This paper develops a theoretical model for energy and exergy analyses of a solar-powered Lithium-water absorption refrigeration system using a recto-trapezoidal flat plate solar collector. The effect of collector fluid inlet temperature is to examine the overall performance of the solar collector and the vapour absorption system for a wide range of design variables. The parameters computed are energy and exergy efficiencies of the solar collector plate, coefficient of performance, cooling efficiency, exergy destruction rates, thermal exergy loss rates, irreversibility, and exergetic efficiency of the absorption refrigeration cycle. The simulation results indicate that there exists an optimum inlet temperature of collector fluid for the maximum system coefficient of performance and exergetic efficiency. When the cooling system runs at this temperature, the absorber plate volume attains a minimum value. Furthermore, the performance results are significantly better when a higher absorber plate thickness parameter is for the recto-trapezoidal profile. Finally, a comparative study analyzes the collector performance parameters of an absorber plate having rectangular, triangular, or trapezoidal profile by selecting their respective parameters of geometries. When an additional constraint imposes on the plate volume, it found that using a recto-trapezoidal profile instead of a rectangular profile saves at least 30% or more collector material, and also it may have better performance than a triangular or trapezoidal profile.
Shun-FuLSherifSA.Second law analysis of various double-effect lithium bromide/water absorption chillers/discussion. ASHRAE Trans2001;
107.
5.
KhaliqAKumarR.Exergy analysis of double effect vapor absorption refrigeration system. Int J Energy Res2008;
32: 161–174.
6.
SedighiKFarhadiMLiaghiM.Exergy analysis: parametric study on lithium bromide—water absorption refrigeration systems. Proc IMechE, Part C: J Mechanical Engineering Science2007;
221: 1345–1351.
7.
SuYFChenCO.Exergetic efficiency optimization of a refrigeration system with multi-irreversibilities. Proc IMechE, Part C: J Mechanical Engineering Science2006;
220: 1179–1187.
8.
AroraAKaushikSC.Theoretical analysis of LiBr/H2O absorption refrigeration systems. Int J Energy Res2009;
33: 1321–1340.
9.
LuminosuIFaraL.Determination of the optimal operation mode of a flat solar collector by exergetic analysis and numerical simulation. Energy2005;
30: 731–747.
10.
TongYLeeHKangW, et al.
Energy and exergy comparison of a flat-plate solar collector using water, Al2O3 nanofluid, and CuO nanofluid. Appl Therm Eng2019;
159: 113959.
11.
BellosETzivanidisC.Performance analysis and optimization of an absorption chiller driven by nanofluid based solar flat plate collector. J Clean Prod2018;
174: 256–272.
12.
FarahatSSarhaddiFAjamH.Exergetic optimization of flat plate solar collectors. Renew Energy2009;
34: 1169–1174.
13.
EsenHOzgenFEsenM, et al.
Modelling of a new solar air heater through least-squares support vector machines. Expert Syst Appl2009;
36: 10673–10682.
14.
EsenHOzgenFEsenM, et al.
Artificial neural network and wavelet neural network approaches for modelling of a solar air heater. Expert Syst Appl2009;
36: 11240–11248.
15.
AltaDBilgiliEErtekinC, et al.
Experimental investigation of three different solar air heaters: energy and exergy analyses. Appl Energy2010;
87: 2953–2973.
16.
OzgenFEsenMEsenH.Experimental investigation of thermal performance of a double-flow solar air heater having aluminium cans. Renew Energy2009;
34: 2391–2398.
17.
BenliH.Experimentally derived efficiency and exergy analysis of a new solar air heater having different surface shapes. Renew Energy2013;
50: 58–67.
18.
EsenHInalliMEsenM, et al.
Energy and exergy analysis of a ground-coupled heat pump system with two horizontal ground heat exchangers. Build Environ2007;
42: 3606–3615.
19.
EsenHEsenMOzsolakO.Modelling and experimental performance analysis of solar-assisted ground source heat pump system. J Exp Theor Artif Intell2017;
29: 1–7.
20.
HazamiMKooliSLazâarM, et al.
Energetic and exergetic performances of an economical and available integrated solar storage collector based on concrete matrix. Energy Convers Manag2010;
51: 1210–1218.
21.
EsenM.Thermal performance of a solar cooker integrated vacuum-tube collector with heat pipes containing different refrigerants. Solar Energy2004;
76: 751–757.
22.
EsenMEsenH.Experimental investigation of a two-phase closed thermosyphon solar water heater. Solar Energy2005;
79: 459–468.
23.
EsenMYukselT.Experimental evaluation of using various renewable energy sources for heating a greenhouse. Energy Build2013;
65: 340–351.
24.
KabirKMAAlamKCASarkerMMA, et al.
Effect of mass recovery on the performance of solar adsorption cooling system. Energy Proc2015;
79: 67–72.
25.
AmerOBoukhanoufRIbrahimHG, The University of Nottingham, Department of Built Environment, Nottingham, UK –a review of evaporative cooling technologies. Int J Environ Sci Dev2015;
6: 111–117.
26.
IbrahimTKRahmanMMAbdallaAN.Improvement of gas turbine performance based on inlet air cooling systems: a technical review. Int J Phys Sci2011;
6: 620–627.
27.
ZaidanMHKhalafHJBaA.Thermal analysis of a solar absorption cooling system with hot and cold storage tanks. J Adv Res Fluid Mech Therm Sci2018;
50: 67–80.
28.
SunJFuLZhangS.A review of working fluids of absorption cycles. Renew Sustain Energy Rev2012;
16: 1899–1906.
29.
MittalVKasanaKSThakurNS.Performance evaluation of solar absorption cooling system of bahal (Haryana). J Indian Inst Sci2005;
85: 295.
30.
OchoaAADutraJCHenríquezJR.Energy and exergy analysis of the performance of 10 TR lithium bromide/water absorption chiller. Revista técnica de la facultad deIngeniería2014;
37: 38–47.
31.
RenJQianZYaoZ, et al.
Thermodynamic evaluation of LiCl-H2O and LiBr-H2O absorption refrigeration systems based on a novel model and algorithm. Energies2019;
12: 3037.
32.
MansooriGAPatelV.Thermodynamic basis for the choice of working fluids for solar absorption cooling systems. Solar Energy1979;
22: 483–491.
33.
ChengFWuYLiX.Research on regeneration performance of the solar steam method for absorption air-conditioning system. Appl Therm Eng2020;
178: 115576.
34.
KetfiOMerzoukMMerzoukNK, et al.
Performance of a single effect solar absorption cooling system (Libr-H2O). Energy Proc2015;
74: 130–138.
35.
GommedKGrossmanG.Performance analysis of staged absorption heat pumps: water-lithium bromide systems. American Society of Heating, Refrigerating and Air-Conditioning Engineers,
AT-90-30-6, 1990.
36.
KaushikSCAroraA.Energy and exergy analysis of single effect and series flow double effect water–lithium bromide absorption refrigeration systems. Int J Refrig2009;
32: 1247–1258.
37.
AnandDKKumarB.Absorption machine irreversibility using new entropy calculations. Solar Energy1987;
39: 243–256.
38.
AssilzadehFKalogirouSAAliY, et al.
Simulation and optimization of a LiBr solar absorption cooling system with evacuated tube collectors. Renew Energy2005;
30: 1143–1159.
39.
SongMWangLYuanJ, et al.
Proposal and parametric study of solar absorption/dual compression hybrid refrigeration system for temperature and humidity independent control application. Energy Convers Manag2020;
220: 113107.
40.
KunduB.Performance analysis and optimization of absorber plates of different geometry for a flat-plate solar collector: a comparative study. Appl Therm Eng2002;
22: 999–1012.
41.
KovarikM.Optimal distribution of heat conducting material in the finned pipe solar energy collector. Solar Energy1978;
21: 477–484.
42.
TzivanidisCBellosE.The use of parabolic trough collectors for solar cooling–a case study for Athens climate. Case Studies Therm Eng2016;
8: 403–413.
43.
KunduB.Performance and optimum design analysis of an absorber plate fin using recto-trapezoidal profile. Solar Energy2008;
82: 22–32.
44.
KunduB.The influence of collector fluid inlet temperature on the performance of a solar-assisted absorption system using step-finned flat-plate collector. Heat Transfer Eng2007;
28: 496–505.
45.
RoyRKunduB.Optimum design analysis of a solar-assisted LiBr/H2O absorption system with a flat-plate collector. J Therm Eng2020; in press.
46.
KunduBMondalPKDattaSP, et al.
Operating design conditions of a solar-powered vapor absorption cooling system with an absorber plate having different profiles: an analytical study. Int Commun Heat Mass Transf2010;
37: 1238–1245.
47.
FloridesGAKalogirouSATassouSA, et al.
Design and construction of a LiBr–water absorption machine. Energy Convers Manag2003;
44: 2483–2508.
48.
ASHRAE.Handbook of fundamentals. Atlanta: ASHRAE, 1997.
49.
DuffieJABeckmanWA.Solar engineering of the thermal process.
New York:
John Wiley, 2013.
50.
HollandsKGStedmanBA.Optimization of an absorber plate fin having a step-change in local thickness. Solar Energy1992;
49: 493–495.
51.
KernDQKrausAD.Extended surface heat transfer.
New York:
McGraw-Hill, 1972.
52.
PetelaR.Exergy of undiluted thermal radiation. Solar Energy2003;
74: 469–488.
53.
PetelaR.Exergy of heat radiation. J Heat Transf1964;
86: 187–192.
54.
NajianMR.Exergy analysis of flat plate solar collector. MS Thesis.
Department of Mechanical Engineering, College of Engineering, Tehran University,
Tehran, Iran, 2000.
55.
Torres-ReyesECervantes-de GortariJGIbarra-SalazarBA, et al.
A design method of flat-plate solar collectors based on minimum entropy generation. Exergy Int J2001;
1: 46–52.
56.
JafarkazemiFAhmadifardE.Energetic and exergetic evaluation of flat plate solar collectors. Renew Energy2013;
56: 55–63.
