The Effect of Moisture On Air Classification of Municipal Solid Waste

Abstract

The effect of moisture on the air classification of municipal solid waste (MSW) is analysed using a 2³ factorial design. A synthetic MSW is used in the laboratory to facilitate controlled variation of composition and moisture content. A pilot scale 120° zig-zag air classifier is used to perform the classification tests. Ten system response variables are evaluated including six recoveries, two purities and two efficiencies, to elucidate the impacts of (1) increased particle density resulting from moisture absorption and (2) particle adhesion. Results indicate a significant decrease in paper recovery and efficiency with increasing moisture. However, no significant reduction in aluminum and iron recovery is observed. This suggests that adhesion of these particles to extracted combustible materials is not a significant factor in reducing extract purity. Instead, extract purity reduction is a result of paper recovery losses from increasing particle density. The degree of moisture effect for varied MSW composition is greater for feeds with lower fractions of adsorbent materials. A redefination of percent moisture based on the MSW absorbent fraction is suggested in order to account for this varied impact. The new definition, moisture absorbancy ratio, is the weight of the moisture in the MSW divided by the dry weight of the absorbent materials in the MSW.

Keywords

Municipal solid waste moisture content air classification resource recovery moisture absorbancy ratio.

Get full access to this article

View all access options for this article.

References

ASTM Committee E-29 on Particle Size Measurement (1972), Manual on Test Sieving Methods, Philadelphia, ASTM technical publication, AA7A.

Bartlett, J. (1983), The Effect of Moisture on Air Classification of Municipal Solid Waste, M. S. Thesis, Department of Civil and Environmental Engineering, Duke University.

Bartlett, J. (1981), Effect of Moisture on Air Classification of a Synthetic MSW, Unpublished report, Center for Environmental Engineering, Duke University, Durham, N.C.

Bond, R.G. & Straub, C.P. (1973), Handbook on Environmental Control, Volume II, Solid Waste, CRC Press, Cleveland Ohio.

Box, G. ( 1978), Statistics for Experimenters, Wiley Pub. Co., New York, N.W.

Lawler, S.P. (1977), A Statistical Analysis of the Chemung County Americology Air Classifier, unpublished report, Americology Division, American Can Company, Greenwich Connecticut, (courtesy of Floyd Hasselriis, P.E., New York, N.Y.).

Ower, E. & Pankhurst, R.C. (1977), The Measurement of Air Flow, Pergamon Press, Oxford.

Saul, C.S. (1981), Air Classification of Glass Particles, M. S. Thesis , Department of Civil and Environmental Engineering, Duke University, Durham, N.C.

Stessel, R.I. (1982), Pulsed Flow Air Classification, M. S. Thesis, Department of Civil & Environmental Engineering, Duke University, Durham, N.C.

10.

Trezek, G.J. & Savage, G.M. (1977), Significance of Size Reduction in Solid Waste Management, EPA-600/2-77-131, U.S. Environmental Protection Agency, Cinncinati, Ohio.

11.

Vesilind, P.A. & Rimer, A. (1977), Unit Operations in Resource Recovery Engineering , Prentice-Hall, Englewood Cliffs, N.J.