Abstract
Composite industry increasingly uses natural fibres because of their environment-friendly advantages. These natural fibres may swell during the mould filling process when they absorb resin, and this swelling reduces the porosity and permeability of the preform. Hence, computational modelling of the flow in swelling porous media would be useful to model the different mould filling processes with the swelling effect. This paper demonstrates the possibility of using computational fluid dynamics to study the effect of swelling on liquid composite moulding mould filling in isotropic and orthotropic porous media. An empirical relation for local permeability changes is used to model the flow of resin under constant volume flow rate and constant injection pressure conditions. The flow front locations and inlet pressure predicted by the computational fluid dynamics simulations are in good agreement with the experimental data for 1D rectilinear flow case. Further, to capture the flow patterns, two different arrangements employing point injection are considered. It was observed that the volume fraction of resin in swelling porous medium is 6% less than rigid porous medium at any given time. It was also observed that the location of the inlet and outlet has a considerable effect on the flow front advancement.
Keywords
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
