This study aims to numerically investigate the impact of air supply terminal devices (ASTDs) on the performance of novel variable refrigerant flow (VRF) integrated stratum ventilation (SV) system. The novel VRF-SV hybrid system was designed and analyzed in the authors’ previous work, where different design configurations were tested and their performances were compared. However, the effect of ASTDs on the performance of novel system has not yet been thoroughly explored. Therefore, this study was designed to investigate the effect of four types of ASTDs, including bar grille, double deflection grille, drum louver and jet slot diffusers installed in the laboratory and meeting room environments. The temperature and velocity field distribution, thermal comfort and indoor air quality (IAQ) were examined as performance indicators. The Re-Normalization Group (RNG), Realizable and Standard k-ϵ turbulence models were also employed in this study to verify and validate the numerical predictions with the experimental measurements. The experimental results found relatively close to the predictions obtained through RNG k-ϵ model with maximum deviations at any location were found to be 0.28 m/s in terms of velocity and 1.6°C in terms of temperature magnitude. Further research demonstrated that among the studied ASTDs, the bar grille diffuser provided an adequate thermal environment for the occupants with an acceptable jet throw and IAQ. This benefit also suggests that if the bar grille is installed with the VRF-SV system, the system would require less fan power, and thus, it reduces the energy use by the fan.
ChenHJanbakhshSLarssonU, et al. Numerical investigation of ventilation performance of different air supply devices in an office environment. Build Environ2015; 90: 37–50.
2.
ChenH. Experimental and numerical investigations of a ventilation strategy – impinging jet ventilation for an office environment. Linköping Studies in Science and Technology Dissertation no. 1606, 2014.
3.
Pérez-LombardLOrtizJCoronelJF, et al. A review of HVAC systems requirements in building energy regulations. Energy Build2011; 43(2–3): 255–268.
4.
SaabRAl QuabehHHassan AliMI. Variable refrigerant flow cooling assessment in humid environment using different refrigerants. J Environ Manag2018; 224: 243–251.
KimDCoxSJChoH, et al. Model calibration of a variable refrigerant flow system with a dedicated outdoor air system: A case study. Energy Build2018; 158: 884–896.
7.
LaughmanCRBortoffSAQiaoH. Integrated control of multi-zone buildings with ventilation and VRF systems in cooling mode. Indiana: Mitsubishi Electric Research Laboratories, 2018.
8.
ElectricM. DOAS and VRF: applying systems for high-performance buildings, Mitsubishi Electric, 2018.
9.
ZhuY, et al. An energy-saving control strategy for VRF and VAV combined air conditioning system in heating mode. In: International refrigeration and air conditioning conference. Purdue University, Indiana, 2014.
10.
AynurTNHwangYRadermacherR. Integration of variable refrigerant flow and heat pump desiccant systems for the cooling season. Appl Therm Eng2010; 30(8–9): 917–927.
11.
Cruz-SalasMVCastilloJAHuelszG. Effect of Windex changer duct cross-section area and geometry on the room airflow distribution. J Wind Eng Ind Aerodynamics2018; 179: 514–523.
12.
LinZChowTTTsangCF, et al. Stratum ventilation – a potential solution to elevated indoor temperatures. Build Environ2009; 44(11): 2256–2269.
13.
LinZ. Stratum ventilation – a solution to meet challenges to contemporary air distribution. REHVA J2014: 40–43.
14.
LiuZLiuZZuoZ. Effect of stratum ventilation on thermal comfort and energy utilization efficiency of numerical simulation. Energy Proc2017; 105: 3596–3602.
15.
TianLLinZWangQ. Experimental investigation of thermal and ventilation performances of stratum ventilation. Build Environ2011; 46(6): 1309–1320.
16.
YauYHRajputUA. Thermal comfort assessment and design guidelines of a VRF-integrated stratum ventilation system for a large tropical building. Arab J Sci Eng2022; 47(12): 16149–16170.
17.
NadaSAEl-BatshHMElattarHF, et al. CFD investigation of airflow pattern, temperature distribution and thermal comfort of UFAD system for theater buildings applications. J Build Eng2016; 6: 274–300.
18.
LinZChowTTTsangCF, et al. CFD study on effect of the air supply location on the performance of the displacement ventilation system. Build Environ2005; 40(8): 1051–1067.
19.
SuiXZhangX. Effects of radiant terminal and air supply terminal devices on energy consumption of cooling load sharing rate in residential buildings. Energy Build2012; 49: 499–508.
20.
YaoTLinZ. An experimental and numerical study on the effect of air terminal types on the performance of stratum ventilation. Build Environ2014; 82: 431–441.
21.
YauYHRajputUA. Performance evaluation of an architecturally-designed vertical high capacity linear slot diffuser in a tropical atrium. Archit Sci Rev2023; 66(1): 53–69.
22.
HuSC. Airflow characteristics in the outlet region of a vortex room air diffuser. Build Environ2003; 38(4): 553–561.
23.
ZhivovA, et al. Chapter 7–Principles of air and contaminant movement inside and around buildings. In: GoodfellowHDKosonenR (eds) Industrial Ventilation Design Guidebook. 2nd ed.Academic Press, 2020, pp.245–370. https://doi.org/10.1016/B978-0-12-816780-9.00007-1
24.
NastaseIMeslemAVladI, et al. Lobed grilles for high mixing ventilation – an experimental analysis in a full scale model room. Build Environ2011; 46(3): 547–555.
25.
SajadiBSaidiMHMohebbianA. Numerical investigation of the swirling air diffuser: parametric study and optimization. Energy Build2011; 43(6): 1329–1333.
26.
SunYSmithTF. Air flow characteristics of a room with square cone diffusers. Build Environ2005; 40(5): 589–600.
27.
ConceiçãoEZERosaSPCustódioALV, et al. Study of airflow around occupants seated in desks equipped with upper and lower air terminal devices for slightly warm environments. HVAC&R Res2010; 16(4): 401–412.
28.
ZhaoHLiuZZuoZ. Numerical simulation of indoor thermal environment effected by air supply temperature and grille angle on stratum ventilation in a typical office. Procedia Eng2015; 121: 779–784.
29.
ChengYLinZWuW, et al. Performance evaluation of stratum ventilation with slot diffuser using CFD. Indoor Environ2014: 470–477.
30.
YaoTLinZ. Numerical study of the effect of air terminal layouts on the performance of stratum ventilation system. In: International high performance buildings conference. Purdue University Purdue e-Pubs, 2014.
31.
YauYHRajputUA. Numerical simulation of a novel VRF-SV hybrid system performance in a large retail facility in the tropics. J Build Perform Simul2022; 15: 323–344.
32.
Paul SolbergJMGuckelbergerDSturmE. Applying variable refrigerant flow, TRANE, 2014.
33.
ZhengCYouSZhangH, et al. Comparison of air-conditioning systems with bottom-supply and side-supply modes in a typical office room. Appl Energy2018; 227: 304–311.
34.
AganovicASteffensenMCaoG. CFD study of the air distribution and occupant draught sensation in a patient ward equipped with protected zone ventilation. Build Environ2019; 162. https://doi.org/10.1016/j.buildenv.2019.106279
35.
XingwangZQingyanC. Optimal Design Of An Indoor Environment Using An RNG K-E Adjoint Turbulence Model. Proceedings of Building Simulation 2019: 16th Conference of IBPSA, IBPSA. 2019; 16: 798–804.
36.
HussainSOosthuizenPHKalendarA. Evaluation of various turbulence models for the prediction of the airflow and temperature distributions in atria. Energy Build2012; 48: 18–28.
37.
BeggsCBKerrKGNoakesCJ, et al. The ventilation of multiple-bed hospital wards: review and analysis. Am J Infect Control2008; 36(4): 250–259.
38.
Thermal environmental conditions for human occupancy. In: ANSI/ASHRAE Addendum D to ANSI/ASHRAE Standard 55-2017. Atlanta: ASHRAE, 2020.
39.
BrauerH. Mathematical models of turbulence. Von B. E. Launder u. D. B. Spalding. Academic Press, London–New York 1972. 1. Aufl., V, 169 S., zahlr. Abb., geb., £ 2.50. Chem Ing Tech1973; 45(3): 143–143.
40.
Ansys. ANSYS fluent theory guide, 2015.
41.
KubicekBHribernikWBraunerG, et al. CFD analysis of the turbulent flow field and thermal behavior of high-current electric switchgear. Turbulence, Heat and Mass Transfer 6. K. Hanjalić, Y. N. and and S. Jakirlić. Austria, Austrian Institute of Technology, Department for Energy, Vienna, Austria, 2009.
42.
WeiJTangJWBorojeniAAT, et al. Low re-inhalation of the exhaled flow during normal nasal breathing in a pediatric airway replica. Build Environ2016; 97: 40–47.
43.
OaksWRCraigJDuranC, et al. On the Lagrangian dynamics of saliva particles during normal mouth breathing. Physics of Fluids 12022; 34(4): 041904. https://doi.org/10.1063/5.0087700
44.
BulińskaABulińskiZ. A CFD analysis of different human breathing models and its influence on spatial distribution of indoor air parameters. Comput Assist Methods Eng Sci2017; 22(3): 213–227.
45.
International Standard Organization (ISO-7730)-Ergonomics of the thermal environment, 2005.
46.
AflakiAMahyuddinNAl-Cheikh MahmoudZ, et al. A review on natural ventilation applications through building façade components and ventilation openings in tropical climates. Energy Build2015; 101: 153–162.
47.
ANSI/ASHRAE. Thermal environmental conditions for human occupancy (Standard 55-2017), 2017.
48.
FangerPO. Thermal comfort. Analysis and applications in environmental engineering. Copenhagen: Danish Technical Press, 1970, p.244.
