Modal testing of epoxy carbon–aramid fiber hybrid composites reinforced with silica nanoparticles

Abstract

In the current paper, the modal characterisation of aramid–carbon fiber hybrid composites (ACFRP) and ACFRP reinforced with silica nanoparticles (nACFRP) is investigated through the analytical-experimental transfer function method. The modal properties, such as resonant frequencies and modal loss factors, are measured by vibrating cantilever beam specimens with an impact hammer, while the vibratory response is detected through an acceleration transducer. The procedure for the identification of analytical-experimental transfer functions is carried out using a genetic algorithm by minimising the difference between the measured response from tests and the calculated response, which is a function of the modal parameters. The analytical transfer functions provide a substructuring process to identify modes, as a function of damped natural frequencies and loss factors of a complex structure, and it is insensitive to experimental noise as well as the modal coupling effect. The validation of the proposed method is verified with 10 degrees of freedom mass-spring dashpot model. The effectiveness of the proposed method is demonstrated by investigating the static and dynamic behaviour of the ACFRP and nACFRP specimens. Results indicate that the inclusion of nanosilica particles increase the stiffness of the ACFRP, although the damping response of the reinforced specimens is moderately improved.

Keywords

Epoxy resin nanosilica carbon-aramid fibres modal testing nondestructive testing genetic algorithm

Get full access to this article

View all access options for this article.

References

Berketis

Tzetzis

Hogg

. The influence of long term water immersion ageing on impact damage behaviour and residual compression strength οf GFRP. Mater Des J 2008; 29: 1300–1310.

Berketis

Tzetzis

Chap. 27: Impact damage behaviour of composite materials after long-term exposure to a hydrothermal environment. In: Lechkov

Prandzheva

(eds). Encyclopaedia of polymer composites, New York: Nova Science Publishers, USA, 2009, pp. 913–932.

Berketis

Tzetzis

Review on the Water Immersion and Impact Damage Effects on the Residual Compressive Strength of Composites. In: Song

(ed). Resin composites: Properties, production and applications, New York: Nova Science Publishers, 2011, pp. 1–53.

Berketis

Tzetzis

Hogg

. Impact damage detection and degradation monitoring of wet GFRP composites using noncontact ultrasonics. Polym Compos 2009; 30: 1043–1049.

Berketis

Tzetzis

. The compression after impact strength of woven and non-crimp composites subjected to long term water immersion. J Mater Sci 2010; 45: 5611–5623.

Lavoie

Morton

Jackson

. An evaluation of the energy absorption of laminated composite plates. J Aerospace Eng 1995; 209: 185–194.

Farley

. Energy absorption of composite materials. J Compos Mater 1983; 17: 267–279.

Subramaniyan

Sun

. Enhancing compressive strength of unidirectional polymeric composites using nanoclay. Compos A 2006; 37: 2257–2257.

Iwahori

Ishiwata

Sumizawa

. Mechanical properties improvements in two-phase and three-phase composites using carbon nano-fiber dispersed resin. Compos A 2005; 36: 1430–1430.

10.

Cho

Chen

Daniel

. Mechanical enhancement of carbon fiber/epoxy composites by graphite nanoplatelet reinforcement. Scripta Mater 2007; 56: 685–685.

11.

Biggerstaff

Kosmatka

. Damping performance of cocured graphite/epoxy composite laminates with embedded damping materials. J Compos Mater 1999; 33: 1457–1469.

12.

Liao

Wang

. On the analysis of viscoelastic materials for active constrained layer damping treatments. J Sound Vib 1997; 207: 319–334.

13.

Liu

Wang

. A non-dimensional parametric study of enhanced active constrained layer damping treatments. J Sound Vib 1999; 223: 611–644.

14.

Mansour

Tzetzis

Bouzakis

. A nanomechanical approach on the measurement of the elastic properties of epoxy reinforced carbon nanotube nanocomposites. Tribol In Ind 2013; 35: 190–199.

15.

Tzetzis

Mansour

Tsiafis

. Nanoindentation measurements of fumed silica epoxy reinforced nanocomposites. J Reinforc Plast Compos 2013; 32: 160–173.

16.

Mansour

Tzetzis

. Nanomechanical characterization of hybrid multiwall carbon nanotube and fumed silica epoxy nanocomposites. Polym Plast Technol Eng 2013; 52: 1054–1062.

17.

Sprenger

Kinloch

Taylor

. Rubber-toughened GFRCs optimised by nanoparticles. J Eur Coat 2005; 21: 66–66.

18.

Kinloch

Mohammed

Taylor

. The interlaminar toughness of carbon-fibre reinforced plastic composites using ‘hybrid toughened’ matrices. J Mater Sci Lett 2006; 41: 5043–5046.

19.

Sprenger

Kinloch

Taylor

. Rubber-toughened CFRCs optimised by nanoparticles – part III. J Eur Coat 2007; 30: 54–57.

20.

Zhang

Friedrich

. Property improvements of an in situ epoxy nanocomposites with reduced interparticle distance at high nanosilica content. Acta Mater 2006; 54: 1833–1842.

21.

Zhang

Liu

. Study on the friction and wear properties of glass fabric composites filled with nano- and micro-particles under different conditions. Mater Sci Eng A Struct 2005; 392: 359–365.

22.

Zhang

Wang

. Friction and wear properties of carbon fabric composites filled with nano-Al2O3 and nano-Si3N4. Compos A – Appl 2006; 37: 1351–1357.

23.

Zheng

Ning

Zheng

. Study of SiO2 nanoparticles on the improved performance of epoxy and fiber composites. J Reinf Plast Compos 2005; 24: 223–223.

24.

Rodgers

Mahfuz

Rangari

. Infusion of SiC nanoparticles into SC-15 epoxy: an investigation of thermal and mechanical response. Macromol Mater Eng 2005; 290: 423–429.

25.

Choi

Y-K

Sugimoto

Song

. Mechanical and physical properties of epoxy composites reinforced by vapor grown carbon nanofibers. Carbon 2005; 43: 2199–2208.

26.

Kennedy

Pancu

CDP

. Use of vectors in vibration measurement and analysis. J Aeronaut Sci 1947; 14: 603–625.

27.

Brown DL, Allemang RJ, Zimmerman R, et al. Parameter estimation techniques for modal analysis. SAE Paper No. 790221, 1979.

28.

Broch JT. Mechanical vibration and shock measurements. Naerum: Bruel & Kjaer, 1984, pp.97–112.

29.

Coley D. An introduction to genetic algorithms for scientists and engineers. Singapore: World Scientific Press, 1999.

30.

Jumahat

Soutis

Jones

. Effect of silica nanoparticles on compressive properties of an epoxy polymer. J Mater Sci 2010; 45: 5973–5983.

31.

Sprenger

. Improving mechanical properties of fiber-reinforced composites based on epoxy resins containing industrial surface-modified silica nanoparticles: review and outlook. J Compos Mater 2015; 49: 53–63.