Abstract
An injectable chelate-setting hydroxyapatite cement (IP6-HAp), formed by chelate-bonding capability of inositol phosphate (IP6), was developed. The effects of ball-milling duration of starting HAp powder and IP6 concentration on the material properties such as injectability and mechanical strength of the cement were examined. The cement powder was prepared by ball-milling the as-synthesized HAp powder for 5 min using ZrO2 beads with a diameter of 10 mm, followed by another 60 min with ZrO2 beads with a diameter of 2 mm, and thereafter surface-modified with 5000 ppm of IP6 solution. Injectable cement was then fabricated with this HAp powder and 2.5 mass% chitosan as a mixing solution, with a setting time of 36.3 ± 4.7 min and a compressive strength of 19.0 ± 2.1 MPa. The IP6-HAp cements prepared with chitosan showed favorable biocompatibility
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
