The development of a goal directed simulation environrnent for discrete part manufacturing systems is discussed. A two phase approach was taken for the development of the nile base. The first phase involved studying different types of manufacturing systems in order to identify the cause-and-effect relationships that an analyst may use during analysis. Based on the "expert" knowledge identified in this phase, and subsequent experimentation, a detailed set of rules was developed. The rule base has a four level structure. Of these, Levels 2, 1, and 0 are generic, while the fourth level is comprised of information specific to the system under consideration.
Glankawahmdee, A., J.S. Liebman, and G.L. Hogg, 1979, "Unconstrained Discrete Non-Linear Programming ," Engineering Optimization, 4, 95-107
2.
Ford, D.R., and B.J. Schroer, 1987, " An Expert Manufacturing Simulation System," SIMULATION, 48,194-200.
3.
Haddock, J., 1987, "An Expert Framework Based on a Simulation Generator ," SIMULATIDN, 48, 2, 45-53.
4.
Himmelblau, D.M., 1972, Applied Nonlinear Programming, McGraw-Hill , New York.
5.
Koshnevis, B., and A. Chen, 1986, "An Expert System Model Builder," Proceedings of Conference on Intelligent Simulation Environments , SCS Simulation Series,17:1,129-132.
6.
Meketon, M.S., 1987, "Optimization in Simulation : A Survey of Recent Results ," Proceedings of the 1987 Winter Simulation Conference , 58-67.
7.
Murray, K.J., and S.V. Sheppard, 1988, "Knowledge-Based Simulation Model Specification ," SIMULATION, 50, 112-119.
Pegden, C.D., 1986, Introduction to SIMAN, System Modeling Corporation, State College, PA.
10.
Prakash, S., and R.E. Shannon, 1989, "Intelligent Back End of a Goal Directed Simulation Environment for Discrete Part Manufacturing," Proceedings of the Winter Simulation Conference, 883-891.
11.
Seliger, G., B. Vieweger, B. Wieneke, and S.R. Kommana, 1987, "Knowledge Based Simulation of Flexible Manufacturing Systems," Proceedings of the European Simulation Multiconference, 65-68.
12.
Shannon, R.E., 1988, "Knowledge Based Simulation Techniques for Manufacturing ," International Journal of Production Research, 26, 953-973.
13.
Wadhwa, S., C. Felix., and J. Browne, 1987, "A Goal Directed Data Driven Simulator for FAS Design ," Presented in the 1987 European Simulation Multiconference , Vienna, Austria.
