The paper describes the stages in design, development and manufacture which have led to the successful introduction of magnox fuel into the first phase of the British nuclear programme. Significant design problems are discussed and attention is directed towards the main limitations in fuel performance and endurance.
Detailed results of fuel irradiation trials are presented and future developments are discussed.
Get full access to this article
View all access options for this article.
References
1.
A programme of nuclear power Cmd 9389-1955 (H.M. Stationery Office, London).
2.
EldredV. W. Private communication, April 1963.
3.
CottrellA. H.‘Effect of nuclear radiation on engineering materials’, J. Brit. nucl. Energy Conf. 19605 (April), 64.
4.
HardyH. K.LawtonH.‘Assessment and testing of fuel elements’, Proc. Second Int. Conf. Peaceful Uses of Atomic Energy (Geneva 1958)19595, 521.
5.
. Proc. Symp. Use of Secondary Surfaces for Heat Transfer with Clean Gases 1960 (Instn mech. Engrs, London); reprinted in J. Brit. nucl. Energy Conf. 1961 6 (October), 275.
6.
FranklinN. L.JohnsonA.CloughE.‘Selecting a fuel cycle for magnox reactors’, Nucl. Power19616 (November), 79.
7.
HardyH. K.BishopJ. F. W.PickmanD. O.EldredV. W.‘Development of uranium-magnox fuel elements for an average irradiation life of 3000 MWD/Te’J. Brit. nucl. Energy Soc. 19632 (January), 33.
8.
FairD. R. R.FranklinN. L.‘Fuel and fuel cycles for magnox reactors’, Proc. Anglo-Jap. nucl. Power Symp. 1963 (Paper no. 8, Session no. 4).
9.
VaughanR. D.Contribution to discussionProc. Anglo-Jap. nucl. Power Symp. 1963.
