The objective of this study is to investigate the hysteresis loss of ultra-large off-the-road (OTR) tire rubber compounds based on typical operating conditions at mine sites. Cyclic tensile tests were conducted on tread and sidewall compounds at six strain levels ranging from 10% to 100%, eight strain rates from 10% to 500% s−1 and 14 rubber temperatures from −30°C to 100°C. The test results showed that a large strain level (e.g. 100%) increased the hysteresis loss of tire rubber compounds considerably. Hysteresis loss of tire rubber compounds increased with a rise of strain rates, and the increasing rates became greater at large strain levels (e.g. 100%). Moreover, a rise of rubber temperatures caused a decrease in hysteresis loss; however, the decrease became less significant when the rubber temperatures were above 10°C. Compared with tread compounds, sidewall compounds showed greater hysteresis loss values and more rapid increases in hysteresis loss with the rising strain rate.
SahooLKBandyopadhyaySBanerjeeR. Benchmarking energy consumption of truck haulage. In: Awuah-OffeiK (ed.) Energy efficiency in the minerals industry. 1st ed. New York, NY: Springer, 2018, pp.159–180.
CarterRA.OTR tire supply comes under pressure. Eng Min J2011; 212: 40.
4.
NyaabaWFrimpongSAnaniA.Fatigue damage investigation of ultra-large tire components. Int J Fatigue2019; 119: 247–260.
5.
MaraisJ.Numerical modelling and evaluation of the temperature distribution in an Earthmover Tyre: establishing a safe operating envelope. PhD Thesis, Stellenbosch University, South Africa, 2017.
6.
NyaabaW.Thermomechanical fatigue life investigation of an ultra-large mining dump truck tire. PhD Thesis, Missouri University of Science and Technology, USA, 2017.
7.
KerrCL.Load G-level as a Truck-Ground KPI. Master’s Thesis, University of Alberta, Canada, 2017.
8.
MeechJParreiraJ.Predicting wear and temperature of autonomous haulage truck tires. IFAC Proc Vol2013; 46: 142–147.
9.
ParreiraJ.An interactive simulation model to compare an autonomous haulage truck system with a manually-operated system. PhD Thesis, University of British Columbia, Canada, 2013.
10.
LiYLiuWYFrimpongS.Effect of ambient temperature on stress, deformation and temperature of dump truck tire. Eng Fail Anal2012; 23: 55–62.
11.
MaraisJVenterG.Numerical modelling of the temperature distribution in the cross-section of an earthmover tyre. Appl Math Model2018; 57: 360–375.
12.
HuXHeRHuangY, et al. A method to predict the dynamical behaviors of carbon black filled natural rubber at different temperatures. Polym Test2019; 79: 106067.
13.
TerrillERCenteaMEvansLR, et al. Dynamic mechanical properties of passenger and light truck tire treads. Report, Akron Rubber Development Laboratory, Inc., USA, February2010.
14.
HeYLiuLMaL, et al. Dependence of heat build-up of tire on temperature and frequency. Tire Ind2006; 6: 323–328.
15.
HeY.Study of the unsteady temperature field of tire. PhD Thesis, Huazhong University of Science and Technology, China, 2005.
16.
LvX.Study of rubber used in tire with low rolling resistance. PhD Thesis, Qingdao University of Science and Technology, China, 2005.
17.
DolezPINohileCAnhTH, et al. Exploring the chemical aspects of truck tire blowouts and explosions. Saf Sci2008; 46: 1334–1344.
18.
LindequeGC.A critical investigation into tyre life on an iron ore haulage system. J South Afr Inst Min Metall2016; 116: 317–322.
19.
AnzabiRV.Haul truck tire reliability and condition monitoring. PhD Thesis, University of Alberta, Canada, 2015.
20.
AnzabiRVNobesDSLipsettMG.Haul truck tire dynamics due to tire condition. J Phys Conf Ser2012; 364: 12005.
21.
ZhouJHallRAHuntingfordK, et al. Effect of off-the-road tyre rotation practices on tyre life: a case study. Min Technol2008; 117: 101–110.
22.
LiuMFattMSH. A constitutive equation for filled rubber under cyclic loading. Int J Non Linear Mech2011; 46: 446–456.
23.
LiuM.A three-dimensional hyper-viscoelasticity constitutive model for the dynamic response of rubber. PhD Thesis, University of Akron, USA, 2007.
24.
ZhiJWangSZhangM, et al. Numerical analysis of the dependence of rubber hysteresis loss and heat generation on temperature and frequency. Mech Time Depend Mater2019; 23: 427–442.
25.
ZhiJWangSWangH, et al. Analysis on energy loss of rubber under dynamic load. Acta Polym Sin2017; 4: 708–715.
26.
JosephA. Off-road tire tread. U.S. Patent application no. 14/343,313, USA, 2014.
WuF.Finite element analysis of temperature distribution in steady rolling tire. PhD Thesis, University of Science and Technology of China, China, 2009.
29.
Narasimha RaoKVKumarRKBoharaPC.A sensitivity analysis of design attributes and operating conditions on tyre operating temperatures and rolling resistance using finite element analysis. Proc IMechE, Part D: J Automobile Engineering2006; 220: 501–517.
30.
YooSUddinMSHeoH, et al. Thermoviscoelastic modeling of a nonpneumatic tire with a lattice spoke. Proc Inst Mech Eng Part D J Automob Eng2017; 231: 241–252.
31.
El-ZomorHM.Real-time estimation of pneumatic tyre hysteresis loss. Int J Heavy Veh Syst2019; 26: 175–187.
NyaabaWBolarinwaEOFrimpongS.Durability prediction of an ultra-large mining truck tire using an enhanced finite element method. Proc IMechE, Part D: J Automobile Engineering2019; 233: 161–169.
39.
KrmelaJKrmelováV.Dynamic experiment of parts of car tyres. Procedia Eng2017; 187: 763–768.
40.
LuoWHuXWangC, et al. Frequency-and strain-amplitude-dependent dynamical mechanical properties and hysteresis loss of CB-filled vulcanized natural rubber. Int J Mech Sci2010; 52: 168–174.
41.
ChoJRLeeHWJeongWB, et al. Numerical estimation of rolling resistance and temperature distribution of 3-D periodic patterned tire. Int J Solids Struct2013; 50: 86–96.
42.
LiFLiuJYangH, et al. Numerical simulation and experimental verification of heat build-up for rubber compounds. Polymer (Guildf)2016; 101: 199–207.
43.
LiFLiuFLiuJ, et al. Thermo-mechanical coupling analysis of transient temperature and rolling resistance for solid rubber tire: numerical simulation and experimental verification. Compos Sci Technol2018; 167: 404–410.
44.
MaritzJC.Numerical modelling and experimental measurement of the temperature distribution in a rolling tire. Master’s Thesis, Stellenbosch University, South Africa, 2015.
45.
TangTJohnsonDSmithRE, et al. Numerical evaluation of the temperature field of steady-state rolling tires. Appl Math Model2014; 38: 1622–1637.
46.
SmithRETangTJohnsonD, et al. Simulation of thermal signature of tires and tracks. Report, Mississippi State Univ Mississippi State Center for Advanced Vehicular Systems, USA, 2012.
47.
Van BlommesteinWB. Experimentally determined material parameters for temperature prediction of an automobile tire using finite element analysis. PhD Thesis, Stellenbosch University, South Africa, 2016.
48.
LeeHWChoJRJeongWB, et al. Mesh generation and hysteretic loss prediction of 3-D periodic patterned tire. Int J Automot Technol2014; 15: 411–417.
49.
BrancatiRStranoSTimponeF.An analytical model of dissipated viscous and hysteretic energy due to interaction forces in a pneumatic tire: theory and experiments. Mech Syst Signal Process2011; 25: 2785–2795.
50.
HeZ.Temperature virtual experimental field technology research for radial type. PhD Thesis, Jiangsu University, China, 2008.
51.
LiX.Study on the reinforcement and blend dependence of hyperelasticity of tire rubbers under the moderate finite deformation. PhD Thesis, University of Science and Technology of China, China, 2012.
52.
LiXDongYLiZ, et al. Experimental study on the temperature dependence of hyperelastic behavior of tire rubbers under moderate finite deformation. Rubber Chem Technol2011; 84: 215–228.
53.
XiaYLiWXiaY.Test and characterization for the incompressible hyperelastic properties of conditioned rubbers under moderate finite deformation. Acta Mech Solida Sin2004; 4: 307–314.
54.
LinYJHwangSJ.Temperature prediction of rolling tires by computer simulation. Math Comput Simul2004; 67: 235–249.
55.
TomitaYAzumaKNaitoM.Strain-rate-dependent deformation behavior of carbon-black-filled rubber under monotonic and cyclic straining. Key Eng Mater2007; 340: 1017–1024.
56.
AzumaKNaitoMTomitaY.Strain rate dependent constitutive equation of rubber and simulation of deformation behavior of carbon-black-filled rubber. Nippon Kikai Gakkai Ronbunshu A Hen (Trans Jpn Soc Mech Eng Part A)(Japan)2007; 19: 558–566.
57.
FengC.Analysis on temperature rise characteristic and mechanics of load vehicle radial tire. Master’s Thesis, Xi’an University of Science and Technology, China, 2017.
58.
JamshidiMTaromiFA.Study on temperature dependence of loss function in a model cord–adhesive–rubber system. J Adhes Sci Technol2007; 21: 169–177.
59.
JamshidiMAfsharFMohammadiN, et al. Study on cord/rubber interface at elevated temperatures by H-pull test method. Appl Surf Sci2005; 249: 208–215.
60.
JamshidiMAfsharFShamayeliB.Evaluation of cord/rubber adhesion by a new fatigue test method. J Appl Polym Sci2006; 101: 2488–2494.
61.
WangZPYuZLiK.Research of automobile tire vertical stiffness optimization method on the basis of ADAMS/Car. Key Eng Mater2013; 561: 527–532.
62.
XuY.The simulation analysis of tire’s stiffness characteristics and rolling resistance. PhD Thesis, South China University of Technology, China, 2011.
63.
RautPSwansonNKulkarniA, et al. Exploiting arene-perfluoroarene interactions for dispersion of carbon black in rubber compounds. Polymer (Guildf)2018; 148: 247–258.
64.
HuX.Micro-and macro-viscohyperelastic behavior of carbon black filled rubbers. PhD Thesis, Xiangtan University, China, 2013.
65.
ParkDMHongWHKimSG, et al. Heat generation of filled rubber vulcanizates and its relationship with vulcanizate network structures. Eur Polym J2000; 36: 2429–2436.
