This paper describes a fault-tolerant driving control strategy for steer-by-wire system failures in six-wheel-driving–six-wheel-steering vehicles. The fault-tolerant driving control algorithm was designed to obtain vehicle manoeuvrability as close as possible to that of non-faulty vehicles by redistributing the tractive forces of the non-faulty wheels. Since a faulty steer-by-wire system induces a high lateral tyre force, which is the resistance to the yaw motion of the vehicle, a high-wheel slip control strategy is used to minimize the resistive lateral tyre force of the faulty steer-by-wire system. The fault-tolerant driving performance of a faulty six-wheel-driving–six-wheel-steering vehicle was investigated via computer simulations. To investigate the effectiveness of the proposed fault-tolerant driving control algorithm, the fault recovery rate was defined and calculated in terms of the vehicle manoeuvrability. Simulation studies show that the proposed fault-tolerant driving control algorithm can significantly improve the vehicle manoeuvrability, compared with the optimal traction redistribution method.
Van ZantenATErhardtRLandesfeindKPfaffG. VDC systems development a yaw moment control using braking forces. JSME Int J1999; 42(2): 301–308.
2.
NagaiMShinoMGaoF. Study on integrated control of active front steer angle and direct yaw moment. JSAE Rev2002; 23: 309–315.
3.
SongJHKimHSKimBS. Vehicle longitudinal and lateral stability enhancement using a TCS and yaw motion controller. Int J Automot Technol2007; 1(8): 49–57.
4.
ShibahataYShimadaKTomariT. The improvement of vehicle maneuverability by direct yaw moment control. In: 1st international symposium on advanced vehicle control, Yokohama, Japan, 14–18 September 1992, pp. 452–457. Tokyo: JSAE.
5.
AnSJYiKJungG. Desired yaw rate and steering control method during cornering for a six-wheeled vehicle. Int J Automot Technol2008; 9(2): 173–181.
6.
BertoluzzoMBolognesiPBrunoO. Drive-by-wire systems for ground vehicles. In: 2004 IEEE international symposium on industrial electronics, Ajaccio, France, 4–7 May 2004, vol. 1, pp. 711–716. New York: IEEE.
7.
HuhKKimJHongJ. Handling and driving characteristics for six-wheeled vehicle. Proc IMechE Part D; J Automobile Engineering2000; 214(2): 159–170.
8.
JacksonACrollaD. Improving performance of a 6 × 6 off-road vehicle through individual wheel control. SAE paper 2002-01-0968, 2002.
9.
IsermannRSchwarzRStolzlS. Fault-tolerant drive-by-wire systems. IEEE Control Systems Mag2002; 22(5): 64–81.
10.
ZhengBAnwarS. Fault-tolerant control of the road wheel subsystem in a steer-by-wire system. A Rev Control2005; 29: 71–85.
11.
HacA. Control of brake- and steer-by-wire systems during brake actuator failure. SAE paper 2006-01-0923, 2006.
12.
ZhengBAltemareCAnwarS. Fault tolerant steer-by-wire road wheel control system. In: American control conference, Portland, Oregon, USA, 8–10 June 2005, vol. 3, pp. 1619–1624. New York: IEEE.
13.
AnwarSChenL. An analytical redundancy-based fault detection and isolation algorithm for a road-wheel control subsystem in a steer-by-wire system. IEEE Trans Veh Technol2007; 56(5): 2859–2869.
14.
KimWYiKLeeJ. An optimal traction, braking, and steering coordination strategy for stability and manoeuvrability of a six-wheel drive and six-wheel steer vehicle. Proc IMechE Part D: J Automobile Engineering2012; 226(1): 3–22.
15.
MokhiamarOAbeM. Simultaneous optimal distribution of lateral and longitudinal tire forces for the model following control. Trans ASME, J Dynamic Systems, Measmt Control2004; 126: 753–763.
16.
KimWGKangJYYiK. Drive control system design for stability and maneuverability of a 6WD–6WS vehicle. Int J Automot Technol2011; 12(1): 67–74.
17.
YihPGerdesJC. Modification of vehicle handling characteristics via steer-by-wire. IEEE Trans Control System Technol2005; 13(6): 965–976.
18.
HsuJGerdesJC. Stabilization of a steer-by-wire vehicle at the limits of handling using feedback linearization. In: 2005 ASME international mechanical engineering congress and exposition, Orlando, FL, USA, 5–11 November 2005, paper IMECE2005-81203. New York: ASME.
19.
PacejkaHB. Tyre and vehicle dynamics. Oxford: Butterworth–Heinemann, 2002.
20.
MaclaurinB. Comparing the steering performances of skid- and Ackermann-steered vehicles, Proc IMechE Part D: J Automobile Engineering2008; 222(5): 739–756.
21.
ImJSOzakiFYeuTKKawajiS. Model-based fault detection and isolation in steer-by-wire vehicle using sliding mode observer. J Mech Sci Technol2009; 23: 1991–1999.
22.
IsermannR. Model-based fault-detection and diagnosis – status and applications. A Rev Control2005; 29: 71–85.
23.
KobayashiKKaCCheoPWatanabeK. Estimation of absolute vehicle speed using fuzzy logic rule-based Kalman filter. In: American control conference, Seattle, WA, USA, 21–13 June 1995, vol. 5, pp. 3086–3090. New York: IEEE.
24.
KimWYiKLeeJ. Development of a driving control algorithm and performance verification using real-time simulator for a 6WD–6WS Vehicle. SAE paper 2011-01-0262, 2011.
25.
KimS-HKimD-HKimC-J. A study on motion control of 6WD–6WS vehicle using optimum tire force distribution method. In: International conference on control, automation and systems, Gyeonggi-do, Republic of Korea, 27–30 October 2010, pp. 1502–1507. New York: IEEE.
26.
BakkerENyborgLPacejkaHB. Tyre modelling for use in vehicle dynamics studies. SAE paper 870421, 1987.
27.
ZhangQLiuGWangYZhouT. A study of calculation method of wheel angular acceleration in ABS system In: 2004 international conference on information acquisition, Hefei, People’s Republic of China, 21–25 June 2004, pp. 147–150. New York: IEEE.
