Six species of wood samples, namely, pine, beech, cherry, oak, maple, and ash, were investigated by autoignition in a cone calorimeter to identify the influence of moisture on autoignition. It was observed that (1) for autoignition, as different from piloted ignition, there is no obvious trend in ignition temperature when moisture content increases from 0% to 11%; (2) ignition temperature decreases with a higher external heat flux, and the influence of specimen thickness to the ignition temperature can be ignored; (3) ignition time correlates linearly with , and the coefficient rises with the increase of moisture content; and (4) the influence of moisture to the average mass loss rate and time at 50% mass loss can be ignored if the moisture content of wood sample is lower than 11%.
LiXRKosekiHMomotaM. Evaluation of danger from fermentation-induced spontaneous ignition of wood chips. J Hazard Mater2006; 135(1–3): 15–20.
2.
ConsalviJLNmiraFFuentesA. Numerical study of piloted ignition of forest fuel layer. Proc Combust Inst2011; 33(2): 2641–2648.
3.
LucheJRogaumeTRichardF. Characterization of thermal properties and analysis of combustion behavior of PMMA in a cone calorimeter. Fire Saf J2011; 46(7): 451–461.
4.
MindykowskiPFuentesAConsalviJL. Piloted ignition of wildland fuels. Fire Saf J2011; 46(1–2): 34–40.
5.
TahsiniAM. Piloted ignition of solid fuels in turbulent back-step flows. Aerosp Sci Technol2011. DOI: 10.1016/j.ast.2011.03.00810.1016/j.ast.2011.03.008.
6.
McAllisterSFernandez-PelloCUrbanD. The combined effect of pressure and oxygen concentration on piloted ignition of a solid combustible. Combust Flame2010; 157(9): 1753–1759.
7.
FereresSLautenbergerCFernandez-PelloC. Mass flux at ignition in reduced pressure environments. Combust Flame2011; 158(7): 1301–1306.
8.
DelichatsiosMAPanagiotouTHKileyF. The use of time to ignition data for characterizing the thermal inertia and the minimum (critical) heat flux for ignition or pyrolysis. Combust Flame1991; 84(3–4): 323–332.
9.
AtreyaAAbu-ZaidM. Effect of environmental variables on piloted ignition. In: The third international symposium on fire safety science, 8-12 July, 1991, pp.177–186. Scotland: University of Edinburgh.
10.
MoghtaderiBNovozhilovVFletcherDF. A new correlation for bench-scale piloted ignition data for wood. Fire Saf J1997; 29(1): 41–59.
11.
SimmsDLLawM. The ignition of wet and dry wood by radiation. Combust Flame1967; 11(5): 377–388.
12.
MitchellP. Methods of moisture content measurement in the lumber and furniture industries, http://www.ces.ncsu.edu/ (accessed 30 August 2011).
13.
Fire Testing Technology Limited. User’s guide for the cone calorimeter. Fire Testing Technology Limited, West Sussex, UK, 2001.
MehaffeyJ. Fire dynamics I: ignition and burning of solids. Lecture notes, Carleton University, Ottawa, Ontario, 2002.
16.
GratkowskiMTDembseyNABeylerCL. Radiant smoldering ignition of plywood. Fire Saf J2006; 41(6): 427–443.
17.
BoonmeeNQiuntiereJG. Glowing and flaming autoignition of wood. Proc Combust Inst2002; 29(1): 289–296.
18.
BoonmeeNQiuntiereJG. Glowing ignition of wood: the onset of surface combustion. Proceedings of the Combustion Institute2005; 30(2): 2303–2310.
19.
BabrauskasV. Ignition handbook: principles and applications to fire safety engineering, fire investigation, risk management and forensic science. Issaquah: Fire Science Publishers, 2003.
20.
DimitrakopoulosAPSamaraEAMitsopoulosID. Regression models of ignition time versus moisture content for the litter of Mediterranean forest species. For Ecol Manage2006; 234: S123.
21.
LuoJWYingKBaiJ. Savitzky-Golay smoothing and differentiation filter for even number data. Signal Process2005; 85(7): 1429–1434.
22.
ShiLChewMYL. (Forthcoming) Experimental study of woods under external heat flux by spontaneous ignition—Part I: ignition time and mass loss rate. Fuel.
23.
LeeCJDiehlJR. Combustion of irradiated dry and wet oak. Combust Flame1981; 42: 123–138.
24.
SaitoMAmagaiKOgiwaraG. Combustion characteristics of waste material containing high moisture. Fuel2001; 80(9): 1201–1209.
