In this study, unsteady numerical simulations of centrifugal compressors with and without volute were carried out. The unsteady two-phase region evolution in the centrifugal compressor is obtained. Large coherent perturbations were revealed by the decomposition of the transient flow data using the dynamic mode decomposition (DMD) approach. The results imply that because of the low static pressure strip LP1, the two-phase region presents a triangular distribution at the blade leading edge (LE) of the pressure surface (PS) side in one impeller rotation period for both a low flow rate and the design flow rate. At a high flow rate, the two-phase region displays a double triangle distribution on the PS side of the blade LE, which is correlated with the low static pressure strips LP1 and LP2. The maximum two-phase region on the PS side of the LE of the blade occurs downstream of the LP1 position. The two-phase region in the tip clearance is deflected along the LP1 trajectory. DMD analysis shows that there are four modes related to the two-phase region in the tip clearance: mean flow mode with a frequency of 0 Hz and three modes with frequencies of 0.5, 1.0, and 1.5 BPF respectively. Furthermore, the circumferential local perturbation region of these four modes has the same deflection trajectory as that of LP1.
MohammadiKEllingwoodKPowellK.Novel hybrid solar tower-gas turbine combined power cycles using supercritical carbon dioxide bottoming cycles. Appl Therm Eng2020; 178: 115588.
2.
BinottiMAstolfiMCampanariS, et al. Preliminary assessment of sCO2 cycles for power generation in CSP solar tower plants. Appl Energy2017; 204: 1007–1017.
3.
SondelskiBNellisG.Mass optimization of a supercritical CO2 Brayton cycle with a direct cooled nuclear reactor for space surface power. Appl Therm Eng2019; 163: 114299.
4.
BaeSJLeeJAhnY, et al. Preliminary studies of compact Brayton cycle performance for small modular high temperature gas-cooled reactor system. Ann Nucl Energy2015; 75: 11–19.
5.
MecheriMLe MoullecY.Supercritical CO2 Brayton cycles for coal-fired power plants. Energy2016; 103: 758–771.
6.
ZhouJZhuMTangY, et al. Innovative system configuration analysis and design principle study for different capacity supercritical carbon dioxide coal-fired power plant. Appl Therm Eng2020; 174: 115298.
7.
SongJLiXSRenXD, et al. Performance improvement of a preheating supercritical CO2 (S-CO2) cycle based system for engine waste heat recovery. Energy Convers Manag2018; 161: 225–233.
8.
HouSWuYZhouY, et al. Performance analysis of the combined supercritical CO 2 recompression and regenerative cycle used in waste heat recovery of marine gas turbine. Energy Convers Manag2017; 151: 73–85.
9.
BehafaridFPodowskiMZ.Modeling and computer simulation of centrifugal CO2 compressors at supercritical pressures. J Fluid Eng2016; 138(6): 061106.
10.
AmeliATurunen-SaarestiTBackmanJ.Numerical investigation of the flow behavior inside a supercritical CO2 centrifugal compressor. J Eng Gas Turbine Power2018; 140(12): 122604.
11.
MaCWangWWuJ, et al. Analysis of unsteady flow in a supercritical carbon dioxide radial compressor stage. In: Proceedings of the 2018 26th international conference on nuclear engineering. Volume 6B: thermal-hydraulics and safety analyses, London, England, 22–26July2018, V06BT08A037. ASME.
12.
RinaldiEPecnikRColonnaP.Numerical computation of the performance map of a supercritical CO2 radial compressor by means of three-dimensional CFD simulations. In: Proceedings of the ASME turbo expo 2014: tubomachinery technical conference and exposition, Düsseldorf, Germany, 16–24June2014.
13.
HosangadiALiuZWeathersT, et al. Modeling multiphase effects in CO2 compressors at subcritical inlet conditions. J Eng Gas Turbine Power2019; 141(8): 081005.
14.
WrightSRadelRVernonM, et al. Operation and analysis of a supercritical CO2 Brayton cycle. Sandia report, no. SAND2010-0171. Sandia National Laboratories.
15.
PhamHSAlpyNFerrasseJH, et al. An approach for establishing the performance maps of the SC-CO2 compressor: development and qualification by means of CFD simulations. Int J Heat Fluid Flow2016; 61: 379–394.
16.
BaltadjievNDLettieriCSpakovszkyZS.An investigation of real gas effects in supercritical CO2 centrifugal compressors. J Turbomach2015; 137: 6–091003.
17.
SaxenaSMallinaRMoragaF, et al. Numerical approach for real gas simulations-part II: flow simulation for supercritical CO2 centrifugal compressor. In: Proceedings of the ASME Turbo Expo 2017: turbomachinery technical conference and exposition, Charlotte, North Carolina, 26–30June2017.
18.
RinaldiEPecnikRColonnaP.Computational fluid dynamic simulation of a supercritical CO2 compressor performance map. J Eng Gas Turbine Power2015; 137(7): 072602.
19.
GuoDShiDZhangD.Investigation on steady and unsteady performance of a SCO2 centrifugal compressor with splitters. Therm Sci2017; 21: 185–192.
20.
WangYShiDZhangD, et al. Investigation on unsteady flow characteristics of a SCO2 centrifugal compressor. Appl Sci2017; 7(4): 310.
21.
LiJJiLYiW.Experimental and numerical investigation on the aerodynamic performance of a compressor cascade using blended blade and end wall. Proc IMechE, Part G: J Aerospace Engineering2017; 232(15): 2833–2844.
22.
YangXZhuXHuC, et al. Compressed dynamic mode decomposition for the analysis of centrifugal compressor volute. Int J Heat Fluid Flow2018; 74: 118–129.
23.
HuCYangCShiX, et al. Investigation of rotating stall in radial vaneless diffusers with asymmetric inflow. Aerosp Sci Technol2020; 96: 105546.
24.
HuCYangXZhuX, et al. Stability and structural sensitivity analysis of the turbulent flow in the narrow vaneless diffuser with mean flow method. Comput Fluids2018; 177: 46–57.
25.
LenganiDSimoniDUbaldiM, et al. Experimental investigation on the time–space evolution of a laminar separation bubble by proper orthogonal decomposition and dynamic mode decomposition. J Turbomach2017; 139(3): 031006.
26.
HongSHuangGYangY, et al. Introduction of DMD method to study the dynamic structures of a three-dimensional centrifugal compressor with and without flow control. Energies2018; 11(11): 3098.
27.
SchmidPJ.Dynamic mode decomposition of numerical and experimental data. J Fluid Mech2010; 656(10): 5–28.
28.
TuJRowleyWLuchtenburgD, et al. On dynamic mode decomposition: theory and applications. J Comput Dyn2015; 1(2): 391–421.
29.
LemmonEWBellHBHuberML, et al. NIST standard reference database 23: reference fluid thermodynamic and transport properties-REFPROP, version 9.0. Gaithersburg, MD: NIST NSRDS, 2010.
30.
ShaoWWangXYangJ, et al. Design parameters exploration for supercritical CO2 centrifugal compressors under multiple constraints. In: Proceedings of the ASME turbo expo 2016: tubomachinery technical conference and exposition, Seoul, South Korea, 13–17June2016.
31.
ZhaoHDengQZhangH, et al. The Influence of tip clearance on supercritical CO2 centrifugal compressor performance. In: Proceedings of the ASME turbo expo 2015: tubomachinery technical conference and exposition, Montréal, Canada, 15–19June2015.
32.
ShaoWYangJWangX, et al. Accuracy study and stability control of a property-table-based CFD strategy for modeling SCO2 compressors working near the critical point of the fluid. Appl Therm Eng2021; 183: 116222.
33.
ShaoWYangJWangX, et al. A real gas-based throughflow method for the analysis of SCO2 centrifugal compressors. Proc IMechE, Part C: J Mechanical Engineering Science2020; 234(10): 1943–1958.
34.
LagumbayRSVasilyevOVHaselbacherA.Homogeneous equilibrium mixture model for simulation of multiphase/multicomponent flows. Int J Numer Meth Fluids2007; 00: 1–6.
35.
Bruce StewartHWendroffB. Two-phase flow: models and methods. J Comput Phys1984; 56(3): 363–409.
36.
LiuYWLiuBJLuLP.Study of modeling unsteady blade row interaction in a transonic compressor stage part 1: code development and deterministic correlation analysis. Acta Mech Sin2012; 28: 281–290.
37.
LettieriCPaxsonDSpakovszkyZ, et al. Characterization of nonequilibrium condensation of supercritical carbon dioxide in a de Laval nozzle. J Eng Gas Turbine Power2018; 140(4): 041701.
38.
YangCWangYLaoD, et al. Detailed measurements of the static pressure characteristics around the centrifugal compressor casing wall. J Therm Sci Technol2017; 12(1): JTST0009.
39.
YangCWangWZhangH, et al. Investigation of stall process flow field in transonic centrifugal compressor with volute. Aerosp Sci Technol2018; 81: 53–64.
40.
ZhangHYangCWangW, et al. Investigation on the casing static pressure distribution and stall behaviors in a centrifugal compressor with volute. Int J Mech Sci2019; 160(209): 318–331.
