Moisture and Temperature Induced Degradation in Tensile Properties of Kevlar-Graphite/Epoxy Hybrid Composites

Abstract

This paper presents results of a comparative study of the effects of mois ture and temperature on tensile properties of Kevlar 49/epoxy, graphite/epoxy, single fiber and Kevlar 49-graphite/epoxy hybrid composites. The work reported here shows varia tions in tensile strength, elastic modulus and Poisson's ratio with changes in the hygrother mal conditions. A temperature range of 23°C to 150°C was considered for both dry and wet specimens exposed to moisture for 200 days. Moisture was introduced into the speci men by immersion in distilled water. Effects of the kind of outer fiber of the same hybrid system was also studied for better understanding of the behavior of hybrid composites. Variation in the tensile modulus determined by various test methods is also reported.

The results indicate that moisture and temperature degrade the tensile strength of hybrid and single fiber composites. The tensile modulus of Kevlar 49-graphite/epoxy is compara tively higher than that of Kevlar 49/epoxy. The degradation of the tensile modulus is mostly temperature dependent. The presence of moisture either increases or decreases the tensile modulus depending upon the laminate and exposure conditions. Poisson's ratio in general appears to increase with temperature. In the presence of moisture the Poisson's ratio further increases between the temperatures of 45°C to 150°C.

Get full access to this article

View all access options for this article.

References

Riewald, P.G. and C. Zweben

"Kevlar 49 Hybrid Composites for Commercial and Aerospace Applications,"

presented at the 30th Annual Conference of Reinforced Plastics/Composite Institute, February 6, 1975 .

Zweben, C. 1975. "Hybrid Fiber Composite Materials," in Proceedings—1975 International Conference on Composite Materials .

Lubin, G., ed 1982 Handbook of Composites.

New York

Van Nostrand Reinhold Company , p 256

Guerini, E. and P. Lissae 1978

"Contribution to the Study of Hybrid Laminates Fabricated from Graphite, Kevlar 49 and Glass,"

Verre Text. Plast Reinf. (July-August).5-16.

Fogg, L.D. "Hybrid Composite Design for Damage Tolerance," 2nd Conference on Fibrous Composites in Flight Vehicle Design , Dayton, Ohio, May, 1974 .

Hadcock, R.N. "The Application of Mixed Fiber Composites to Military Aircraft," 10th National State of the Art Symposium, Washington, D.C. , Division of Industrial and Engineering Chemistry Society, June 1974

Shen, C.H. and G.S. Springer 1977. "Effects of Moisture and Temperature on Tensile Strength of Composite Materials," J. Comp. Mats ., 11:2-16

Garg, A.C.

"Hygrothermal Influence on Fracture Behavior of Graphite/Epoxy Laminates"

presented at ASME Annual Winter Meeting, November , 1985

Browning, C.E. G.E. Hushman and J.M. Whitney 1977. "Moisture Effects in Epoxy Matrix Composites," Composite Materials: Testing and Design, ASTM-STP, 617 481-496

10.

Vinson, J R., ed 1978. "Advanced Composite Materials—Environmental Effects," ASTM-STP, 658.

11.

Allred, R.E. 1981. "The Effect of Temperature and Moisture Content on Flexural Response of Kevlar/Epoxy Laminates Part I and Part II," J. Comp Mats. , 15·100 .

12.

Whiteside, J. "Environmental Sensitivity of Advanced Composites," AFFDL Contract F 35615-76-C-5324 , presented at AF Mechanics of Composite Review , Dayton, Ohio , Oct. , 1977.

13.

Chamis, C.C. and R.F. Lark. "Hybrid Composites: State-of-the-Art Review: Analysis, Design, Application and Fabrication," NASA TM X-73545.

14.

Haque, A et al 1990. "Hygrothermal Influence on Flexural Properties of Kevlar-Graphite/ Epoxy Hybrid Composites," J Reinforced Plastics and Composites, 9.602-613

15.

Haque, A. et al 1990. "Hygrothermal Influence on the Interlaminar Shear Strength of Kevlar-Graphite/Epoxy Hybrid Composites," J. Mat. Science, 25:4639-4643.

16.

Gopalan, R. R M V G Rao, et al. "Diffusion Studies on Advanced Fiber Hybrid Composites," in Environmental Effects on Composite Materials , Vol. 3. G. S. Springer, ed Lancaster, PA Technomic Publishing Co., pp. 96-106

17.

Tsai, S.W. 1967. "Environmental Factors in the Design of Composite Materials" 5th Symp. Naval Structural Mechanics New York · Pergamon

18.

Springer, G S., ed "Model for Predicting the Mechanical Properties of Composites at Elevated Temperatures," in Environmental Effects on Composite Materials, pp. 151-161

19.

Pering, G.A. , P.V. Farrell and G.S. Springer 1980 "Degradation of Tensile and Shear Properties of Composites Exposed to Fire or High Temperature," J. Comp Mats. , 14 54