Abstract
The present study is aimed to eliminate the undesirable microstructure in the real working condition of the steel unit. In this work, the microstructure of hot-rolled medium carbon steel (grade 45C8) is studied for application in the automotive industry. The effect of the temperature and rolling rate on the microstructure has been thoroughly investigated by analyzing the microstructure containing ferrite and pearlite phases after each trial run of hot-rolled steel. The desired microstructure of fine ferrite and pearlite is very much essential in hot-rolled medium carbon steel for better strength and uniform properties of the material. The formation of coarse pearlite is undesirable, which may lead to breakage during drawing and hardness variation in the hot-rolled steel. Therefore, this study is focused to find the optimum condition for achieving the microstructure containing uniform distribution of fine pearlite and ferrite without the presence of blocky pearlite patches.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
