Study on Bentonite-Unsaturated Polyester Composite Materials

Abstract

Jordanian Ca-bentonite was used in formulation of unsaturated polyester-based composite materials. For curing purpose, methyl ethyl ketone peroxide was used as an initiator and it was accelerated with cobalt octoate to maximize the curing process at room temperature. The effect of filler and styrene contents on the physical properties of composites was assessed by measuring the compressive strength, hardness, thermal conductivity, water absorption capacity, and apparent density. Increasing the filler content, at a constant styrene/polyester ratio, increased the properties of composites. On other hand, maximum values of compressive strength, hardness, and thermal conductivity of composites were found at about 22.7 wt% of styrene, whereas water absorption capacity was minimum at a styrene content of 32.8 wt%. Nevertheless, the apparent density was found to linearly decrease with styrene content.

Get full access to this article

View all access options for this article.

References

1. Saroja, D.V. , Murugesan, K.R. and Anand, P. (1998). Journal of Applied Polymer Science, 69: 1385-1391.

2. Ruffier, M. , Prodemat, S.A. , Merle, G. and Pascault, J.P. (1993). Polymer Engineering and Science, 33: 466-473.

3. Lucas, J.C. , Borrajo, J. and Williams, R.J.J. (1993). Polymer, 34: 1886-1890.

4. Katz, H.S. and Milewiski, J.V. (1978). Hand Book of Fillers and Reinforcements for Plastics. New York: Van Nostrand Reinhold.

5. Al-Alali, J. (1996). Bentonite in Jordan. Amman, Jordan: Natural Resources Authority.

6. Rothon, R.N. (1999). Mineral fillers in thermoplastics: filler manufacture and characterization. In: Jancar, J. (ed.), Advances in Polymer Science. Berlin: Springer. pp. 69-107.

7. Ismail, M.R. , Ali, M.A.M. , El-Milligy, A.A. and Afifi, M.S. (1999). Journal of Applied Polymer Science, 72: 1031-1038.

8. Jokiel, M. , Kachlicki, B. , Rozycki, J. and Spychala, A. (1982). Some strength bearing properties of polyester-concrete. In: Bares, R.A. (ed.), Plastic in Material and Structural Engineering. Amsterdam: Elsevier.

9. Harper, C.A. (1975). Hand Book of Plastics and Elastomers. New York: Mcgraw-Hill.

10.

10. Billmeyer, F.W. (1984). Textbook of Polymer Science. 3rd Edn. New York: John Wiley.

11.

11. Wordingham, J.A. and Reboul, P. (1968). Dictionary of Plastics. 3rd Edn. England: Newnes Middlesex.

12.

12. Han, chang dae . (1984). Polymer and Composites in Multiphase Systems. Washington: American Chemical Society.

13.

13. Wilson, J.E. (1974). Radiation Chemistry of Monomers, Polymers and Plastics. New York: Marcel-Dekker, Inc.

14.

14. Urabe, H. , Nomura, Y. , Shirai, K. , Yoshioka, M. and Shintani, H. (1999). J. Mater. Sci.: Mater. Med., 10: 375-478.