Workspace and Mobility of a Closed- Loop Manipulator

Abstract

This paper examines the geometry of a group of closed-loop manipulators with structures based on a planar, revolute jointed, five-bar chain. Of primary interest is the influence of the link lengths on the reachable workspace of the manipula tor. Unlike the commonly used open-loop manipulators, the entire workspace for a closed-loop manipulator will not be freely reachable, in general. The issues pertaining to the independent mobility of the driving links are discussed at length. A classification is made based on mobility criteria, and these mechanisms are further categorized into two types depending upon the influence of the link lengths on the ma nipulator's workspace. Based on this analysis, some general guidelines are laid down to assist the designer in making rational choices in selecting manipulator link lengths.

Get full access to this article

View all access options for this article.

References

Asada, H. , and Ro, I.H. 1984 (Oct., Cambridge, Mass.). A linkage design for direct-drive robot arms ASME Paper No. 84-DET-143. Presented at ASME 18th Mechanisms Conf.

Bajpai, A. 1984. Workspace and mobility of links of a closed-loop manipulator. Engineers Thesis, Stanford University, Department of Mechanical Engineering.

Freudenstein, F. , and Primrose, E.J.F. 1963. Geared five-bar motion: part I—gear ratio minus one ASME J. Applied Mechanics, Series E, 30(2):161-169.

Primrose, E. J. F. , and Freudenstein, F. 1963. Geared five-bar motion: part II—arbitrary commensurate gear ratio ASME J. Applied Mechanics, Series E, 30(2):170-175.

Stewart, D. 1965 (London, England). A platform with six degrees of freedom. Proc Inst. Mech. Engr. , 180(1):371- 386.

Trevelyan, J.P. , Kovesi, P.D. , and Ong, M.C.H. 1984. Motion control for a sheep shearing robot Robotics Research, 1st Int. Symp., eds. Michael Brady and Richard Paul. Cambridge: MIT Press, pp. 175-190.