Cross-correlation transit-time measuring instrumentation is now inherently accurate to a few ppm depending upon the sensing technology, but when ultrasonic sensors are used to measure fluid flow the accuracy is determined mainly by the fluid properties and flow profile. This paper describes the operation of the ultrasonic cross-correlation flowmeter and its performance in different applications.
Get full access to this article
View all access options for this article.
References
1.
CoulthardJ‘Improvements in or relating to the measurement of fluid flowrates’, British Patent 1359151, 1973.
KeechR P (1982) The Kent multichannel correlation signal processor for velocity measurement, Trans InstMC, 14, No 1.
4.
XuL (1988. J Phys E Sci Inst, 21, 404–414.
5.
NuijtenJ A, ‘Industrial mass flow measurement trials using an ultrasonic cross-correlation flowmeter’, FLOMEKO1983.
6.
McLeroyE GDeLoachA (1968) Sound speed and attenuation from 15 to 15000 kHz measured in natural sea-floor sediments, JASA, 44, No 4.
7.
KingN W‘Cross correlation measurements in oil–air mixtures’, IMEKO XI World Congress, Houston, 1988.
8.
SidneyJ K, Cross-correlation flow measurement in liquid-gas mixtures, PhD thesis, University of Teesside/NEL, 1989.
9.
ByrneB, Ultrasonic and nucleonic cross correlation measurements of air–water mixtures in vertical upwards flow, Int. Conf. on Basic Principles and Industrial Applications of Multiphase Flow, IBC Technical Services, April 1990.
10.
CoulthardJYanY (1993) Vortex wake transit time measurements for flow metering, Flow Measurement and Instrumentation, 4, No 4.
