Member Ductility and Design Detail of Some Welded Joints

Abstract

The behaviour of tubular steel members and their connections are studied under ultimate tensile load conditions. Three end connection details are considered. These are practical connections, but one has a deliberately introduced defect of welding fabrication detail. Two types of steel are used: one is a conventional semi-killed mild steel, while the other is a rimmed steel that has been cold formed to produce an enhanced yield stress. The ratio of ultimate stress to yield stress (strain hardening ratio) is widely different for the two steels. The tests highlight the reduction in ultimate-load capacity and the severely reduced ductility that follows when defects of fabrication and low strain hardening ratio steels occur together.

Get full access to this article

View all access options for this article.

References

Kitipornchai

and Traves

W. H.

, Design of cap-cleat plate end connections for tubes, Res. Rep. CE68, Dept of Civ. Eng., Univ. of Queensland. Feb. (1986), 32 pages.

Lay

M. G.

and Smith

P. D.

, Role of strain hardening in plastic design, Proc. ASCE, 91, ST3, June (1965), 25-43.

Dhalla

A. K.

and Winter

, Steel ductility measurements, Proc. ASCE, 100, ST2, Feb. (1974), 427-44.

Dhalla

A. K.

and Winter

, Suggested steel ductility requirements, Proc. ASCE, 100, ST2, Feb. (1974), 445-62.

Morgan

P. R.

and Schmidt

L. C.

, The influence of material effects on tubular steel strut capacity, Res. Rep. RR/Struct/11/1985, Dept. of Civil and Agr. Eng., Univ. of Melbourne, March (1985), 56 pages.