Microstrip Antenna for SAR Application with Composite Sandwich Construction: Surface-antenna-structure Demonstration

Abstract

A 5.3 GHz microstrip antenna for use in synthetic aperture radar (SAR) systems was developed with a composite sandwich construction, using composite laminates, Nomex honeycomb and aluminum alloy. This is the surface-antenna-structure (SAS) for application to load-bearing structural surfaces. The design concept originated from a composite sandwich structure and a multi-layer microstrip antenna. Design, fabrication and validation of structural/electrical performances were all demonstrated. To verify the structural rigidity, flexural behavior was observed under the three-point bending test and was compared with two kinds of composite sandwich beams consisting of CFRP–GFRP skins and Nomex honeycomb core. Electrical measurements of the fabricated antenna array were in good agreement with design requirements, and a comparative study found that SAS has good mechanical characteristics. The SAS concept can be extended to give a useful guide to manufacturers of structural body panels as well as antenna designers, promising innovative future communication technology.

Keywords

SAS surface-antenna-structure composite microstrip antenna SAR

Get full access to this article

View all access options for this article.

References

1. Tuss, J. etal. (1996). 37th AIAA SDM Conference, pp. 836–843.

2. Lockyer, A. J. et al. (1999). Part of the SPIE Conference on Industrial and Commercial Applications of Smart Structures Technologies, 3674: 410–424.

3. Zucher, J. F. (1988). Electronics Letters, 24(23): 1433–1435.

4. Zucher, J. F. and Gardiol, F. E. (1995). Broadband Patch Antennas, Archtech House, 49–61.

5. Pokuls, R. , Uher, J. and Pozar, D. M. (1995). IEEE Trans. Antennas Prop., 46(9): 1289–1296.

6. Carver, K. R. and Mink, J. W. (1981). IEEE Trans. Antennas Propa., AP-29(1): 2–24.

7. Allen, H. G. (1969). Analysis and Design of Structural Sandwich Panels, Pergamon Press, 156–189.