A Study of Flexural Behavior of Reinforced Concrete Beam Strengthened with Carbon Fiber-Reinforced Plastic (CFRP)

Abstract

This paper presents an analytical study on the flexural behavior of reinforced concrete beams strengthened with externally bonded carbon fiber-reinforced plastic (CFRP) laminates. Different failure modes of these strengthened reinforced beams have been reported and these failure modes are generally referred to as brittle failure or ductile failure involving the compression crushing of the concrete, debonding or rupture of the composite laminate and yielding of the steel reinforcement. For the analysis, the stresses and strains of all the components of the beam are related by the material properties, including the stress-strain curves for the concrete, steel and CFRP laminate. The strain distribution is assumed to be compatible within the distorted shape of the cross-section of the concrete beam. The resultant forces on the cross section are balanced with the applied loads for static equilibrium. The analytical solution is derived from the equilibrium equations and the compatibility of the strains, and it is applicable to both singly and doubly reinforced concrete beams strengthened with multi-layers of CFRP laminates. In this study, a simple and direct analytical procedure has been developed to evaluate the flexural capacity of concrete beams strengthened with CFRP and to predict their failure modes. An example is presented to illustrate the computational procedures. For design purposes, the upper and lower limits of CFRP cross-section areas are established to ensure that reinforced concrete beam strengthened with advanced composite materials will fail in a ductile manner. A comparison between the analytical results and the data obtained from the literature has been made and the agreement is very good.

Keywords

carbon fiber reinforced plastic strengthening analysis reinforced concrete

Get full access to this article

View all access options for this article.

References

1. Saadatmanesh, H. and Ehsani, M. R. (1991). “RC beams strengthened with GFRP plates. I: Experimental study.” J. of Struct. Engrg., ASCE, 117(11), 3417-3433.

2. An, W. , Saadatmanesh, H. and Ehsani, M. R. (1991). “RC beams strengthened with FRP plates. II: Analysis and parametric study.” Journal of Structural Engineering, ASCE, 117(11), 3434-3455.

3. Meier, U. and Kaiser, H. (1991). “Strengthening structures with CFRP laminates.” Proc., Advanced Compos. Mat. in Civ. Engrg. Struct., ASCE, New York, 224-232.

4. Sharif, A. , A1-Sulaimani, G. J. , Basunbul, I. A. , Baluch, M. H. and Ghaleb, B. N. (1994). “Strengthening of initially loaded reinforced concrete beams using FRP plates.” ACI Struct. J., 91(2), 160-168.

5. Sierakowski, R. L. , Ross, C. A. , Tedesco, J. W. and Hughes, M. L. (1994). “Concrete beams with externally bonded carbon fiber reinforced plastic strips.” Proceedings of the Third Materials Engineering Conference: Infrastructure: New materials and Methods for Repair, ASCE, San Diego, California, 212-220.

6. Chajes, M. J. , Januszka, T. F. , Merz, D. R. , Thomson, T. A. and Finch, W. W. (1995). “Shear Strengthening of reinforced concrete beams using externally applied composite fabrics.” ACI Struct. J., 92(3), 295-303.

7. Quantrill, R. J. , Holloway, L. C. and Thorne, A. M. (1996). “Predictions of the maximum plate end stresses of FRP strengthened beams: part II.” Mag. Concrete Res., 48(177), 343-351.

8. Norris, T. , Saadatmanesh, H. and Ehsani, M. R. (1997). “Shear and flexural strengthening of reinforced concrete beams with carbon fiber sheets.” J. of Struct. Engrg., ASCE, 123(7), 903-911.

9. Arduini, M. and Nanni, A. (1997). “parametric study of beams with externally bonded FRP reinforcement.” ACI Struct. J., 94(5), 493-501.

10.

10. Malek, A. M. (1997). “Analytical study of reinforced concrete beams strengthened with FRP plates or fabrics,” PhD dissertation, University of Arizona, Tucson.

11.

11. Malek, A. M. , Saadatmanesh, H. and Ehsani, M. R. (1998). “Prediction of failure load of R/C beams strengthened with FRP plate due to stress concentration at the plate end.” ACI Struct. J., 95(1), 142-152.

12.

12. Triantafllou, T. C. (1998). “Shear Strengthening of reinforced concrete beams using epoxy-bonded FRP composites.” ACI Struct. J., 95(2), 107-115.

13.

13. Malek, A. M. and Saadatmanesh, H. (1998). “Analytical study of reinforced concrete beams strengthened with web-bonded fiber reinforced plastic plates or fabrics.” ACI Struct. J., 95(3), 343-352.

14.

14. Malek, A. M. and Saadatmanesh, H. (1998). “On the analysis and design of reinforced concrete beams strengthened with FRP laminates.” Arabian Journal for Science and Engineering, 23(2C), 167-182.

15.

15. Saadatmanesh, H. and Malek, A. M. (1998). “Design guidelines for flexural strengthening of RC beams with FRP plates.” J. of Compos. for Constr., ASCE, 2(4), 158-164.

16.

16. Grace, N. F. , Soliman, A. K. , Sayed, G. A. and Saleh, K. R. (1998). “Behavior and ductility of simple and continuous FRP reinforced beams.” J. of Compos. for Constr., ASCE, 2(4), 186-194.

17.

17. Ross, C. A. , Jerome, D. M. , Tedesco, J. W. and Hughes, M. L. (1999). “Strengthening of reinforced concrete beams with externally bonded composite laminates.” ACI Struct. J., 96(2), 212-220.

18.

18. Grace, N. F. , Sayed, G. A. , Soliman, A. K. and Saleh, K. R. (1999). “Strengthening reinforced concrete beams using fiber reinforced polymer (FRP) laminates.” ACI Struct. J., 96(5), 865-874.

19.

19. Rabinovich, O. and Frostig, Y. (2000). “Closed-form high-order analysis of RC beams strengthened with FRP strips.” J. of Compos. for Constr., ASCE, 4(2), 65-74.

20.

20. El-Mihilmy, M. T. and Tedesco, J. W. (2000). “Analysis of reinforced concrete beams strengthened with FRP laminates.” J. of Struct. Engrg., ASCE, 126(6), 684-691.