Abstract
The brake system creation is an important achievement for automotive production. However there is a secondary response of this system, its noise emission. Brake noise researches started in 1920’s and since then several causes were identified. In addition, many kinds of noises, their frequency range and characteristics were detected. Between these, the squeal is the noise that most concerns the automotive industry by reason of high warranty costs and environmental impact. The squeal noise occurs as a result of three mechanisms that are the stick-slip, the sprag-slip and the modal coupling and these are connected to material parameters of the brake components. This paper proposes a correlation between material and stability parameters of a light duty automotive duplex drum brake to indicate the influence of this on brake squeal. The results suggest that friction coefficient is the most influential parameter and its restrain does make possible to maintain squeal level under emissions regulations.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
