Part E: J Process Mechanical Engineering 2019; 233: 954–966.

12.

Kumar

Balasubramanian

Kumar

, et al. Numerical investigation of heat transfer and fluid flow characteristics in circular wavy microchannel with tangentially branched secondary channels. Proc IMechE, Part E: J Process Mechanical Engineering 2019; 233: 1304–1316.

13.

Kumar

Balasubramanian

Kumar

. Numerical study on significance of wave amplitude, wavelength and aspect ratio on heat transfer and fluid flow characteristics in circular wavy MC heat sink design. Proc Inst Mech Eng Part C J Mech Eng Sci. Epub ahead of print 2021. DOI: 10.1177/0954406221989378.

14.

Bognár

, Horváth G, Kohári Z, et al. Thermal characterization of a radial micro-channel cooling plate. In: Annual IEEE Semiconductor Thermal Measurement and Management Symposium. San Jose, CA, USA, 2005, pp. 135–140.

15.

Ducrée

Haeberle

Brenner

, et al. Patterning of flow and mixing in rotating radial microchannels. Microfluid Nanofluidics 2006; 2: 97–105.

16.

Muwanga

Hassan

Ghorab

. Numerical investigation of a radial microchannel heat exchanger with varying cross-sectional channels. J Thermophys Heat Transfer 2008; 22: 321–332.

17.

Chu

Teng

Greif

. Experimental and numerical study on the flow characteristics in curved rectangular microchannels. Appl Therm Eng 2010; 30: 1558–1566.

18.

Recinella

Kalani

Kandlikar

. Enhanced flow boiling heat transfer using radial Microchannels. In: ASME 2016 14th international conference on nanochannels, microchannels, and minichannels, ICNMM 2016, collocated with the ASME 2016 heat transfer summer conference and the ASME 2016 fluids engineering division summer meeting, 2016, pp. 1–7.

19.

Recinella

Kandlikar

. Enhanced flow boiling using radial open microchannels With manifold and offset strip fins. J Heat Transfer 2018; 140: 1–9.

20.

Yang

, Schultz M, Parida P, et al. Local measurements of flow boiling heat transfer on hot spots In 3D compatible radial microchannels. In: ASME 2015 International Technical Conference and Exhibition on Packaging and Integration of Electronic and Photonic Microsystems, InterPACK 2015, collocated with the ASME 2015 13th International Conference on Nanochannels, Microchannels, and Minichannels. San Francisco, California, USA, 2015, pp. 1–7.

21.

Qidwai

Hasan

Khan

, et al. Performance evaluation of simple radial fin design for single phase liquid flow in microchannel heat sink. Proc IMechE, Part E: J Process Mechanical Engineering 2021; 235: 80–92.

22.

Herrmann-Priesnitz

Calderón-Muñoz

Valencia

, et al. Thermal design exploration of a swirl flow microchannel heat sink for high heat flux applications based on numerical simulations. Appl Therm Eng 2016; 109: 22–34.

23.

Huang

Lai

, et al. Fluid mixing in a swirl-inducing microchannel with square and T-shaped cross-sections. Microsyst Technol 2017; 23: 1971–1981.

24.

Dong

Jiang

Xie

, et al. Experimental investigation on boiling heat transfer characteristics of Al2O3-water nanofluids in swirl microchannels subjected to an acceleration force. Chin J Aeronaut 2019; 32: 1136–1144.

25.

Ruiz

Carey

. Experimental study of single phase heat transfer and pressure loss in a spiraling radial inflow microchannel heat sink. J Heat Transfer 2015; 137: 1–8.

26.

Incropera

. Liquid cooling of electronic devices by single-phase convection. New York: Wiley, 1999.

27.

Bird

Warren

Stewart

ENL

. Transport Phenomena. 2nd ed. New York/Chichester/Weinheim/Brisbane/Singapore/Toronto: John Wiley & Sons, Inc., 2012.

28.

Chiam

Lee

Singh

, et al. Investigation of fluid flow and heat transfer in wavy micro-channels with alternating secondary branches. Int J Heat Mass Transfer 2016; 101: 1316–1330.

29.

Lee

Chou

. Enhanced thermal transport in microchannel using oblique fins. J Heat Transfer 2012; 134: 1–10.