Efforts by North Carolina Department of Transportation to Develop Mechanistic Pavement Design System

Abstract

A first generation mechanistic empirical pavement design procedure was developed using falling weight deflectometer deflections taken over a 3-year period at 16 test sections in Siler City, North Carolina. Information available for use in developing the procedure included deflection data, surface and air temperature, coring thicknesses at each test location, pavement performance records regarding rate of cracking, and traffic records. Jung's method, based on the curvature of the deflection bowl, was used to calculate strain at the bottom of the asphalt layer as a measure of fatigue. This calculated strain was used to obtain a calculated number of load repetitions to failure. Comparision of actual loads to failure with calculated loads to failure resulted in a table of shift factors by pavement type.

Get full access to this article

View all access options for this article.

References

AASHTO Guide for Design of Pavement Structures. American Association of State Highway and Transportation Officials, Washington, D.C., 1993.

AASHO Interim Guide for Design of Pavement Structures. American Association of State Highway Officials, Washington, D.C., 1972.

Khosla

An Evaluation of Pavement Instrumentation Technology. North Carolina State University, Raleigh, May 1990.

Calibrated Mechanistic Structural Analysis Procedure for Pavements, Volumes 1 and 2. NCHRP Project 1-26, Phase 2. TRB, National Research Council, Washington, D.C., 1992.

Pierce

L. M.

, Jackson

N. C.

, and Mahoney

J. P.

. Development and Implementation of a Mechanistic, Empirically Based Overlay Design Procedure for Flexible Pavements. In Transportation Research Record 1388, TRB, National Research Council, Washington, D.C., 1993 pp. 120–128.

Monismith

C. L.

, and Epps

J. A.

. Asphalt Mixture Behavior in Repeated Flexure. Institute of Transportation and Traffic Engineering, University of California, Berkeley, 1969.

Thompson

M. R.

, and Cation

. A Proposed Full-Depth Asphalt Concrete Thickness Design Procedure. Civil Engineering Studies, Transportation Engineering Series 45, University of Illinois, Urbana-Champaign, 1986.

Thickness Design-Asphalt Pavements for Highways and Streets. Manual Series 1 (MS-1), Asphalt Institute, Lexington, Ky., 1991.

Kim

Y. R.

, Hibbs

B. O.

, Lee

Y. C.

, Inge

E. H.

Jr. Asphalt Paving Material Properties Affected by Temperature. Center for Transportation Engineering Studies, North Carolina State University, Raleigh, March 1994.

10.

Gomez-Achecar

, and Thompson

M. R.

. ILLI-PAVE-Based Response Algorithms for Full-Depth Asphalt Concrete Flexible Pavements. In Transportation Research Record 1095, TRB, National Research Council, Washington, D.C., 1986, pp. 11–18.

11.

Thompson

M. R.

, and Elliott

R. P.

. ILLI-PAVE-Based Response Algorithms for Design of Conventional Flexible Pavements. In Transportation Research Record 1043, TRB, National Research Council, Washington, D.C., 1985, pp. 50–57.

12.

Jung

F. W.

Direct Calculation of Maximum Curvature and Strain in Asphalt Concrete Layers of Pavements from Load Deflection Basin Measurements. In Transportation Research Record 1196, TRB, National Research Council, Washington, D.C., 1988, pp. 125–132.

13.

Scullion

, Uzan

, and Paredes

. MODULUS: A Microcomputer-Based Backcalculation System. In Transportation Research Record 1260, TRB, National Research Council, Washington, D.C., 1990, pp. 180–191.