Effect of Coarse Aggregate Morphology on the Resilient Modulus of Hot-Mix Asphalt

Abstract

The resilient modulus measured in the indirect tensile mode according to ASTM D 4123 reflects effectively the elastic properties of asphalt mixtures under repeated load. The coarse aggregate morphology quantified by angularity and surface texture properties affects resilient modulus of asphalt mixes; however, the relationship is not yet well understood because of the lack of quantitative measurement of coarse aggregate morphology. This paper presents findings of a laboratory study aimed at investigating the effects of the material properties of the major component on the resilient modulus of asphalt mixes, with the coarse aggregate morphology considered as the principal factor. With modulus tests performed at a temperature of 25°C, using coarse aggregates with more irregular morphologies substantially improved the resilient modulus of asphalt mixtures. An imaging-based angularity index was found to be more closely related to the resilient modulus than an imaging-based surface texture index, as indicated by a higher value of the correlation coefficient. The stiffness of the asphalt binder also had a strong influence on modulus. When the resilient modulus data were grouped on the basis of binder stiffnesses, the agreement between the coarse aggregate morphology and the resilient modulus was significantly improved in each group. Although the changes in aggregate gradation did not significantly affect the relationship between the coarse aggregate morphology and the resilient modulus, decreasing the nominal maximum aggregate size from 19 mm to 9.5 mm indicated an increasing positive influence of aggregate morphology on the resilient modulus of asphalt mixes.

Get full access to this article

View all access options for this article.

References

Robert

F. L.

, Kandhal

P. S.

, Brown

E. R.

, Lee

D. Y.

, and Kennedy

T. W.

. Hot Mix Asphalt Materials, Mixture Design, and Construction. NAPA Education Foundation

Lanham, Md.,

1996, pp. 502–507.

Seed

H. C.

, Chan

C. K.

, and Lee

C. E.

. Resilient Characteristics of Subgrade Soils and Their Relation to Fatigue Failures in Asphalt Pavements. Proc., International Conference on the Structural Design of Asphalt Pavements, University of Michigan, 1962.

Mamlouk

M. S.

, and Ramsis

R. T.

. Modulus of Asphalt Mixtures—An Unresolved Dilemma. In Transportation Research Record 1171, TRB, National Research Council, Washington, D.C., 1988, pp. 193–198.

Baladi

G. Y.

, and Harichandran

R. S.

. Asphalt Mix Design and the Indirect Test: A New Horizon. In Asphalt Concrete Mix Design: Development of More Rational Approaches, ASTM STP 1041 ( Gartner

Jr. , ed.). American Society for Testing and Materials, Philadelphia, Pa., 86–105, 1989.

Monismith

C. L.

Influence of Shape, Size, and Surface Texture on the Stiffness and Fatigue Response of Asphalt Mixtures. In Special Report: 109, HRB, National Research Council, Washington, D.C., 1970, pp. 4–11.

Masad

, and Button

J. W.

. Unified Imaging Approach for Measuring Aggregate Angularity and Texture. International Journal of Computer-Aided Civil and Infrastructure Engineering—Advanced Computer Technologies in Transportation Engineering, Vol. 15, No. 4, 2000, pp. 273–280.

Tutumluer

, Rao

, and Stefanski

J. A.

. Video Image Analysis of Aggregates. Civil Engineering Studies UILU-ENG-2000–2015. Final Project Report, FHWA-IL-UI-278. University of Illinois Urbana-Champaign, Urbana, Ill., 2000.

Rao

, Tutumluer

, and Kim

I. T.

. Quantification of Coarse Aggregate Angularity Based on Image Analysis. In Transportation Research Record: Journal of the Transportation Research Board, No. 1787, Transportation Research Board of the National Academies, Washington, D.C., 2002, pp. 117–124.

Pan

, Tutumluer

, and Carpenter

S. H.

. Imaging Based Evaluation of Coarse Aggregate Used in the NCAT Pavement Test Track Asphalt Mixes. Proc., 1st International Conference on Design and Construction of Long Lasting Asphalt Pavements, Auburn, Ala., 2004, June 7–10.

10.

Rao

, Pan

, and Tutumluer

. Determination of Coarse Aggregate Surface Texture Using Imaging Analysis. Proc., 16th ASCE Engineering Mechanics Conference, University of Washington, Seattle, 2003.

11.

Van der Poel

C. A.

General System Describing the Viscoelastic Properties of Bitumens and Its Relationship to Routine Test Data.

Journal of Applied Chemistry, May 1954.

12.

Seward

D. L.

, Hinrichsen

J. A.

, and Ries

J. L.

. Structure Analysis of Aggregate Blends Using Strategic Highway Research Program Gyratory Compactor. In Transportation Research Record 1545, TRB, National Research Council, Washington, D.C., 1996, pp. 82–88.