Abstract
The response of biomaterial surfaces when exposed to blood is in part dependent upon the nature and composition of the adsorbed layer of proteins. Surfaces passivated with albumin have been shown to reduce platelet adhesion and activation. In an attempt to develop surfaces that can selectively and specifically bind albumin, silicon-based surfaces were functionalized with linear peptides and chemical ligands that displayed an affinity for albumin. Peptide functionalized surfaces were observed to preferentially bind albumin when compared to human immunoglobulin and human fibrinogen, which possess low densities of surface adsorbed platelets. The platelet morphology was noted to be discoid on the peptide modified surface. Both the unmodified control and SCL functionalized surfaces had high densities of surface adhered platelets with spread out morphology. The peptide and SCL functionalized surfaces were noted to have no impact on PTT and PT clotting times, indicating that the extrinsic and intrinsic pathways were unperturbed by the surfaces generated.
Keywords
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
