Practical Procedure for Developing Dynamic Modulus Master Curves for Pavement Structural Design

Abstract

A dynamic modulus master curve for asphalt concrete is a critical input for flexible pavement design in the mechanistic–empirical pavement design guide developed in NCHRP Project 1–37A. The recommended testing to develop the modulus master curve is presented in AASHTO Provisional Standard TP62–03, Standard Method of Test for Determining Dynamic Modulus of Hot-Mix Asphalt Concrete Mixtures. It includes testing at least two replicate specimens at five temperatures between 14°F and 130°F (–10°C and 54.4°C) and six loading rates between 0.1 and 25 Hz. The master curve and shift factors are then developed from this database of 60 measured moduli using numerical optimization. The testing requires substantial effort, and there is much overlap in the measured data, which is not needed when numerical methods are used to perform the time–temperature shifting for the master curve. This paper presents an alternative to the testing sequence specified in AASHTO TP62–03. It requires testing at only three temperatures between 40°F and 115°F (4.4°C and 46.1°C) and four rates of loading between 0.01 and 10 Hz. An analysis of data collected using the two approaches shows that comparable master curves are obtained. This alternative testing sequence can be used in conjunction with the simple performance test system developed in NCHRP Project 9–29 to develop master curves for structural design.

Get full access to this article

View all access options for this article.

References

Dougan

, Stephens

, Mahoney

, and Hansen

. E^*-Dynamic Modulus Test Protocol—Problems and Solutions. Publication CT-SPR-0003084-F03-3. Connecticut Department of Transportation and Federal Highway Administration, 2003.

Witczak

M. W.

NCHRP 9–19 Video Conference. Presented at the National Cooperative Highway Research Program, Washington, D.C., Nov. 7, 2003.

ARA, Inc. ERES Consultants Division. Guide for Mechanistic–Empirical Design of New and Rehabilitated Pavement Structures. Final Report to the National Cooperative Highway Research Program. NCHRP, Washington, D.C., March 2004.

Christensen

D. W.

, and Anderson

D. A.

. Interpretation of Dynamic Mechanical Test Data for Paving Grade Asphalt Cements. Journal of the Association of Asphalt Paving Technologists, Vol. 61, 1992, pp. 67–116.

Mirza

M. W.

, and Witczak

M. W.

. Development of a Global Aging System for Short and Long Term Aging of Asphalt Cements. Journal of the Association of Asphalt Paving Technologists, Vol. 64, 1995, pp. 393–430.

Designation: D 2493-01.

Standard Viscosity–Temperature Chart for Asphalts.

2003 Annual Book of ASTM Standards, Volume 04.03, ASTM International, West Conshohoken, Pa., 2003.

Christensen

D. W.

, Pellinen

T. K.

, and Bonaquist

R. F.

. Hirsch Model for Estimating the Modulus of Asphalt Concrete. Journal of the Association of Asphalt Paving Technologists, Vol. 72, 2003, pp. 97–121.

Pellinen

T. K.

Investigation of the Use of Dynamic Modulus as an Indicator of Hot-Mix Asphalt Performance. Ph.D. dissertation. Arizona State University, May 2001.

Bonaquist

R. F.

, Christensen

D. W.

, and Stump

. Simple Performance Tester for Superpave Mix Design: First Article Development and Evaluation. NCHRP Report 513. National Cooperative Highway Research Program, Washington, D.C., 2003.