The development of high-speed trains has increased the demand for dynamic vehicle tests on roller rigs. This study presents a nonlinear multi-body dynamic model of a vehicle system running on a roller rig and an actual track. Dynamic tests for a high-speed vehicle were performed using a full-scale roller rig to validate the numerical model. The hunting stability characteristics of the vehicle were investigated by performing a comparative analysis of the roller rig tests and numerical simulations of the vehicle on roller rigs and tracks. The results indicate that the critical hunting speed of the vehicle on a roller rig is lower than that on a track, particularly under significantly high or low equivalent conicity and yaw damper failure conditions. The characteristics of the hunting stability, riding performance, and lateral acceleration of the bogie frame were comparable in both rig tests and line operations, exhibiting consistent trends under the normal operation of the suspension system with the wheel/rail matches existing within the ideal range of equivalent conicity. However, the lateral acceleration or lateral Sperling index of the carbody could better detect the carbody hunting under low equivalent conicities, particularly when the lateral acceleration of the bogie was not sufficiently effective.
WeiWYabunoH. Subcritical Hopf and saddle-node bifurcations in hunting motion caused by cubic and quintic nonlinearities: experimental identification of nonlinearities in a roller rig. Nonlinear Dyn2019; 98: 657–670.
5.
ContiRMeliERidolfiA. A full-scale roller-rig for railway vehicles: multibody modelling and hardware in the loop architecture. Multibody Syst Dyn2016; 37: 69–93.
6.
AlehashemSMSNiYQLiuXZ. A full-scale experimental investigation on ride comfort and rolling motion of high-speed train equipped with MR dampers. IEEE Access2021; 9: 118113–118123.
7.
NaimKVerardiRAriaudoC, et al. Impact of maintenance conditions of vehicle components on the vehicle–track interaction loads. Proc IMechE, Part C: J Mechanical Engineering Science2018; 232(15): 2626–2641.
8.
ZhangZZhouJSunW, et al. Analysis of consistency of ride quality evaluation algorithm for railway vehicles. Journal of Tongji University2023; 51(9): 1442–1449.
9.
ZhaiWLiuPLinJ, et al. Experimental investigation on vibration behaviour of a CRH train at speed of 350 km/h. Int J Rail Transp2015; 3(1): 1–16.
10.
DybalaV. The measurement of the influence of the adhesion loss on the dynamic load of the drive reaction rod on the roller rig. Acta Polytechnica CTU Proc2023; 43: 6–12.
11.
MeymandSCraftMAhmadianM. On the application of roller rigs for studying rail vehicle systems. In: ASME 2013 rail transportation division fall technical conference, 2013. DOI: 10.1115/RTDF2013-4724.
12.
KalivodaJBauerP. Scaled roller rig to assess the influence of active wheelset steering on wheel-rail contact forces. In: Proceedings of the IAVSD symposium on dynamics of vehicles on roads and track, 2019, pp.82–89. DOI: 10.1007/978-3-030-38077-9_10.
13.
BossoNGugliottaAMagelliM, et al. Experimental setup of an innovative multi-axle roller rig for the investigation of the adhesion recovery phenomenon. Exp Tech2019; 43: 695–706.
14.
ShiHGanFLiF, et al. Numerical and experimental investigation of the wheel/rail interaction and dynamics for a high-speed gauge-changeable railway vehicle. Veh Syst Dyn2022; 60(9): 3198–3214.
15.
MyamlinSKalivodaJNeduzhaL. Testing of railway vehicles using roller rigs. Procedia Eng2017; 187: 688–695.
16.
JaschinskiACholletHIwnickiS, et al. The application of roller rigs to railway vehicle dynamics. Veh Syst Dyn1999; 31: 345–392.
17.
LiuBBruniS. A method for testing railway wheel sets on a full-scale roller rig. Veh Syst Dyn2015; 53(9): 1331–1348.
18.
García-PradaJCastejónCRubioH, et al. Methodology to characterize the von Misses stress in the contact between wheel and rail (test-rig). In: 18th IWC, Chengdu, 2016, pp.34–38. DOI: 10.1109/IWC.2016.8068363.
19.
LiuW. Method of curve simulation of railway vehicle on roller rig. J Mech Eng2018; 54(16): 127.
20.
AllenPDZhangWLiangY, et al. Chapter 19: roller rig. In: IwnickiSSpiryaginMColinC, et al. (eds.), Handbook of railway vehicle dynamics. Boca Raton, FL: CRC Press, 2019, p.765.
21.
MAlvezziMAllottaBPugiL. Feasibility of degraded adhesion tests in a locomotive roller rig. Proc IMechE, Part F: J Rail and Rapid Transit2008; 222(1): 27–43.
22.
WeiLZengJHuangC, et al. Hunting stability and dynamic stress analysis of a high-speed bogie using elastic-suspended motors as dynamic vibration absorber. Veh Syst Dyn2024: 1–23. DOI: 10.1080/00423114.2023.2289654.
23.
BhardawajSSharmaRCGuptaP, et al. A review of wheel-rail contact mechanics for railway vehicles. Int J Veh Struct Syst2023; 15(3): 365–371.
24.
SunJChiMCaiW, et al. Numerical investigation into the critical speed and frequency of the hunting motion in railway vehicle system. Math Probl Eng2019; 2019: 1–15.
25.
UyulanÇGokasanM. Nonlinear dynamic characteristics of the railway vehicle. Nonlinear Eng2017; 6(2): 123–137.
26.
QiYDaiH. Influence of motor harmonic torque on wheel wear in high-speed trains. Proc IMechE, Part F: J Rail and Rapid Transit2020; 234(1): 32–42.
27.
VollebregtEVoltrP. Improved accuracy for FASTSIM using one or three flexibility values. Veh Syst Dyn2023; 61(1): 309–317.
28.
LuoRShiHL. Dynamics of railway vehicle systems and application. Chengdu: Southwest Jiaotong University Press, 2018.
29.
XiaZZhouJGongD, et al. Theoretical study on the effect of the anti-yaw damper for rail vehicles. Proc IMechE, Part C: J Mechanical Engineering Science2020; 234(2): 457–473.
30.
AlonsoAGiménezJGGomezE. Yaw damper modelling and its influence on railway dynamic stability. Veh Syst Dyn2011; 49(9): 1367–1387.
31.
DaiXWuPShiH, et al. Failure time prediction for vehicle dynamics under performance degradation of dampers and track evolution. Proc IMechE, Part O: J Risk and Reliability2023; 77(4): 1485–1502.
32.
LiuCSongYLiF, et al. Development method and experimental verification of fatigue load spectrum of anti-yaw damper for rail vehicles. Eng Fail Anal2022; 138(1): 1485–1502.
33.
ZengYCSongDLZhangWH, et al. Stochastic failure process of railway vehicle dampers and the effects on suspension and vehicle dynamics. Veh Syst Dyn2021; 59(5): 703–718.
