Development and application of a control scheme to reduce insufficient operation of an NG-diesel dual-fuel automobile

Abstract

The thermal efficiency levels are generally maintained while the smoke emission levels are reduced significantly with natural-gas–diesel dual-fuel operation in comparison with those with diesel operation. Thus, the dual-fuel mode is a good choice for in-use vehicles to reduce the smoke emissions and the fuel cost. However, the higher hydrocarbon and carbon monoxide emissions compared with those for traditional diesel operation under low loads is a concern. In this paper, a control scheme is proposed to reduce insufficient operation in the natural-gas–diesel dual-fuel mode. Also, a control system, including a control unit and actuating devices, is developed to realize the scheme. The responses of the governor lever, the smoke emissions of the vehicle and the fuel consumption values are compared and analysed. The test results show that the response of the governor lever is sufficient for practical applications, as it is able to follow the pedal stroke instantaneously with good accuracy. The lugdown smoke emissions of the diesel mode do not conform to those given in the Chinese Standard GB 3847-2005, but those of the dual-fuel mode do. In the road tests, the substitution ratio of liquefied natural gas to diesel is 61.36%, and the fuel cost saving ratio is up to 21.71%. Overall, the scheme and the electronic control device work reliably and can be applied to both liquefied natural gas and compressed natural gas as gaseous fuels.

Keywords

Alternative vehicle designs heavy-duty vehicles natural-gas–diesel dual fuel diesel quantity control scheme electronic control device reduction in the smoke emissions

Get full access to this article

View all access options for this article.

References

Wellnitz

Subic

Ramona

(eds). 5th international conference on sustainable automotive technologies, Ingolstadt, Germany, 25–27 September 2013. Berlin: Springer, 2014.

Shi

Wang

. Simulations of the diesel engine performance with a two-stage sequential turbocharging system at different altitudes. Proc IMechE Part D: J Automobile Engineering 2014; 228(14): 1718–1726.

Lee

Sunwoo

. Model-based control of a diesel engine variable geometry turbine and exhaust gas recirculation system using a linear parameter varying methodology. Proc IMechE Part D: J Automobile Engineering 2014; 228(14): 1633–1643.

Papagiannakis

Hountalas

. Combustion and exhaust emission characteristics of a dual fuel compression ignition engine operated with pilot diesel fuel and natural gas. Energy Conversion Managmt 2004; 45(18): 2971–2987.

Gatts

Liu

Liew

. An experimental investigation of incomplete combustion of gaseous fuels of a heavy-duty diesel engine supplemented with hydrogen and natural gas. Int J Hydrogen Energy 2012; 37(9): 7848–7859.

Thipse

Kavathekar

Rairikar

. Development of environment friendly diesel–CNG dual fuel engine for heavy duty vehicle application in India. SAE paper 2013-26-0015, 2013.

Guerry

. Injection timing effects of diesel-ignited methane dual fuel combustion in a single cylinder research engine. Master Thesis, Mississippi State University, Starkville, Mississippi, USA, 2014.

Kwon

Hong

. Particle number and size distribution characteristics from diesel- and liquefied-natural-gas-fuelled buses for various emission certification modes in the Republic of Korea. Proc IMechE Part D: J Automobile Engineering 2010; 224(12): 1569–1579.

Song

. Study on the dual-fuel engine of liquefied natural gas piloted by electronically controlled common rail diesel. PhD Thesis, Chang’an University, Xi’an, Shaanxi, People’s Republic of China, 2014.

10.

Mohand

Khaled

Lyes

. Towards improvement of natural gas–diesel dual fuel mode: an experimental investigation on performance and exhaust emissions. Energy 2014; 64(1): 200–211.

11.

Lin

Wang

. Development of a sequential port injection, fully electronically controlled gas/diesel dual fuel engine. Trans CSICE 2001; 19(2): 102–108.

12.

Ren

Zhang

Ping

. Theoretical and simulation experimental study on gas delay pipe system of gaseous engine. Chin Internal Combust Engine Engng 2000; 21(1): 5–9.

13.

Park

Lim

Lee

. Effects of the ignition timing retard and the compression ratio on the full-load performance and the emissions characteristics of a heavy-duty engine fuelled by hydrogen–natural-gas blends. Proc IMechE Part D: J Automobile Engineering 2013; 227(9): 1295–1302.

14.

Pirouzpanah

Khoshbakhti Saray

. Enhancement of the combustion process in dual-fuel engines at part loads using exhaust gas recirculation. Proc IMechE Part D: J Automobile Engineering 2007; 221(7): 877–888.

15.

Srinivasan

Krishnan

Midkiff

. Improving low load combustion, stability, and emissions in pilot-ignited natural gas engines. Proc IMechE Part D: J Automobile Engineering 2006; 220(2): 229–239.

16.

Zhou

Liu

. Effect of the diesel injection timing and the pilot quantity on the combustion characteristics and the fine-particle emissions in a micro-diesel pilot-ignited natural-gas engine. Proc IMechE Part D: J Automobile Engineering 2013; 227(8): 1142–1152.

17.

Shabgard

Kheradmand

Bae

. Numerical simulation of the fuel trapped in the crevice during a pilot injection in a homogeneous charge compression ignition engine. Proc IMechE Part D: J Automobile Engineering 2014; 228(12): 1415–1423.

18.

Sogbesan

Davy

Garner

. Insights into the hydrocarbon and carbon monoxide emissions in moderately and highly dilute low temperature combustion. Proc IMechE Part D: J Automobile Engineering 2014; 228(11): 1285–1296.

19.

Zhang

Bian

. A study on an electronically controlled liquefied petroleum gas-diesel dual-fuel automobile. Proc IMechE Part D: J Automobile Engineering 2005; 219(2): 207–213.

20.

Chinese Standard GB 3847-2005 Limits and measurement methods for exhaust smoke from C.I.E. (compression ignition engine) and vehicle equipped with C.I.E. Beijing: Standardization Administration of the People’s Republic of China.