In this study, experimental bond investigations through pullout and split tensile testing were carried out for the possible application of embedded fiber reinforced polymer laminates/plates as internal reinforcements as an alternative form of reinforcement to fiber reinforced polymer rods. The effect of different surface treatments and two concrete compressive strengths on the bond behavior are the main parameters investigated. Results showed that the bond strength of the embedded carbon fiber reinforced polymer plates increased as the concrete compressive strength increased and that the surface condition of the embedded carbon fiber reinforced polymer plate enhanced the bond behavior. An in-depth visual examination of the test specimens after failure indicated that bond failure occurred in both the concrete and at the resin layer of the embedded carbon fiber reinforced polymer plate. In addition, the tensile bond strength of the concrete-fiber reinforced polymer interface for different surface conditions is determined. The failure mode and bond strengths of embedded carbon fiber reinforced polymer plates was found to depend on the relative shear strengths of the concrete and resin layer interfaces.
De LorenzisL. Anchorage length of near-surface mounted fiber-reinforced polymer rods for concrete strengthening – analytical modeling. ACI Struct J2004; 101(3): 375–386.
2.
Blaschko M and Zilch K. Rehabilitation of concrete structures with CFRP strips glued into slits. In: Proceedings of the 12th international conference on composite materials, Paris, July 5–9, 1999, pp. 1–7.
3.
Cruz JMS and Barros JAO. Bond behavior of carbon laminate strips into concrete by pull-out bending tests. In: Proceedings bond in concrete: from research to standards, Budapest, November 20–22, 2002, pp.614–621.
4.
TengJGDe LorenzisLWangB. Debonding failures of RC beams strengthened with near surface mounted CFRP strips. J Compos Construct, ASCE2006; 10(2): 92–105.
5.
BakisCEUppuluriVSNanniA. Analysis of bonding mechanisms of smooth and lugged FRP rods embedded in concrete. Compos Sci Technol1998; 58: 1307–1319.
6.
NanniABakisCEBoothbyTE. Test methods for FRP-concrete systems subjected mechanical loads: state of the art review. Reinforc Plast Compos J1995; 14(6): 524–558.
7.
AchillidesZPilakoutasK. Bond behavior of fiber reinforced polymer bars under direct pullout conditions. J Compos Construct2004; 8(2): 173–181.
8.
HarriesKAReeveBZornA. Experimental evaluation of factors affecting monotonic and fatigue behavior of fiber reinforced polymer concrete bond in reinforced concrete beams. ACI Struct J2007; 104(6): 667–674.
9.
LeeJ-YKimT-YKimT-J. Interfacial bond strength of glass fiber reinforced polymer bars in high-strength concrete. Compos Pt B: Eng2008; 38: 258–270.
10.
Achillides Z. Bond behavior of FRP bars in concrete. Thesis, Centre for Cement and Concrete, Department of Civil and Structural Engineering, The University of Sheffield, 1998.
11.
ShimaHSugaTHonmaM. Local bond stress-slip relationship of continuous fibre reinforcing materials obtained by pull bond test with long embedment. Transport Jpn Concr Instit1993; 15: 297–304.
12.
OkeloRYuanRL. Bond strength of fiber reinforced polymer rebars in normal strength concrete. J Compos Construct2005; 9(3): 203–213.
13.
Sika Group Sdn. Bhd. Product data sheet for Sika CarboDur plates. Switzerland: Sika Group, 2008.
14.
BazantZPSenerS. Size effect in pullout tests. ACI Mater J1988; 85(5): 347–351.
15.
De LarradFSchallerDFuchsJ. Effect of bar diameter on the bond strength of passive reinforcement in high-performance concrete. ACI Mater J1993; 90(4): 333–339.
16.
AzizinaminiAStarkMRollerJJ. Bond performance of reinforcing bars embedded in high-strength concrete. ACI Struct J1993; 90(5): 554–561.
17.
MoYLChanJ. Bond and slip of plain re-bars in concrete. J Mater Civil Eng1996; 8(4): 208–211.
18.
Al-MahmoudFCastelAFrancoisR. Effect of surface pre-conditioning on bond of carbon fibre reinforced polymer rods to concrete. Cement Concr Compos2007; 29(9): 677–689.
19.
HaoQ-DWangY-LZhangZ-C. Bond strength improvement of GFRP bars with different rib geometries. J Zhejiang Univ Sci A2007, 8(9): 1356–1365.
20.
BS8110; Structural Use of Concrete; Part 1: 1985 “Code of practice for design and construction” by British Standard Institution, 1985.
21.
AielloMALeoneMPecceM. Bond performances of FRP rebars-reinforced concrete. J Mater Civil Eng2007; 19(3): 205–213.
22.
Arias JPM, Vazquez A and Escobar M. Use of sand coating to improve bonding between GFRP bars and concrete. J Compos Mater 2012; 46(18): 1–8.
23.
AhmadFSGillesFRobertL. Bond between carbon fibre-reinforced polymer (CFRP) bars and ultra high performance fibre reinforced concrete (UHPFRC): experimental study. Construct Build Mater J2011; 25: 479–485.
24.
PecceMManfrediGRealfonzoR. Experimental and analytical evaluation of bond properties of GFRP bars. J Mater Civil Eng2001; 13(4): 282–290.
25.
Tepfers R, Hedlund G and Rosinski B. Pullout and tensile reinforcement splice tests with GFRP bars. In: Proceedings 2nd international conference on composites in infrastructure (ICCI′ 98) (eds H Saadatmanesh and MR Ehsani), Tuscon, AZ, Vol. II, 5–7 January 1998, pp.37–51.
26.
WangHAbdeldjelilB. Static and fatigue bond characteristics of FRP rebars embedded in fiber-reinforced concrete. J Compos Mater2010; 44(13): 1605–1622.
27.
Makitani E, Irisawa I and Nishiura N. Investigation of bond in concrete members with fiber reinforced plastic bars. In: Proceedings of the international symposium on fiber reinforced plastic reinforcement for concrete structures. ACI SP-138 (eds A Nanni and CW Dolan), 1 September 1993, pp. 315–332.
28.
Nanni A, Al-Zaharani MM, Al-Dulaijan SU, et al. Bond of FRP reinforcement to concrete-experimental results. In: Taerwe L (ed.) Proceedings 2nd international RILEM symposium (FRPRCS-2), 23--25 August 1995, pp. 135–145.
29.
Rossetti AV, Galeota D and Giammatteo MM. Local bond stress-slip relationships of glass fibre reinforced plastic bars embedded in concrete. Mater & Struct 1995; 28(6): 340–354.
30.
Faoro M. Bearing and deformation behavior of structural components with reinforcements comprising resin bounded glass fibre bars and conventional ribbed steel bars. In: Proceedings of the international conference: Bond in concrete, Riga, Latvia, 15–17 October 1992, pp. 9-11–9-20.
31.
ItohSMaruyamaTNishiyamaH. Study of bond characteristics of deformed fiber reinforced plastic rods. Proc Jpn Concr Instit1989; 11(1): 777–782.
32.
CosenzaEManfrediGRealfonzoR. Behaviour and modeling of bond of FRP rebars to concrete. J Compos Construct, ASCE1997; 1(2): 40–51.
