Preliminary results of an investigation into the possible use of glass-ceramic frits from fly ash and glass cullet in terracotta (stoneware) tile manufacture are reported. Two new ceramics were studied and compared with a plant composition, containing 45 wt.% sodium feldspar. In the first ceramic batch 20% of the feldspar was substituted by frits and in the second the whole amount of feldspar was eliminated and replaced by 35% frits and 10% refractory waste. It was found that the addition of low viscous glass-ceramic frits decreased the sintering temperature by 50—100 °C. At the same time, due to formation of an additional crystal phase (i.e. pyroxene or anorthite) the new ceramics showed an improvement of 25—50% in bending strength.
Abadir, M.F., Sallam, E.H. & Bakr, I.M. (2002) Preparation of porcelain tiles from Egyptian raw materials. Ceramics International, 28, 303- 310.
2.
Andreola, F., Barbieri, L., Corradi, A., Lancellotti, I. & Manfredini, T. (2002) Utilisation of municipal incinerator grate slag for manufacturing of porcelainized stoneware tiles manufacturing. Journal of the European Ceramic Society, 22, 1457-1462.
3.
Andreola, F., Barbieri, L., Karamanova, E., Lancellotti, I. & Pelino, M. (2008) Recycling of CRT panel glass as fluxing agent in the porcelain stoneware tile production. Ceramics International , 34: 1289- 1295.
4.
Barbieri, L., Corradi, A., Lancellotti, I. & Manfredini, T. (2002) Use of municipal incinerator bottom ash as sintering promoter in industrial ceramics. Waste Management, 22, 859-863.
5.
Bragança, S.R., Licenzi, J., Guerino, K. & Bergmann, C.P. (2006) Recycling of iron foundry sand and glass waste as raw material for production of whiteware. Waste Management & Research, 24, 60-66.
6.
Carbonchi, G., Dondi, M., Morandi, N. & Tateo, F. (1999) Possible use of altered volcanic ash in ceramic tile production. Industrial Ceramics, 19, 67-74.
7.
Dana, K. & Das, S.K. (2004) Partial substitution of feldspar by B.F. slag in triaxial porcelain: Phase and microstructural evolution. Journal of the European Ceramic Society, 24, 3833-3839.
8.
Ergul, S., Akyildiz, M. & Karamanov, A. (2007) Ceramic material from basaltic tuffs. Industrial Ceramics, 37: 75-80.
9.
Gennaro, R., Cappelletti, P., Cerri, G., Gennaro, M., Dondi, M., Guarini, G., Langella, A. & Naimo D. (2003) Influence of zeolites on the sintering and technological properties of porcelain stoneware tiles. Journal of the European Ceramic Society, 23, 2237-2245.
10.
Hlavac, J. (1983) The Technology of Glass and Ceramics: an Introduction . Elsevier, Amsterdam.
11.
Karamanov, A., Pelino, M. & Gutzow, I. (1998) Sintered building glass-ceramics based on industrial wastes. In: Proc of 18th International Congress on Glass, San Francisco, California , USA. The American Ceramic Society (CD), Westerville, Ohio, USA.
12.
Karamanov, A., Taglieri, G. & Pelino, M. (1999) Iron-rich sintered glass-ceramics from industrial wastes. Journal of the American Ceramics Society, 82, 3012-3016.
13.
Karamanov, A., Pelino, M., Ferraris, M. & Metecovitz, I. (2003) Sintered glass-ceramics from MSW-incinerator fly ashes, Part II: The influence of the particle size and heat-treatment on the properties. Journal of the European Ceramic Society, 23, 1609-1615.
14.
Karamanov, A., Karamanova, E., Ferrari, A.M., Ferrante, F. & Pelino, M. (2006) The effect of scrap addition on the sintering behavior of hard porcelain. Ceramics International, 32, 727-732.
15.
Karamanova, E., Andreola, F., Lancelloti, I., Barbieri, L. & Karamanov, A. (2007) Recycling of CRT waste glass in porcelain stoneware production. In: Proc. of 7th International SGEM Conference `Modern Management of Mine Producing, Geology and Environmental Protection', June 2007, Albena, Bulgaria (CD), SGEM-Society, Sofia, Bulgaria.
16.
Kingery, W.D., Bowen, H.K. & Uhlmann, D.R. (1976) Introduction to Ceramics, John Wiley & Sons, New York.
17.
Kurama, S., Kara, A. & Kurama, H. (2006) The effect of boron waste in phase and microstructural development of a terracotta body during firing. Journal of the European Ceramic Society, 26, 755-760.
18.
Matteucci, F., Dondi, M. & Guarini, G. (2002) Effect of soda-lime glass on sintering and technological properties of porcelain stoneware tiles. Ceramics International , 28, 873-880.
19.
Pisciella, P., Crisucci, S., Karamanov, A. & Pelino, M. (2001) Chemical durability of glasses obtained by vitrification of industrial wastes. Waste Management, 21, 1-9.
20.
Raimondo, M., Zanelli, C., Matteucci, F., Guarini, G., Dondi, M. & Labrincha, J.A. (2007) Effect of waste glass (TV/PC cathodic tube and screen) on technological properties and sintering behaviour of porcelain stoneware tiles. Ceramics International, 33, 615-621.
21.
Rawlings, R.D. (1997) Production and Properties of Silceram Glass-Ceramic: in Glass-Ceramic Materials-Fundamentals and Applications, Series of Monographs on Material Science, Engineering and Technology, pp. 115-133. Mucchi Editore. Modena, Italy.
22.
Rawlings, R.D., Wu, J.P. & Boccaccini, A.R. (2006) Glass-ceramics: Their production from wastes - a review. Journal of Materials Science, 41, 733-761.
23.
Scholze, H. (1990) Glass Nature, Structure and Properties. Springer-Verlag, Berlin.
24.
Siligardi, C., D'Arrigo, M.C. & Leonelli, C. (2000) Sintering behaviour of glass-ceramic frits. American Ceramic Society Bulletin, 79, 23-29.
25.
Torres, P., Fernandes, H.R., Agathopoulos, S., Tulyaganov, D.U. & Ferreira, J.M.F. (2004) Incorporation of granite cutting sludge in industrial porcelain tile formulations. Journal of the European Ceramic Society, 24, 3177-3185.
26.
Tucci, A., Esposito, L., Rastelli, E., Palmonari, C. & Rambaldi, E. (2004) Use of soda-lime scrap-glass as a fluxing agent in a porcelain stoneware tile mix. Journal of the European Ceramic Society, 24, 83-92.
27.
Zanelli, C., Baldi, G., Dondi, M., Ercolani, G., Guarini, G. & Raimondo, M. (2008) Glass ceramic frits for porcelain stoneware bodies: effects on sintering, phase composition and technological properties. Ceramics International, 34: 455-465.
