Application of Falling Weight Deflectometer Data for Analysis of Superheavy Loads

Abstract

Permitting superheavy loads may increase the rate of pavement damage and the cost of maintenance. An analysis of a proposed superheavy load route (FM519) to evaluate the potential pavement damage caused by a planned superheavy load move is presented. Falling weight deflection (FWD) tests and backcalculations of layer moduli were performed on the FM519. FWD tests and backcalculation of layer moduli were performed on the pavement before and after the superheavy load was moved. ELSYM5 and BISAR were used to evaluate the pavement responses using the backcalculated layer moduli from FWD data. The predictions of surface deflections from ELSYM5 and BISAR were close to (within 10 percent of) the measured deflections from FWD tests. The FWD data and analyses show that the existing pavement structure is adequate for the planned superheavy load move. Finally, the permit was issued with the condition that the transport vehicle should be kept within the travel lanes and away from the shoulder whenever possible. FWD tests were conducted after the superheavy load move and comparisons with before superheavy load move were made. T-tests were performed to check for significant difference at the 95 percent confidence level. T-tests showed that there is no significant difference between before and after superheavy load move. Also, no significant distresses due to this superheavy load were observed after the move, and the pavement condition is consistent with the analysis performed to issue the permit.

Get full access to this article

View all access options for this article.

References

Oversize-Overweight Permit Booklet. Draft. Texas Department of Transportation, Oct. 1994.

Zaghloul

S. M.

, White

T. D.

, Ramirez

J. A.

, White

D. W.

, and Prasad

N. B. R.

. Computerized Overload Permitting Procedure for Indiana. In Transportation Research Record 1448, TRB, National Research Council, Washington, D.C., 1994, pp. 40–52.

Kang

Y. V.

, Roesset

J. M.

, and Stokoe

K. H.

II Effect of Finite Width on Dynamic Deflections of Pavements. Research Report 1123-6. Project 2/3-18-87/0-1123, Center for Transportation Research, University of Texas, Austin, 1991.

Zaghloul

S. M.

, and White

T. D.

, Use of a Three Dimensional–Dynamic Finite Element Program for Analysis of Flexible Pavement. In Transportation Research Record 1388, TRB, National Research Council, Washington, D.C., 1993, pp. 60–69.

Scullion

Incorporating a structural Strength Index into the Texas Pavement Evaluation System. Research Report FHWA/TX-88/409-3F, Texas Transportation Institute, Texas A&M University System, College Station, 1988.

Jooste

F. J.

, and Fernando

E. G.

. Victoria Superheavy Load Move: Report on Route Assessment and Pavement Modeling. Research Report 1335-1, Texas Transportation Institute, Texas A&M University System, College Station, 1994.

Chen

W. F.

, and Baladi

G. Y.

. Soil Plasticity: Theory and Implementation. Developments in Geotechnical Engineering, No. 38, Elsevier, New York, 1985.

Uzan

Resilient Characterization of Pavement Materials. International Journal for Numerical and Analytical Methods in Geomechanics, Vol. 16, 1992, pp. 453–459.

AASHTO Guide for Design and Pavement. American Association of State Highway and Transportation Officials, Washington, D.C., 1993.

10.

Jooste

F. J.

, and Fernando

E. G.

. Development of a Procedure for the Structural Evaluation of Superheavy Load Routes. Research Report 1335-3F, Texas Transportation Institute, Texas A&M University Sytem, College Station, 1995.

11.

Triaxial Compression Tests for Disturbed Soils and Base Materials. Manual of Test Procedures, Texas Department of Transportion, Vol. 1, 1991.