Force Control Strategy of Five-Digit Precision Grasping With Aligned and Unaligned Configurations

Abstract

Objective

To investigate the digit force control during a five-digit precision grasp in aligned (AG) and unaligned grasping (UG) configurations.

Background

The effects of various cylindrical handles for tools on power grasp performance have been previously investigated. However, there is little information on force control strategy of precision grasp to fit various grasping configurations.

Method

Twenty healthy young adults were recruited to perform a lift-hold-lower task. The AG and UG configurations on a cylindrical simulator with force transducers were adjusted for each individual. The applied force and moment, the force variability during holding, and force correlations between thumb and each finger were measured.

Result

No differences in applied force, force correlation, repeatability, and variability were found between configurations. However, the moments applied in UG were significantly larger than those in AG.

Conclusion

The force control during precision grasp did not change significantly across AG and UG except for the digit moment. The simulator is controlled efficiently with large moment during UG, which is thus the optimal configuration for precision grasping with a cylindrical handle. Further research should consider the effects of task type and handle design on force control, especially for individuals with hand disorders.

Application

To design the handle of specific tool, one should consider the appropriate configuration according to the task requirements of precision grasping to reduce the risk of accumulating extra loads on digits with a cylindrical handle.

Keywords

forces and moments coordinated action physical ergonomics

Get full access to this article

View all access options for this article.

References

Begliomini

Caria

Grodd

Castiello

. (2007). Comparing natural and constrained movements: New insights into the visuomotor control of grasping. PLoS One, 2, e1108.doi:10.1371/journal.pone.0001108

17971871

Budgeon

M. K.

Latash

M. L.

Zatsiorsky

V. M

. (2008). Digit force adjustments during finger addition/removal in multi-digit prehension. Experimental Brain Research, 189, 345–359.doi:10.1007/s00221-008-1430-9

18553076

Cepriá-Bernal

Pérez-González

Mora

M. C.

Sancho-Bru

J. L

. (2017). Grip force and force sharing in two different manipulation tasks with bottles. Ergonomics, 60, 957–966.doi:10.1080/00140139.2016.1235233

27616303

Chang

J.-H.

K.-Y.

F.-C

. (2008). Kinetic analysis of the thumb in jar-opening activity among female adults. Ergonomics, 51, 843–857.doi:10.1080/00140130701763621

18484399

Chen

P.-T.

Jou

I.-M.

Lin

C.-J.

Chieh

H.-F.

Kuo

L.-C.

F.-C

. (2015). Is the control of applied digital forces during natural five-digit grasping affected by carpal tunnel syndrome? Clinical Orthopaedics & Related Research, 473, 2371–2382.doi:10.1007/s11999-015-4189-x

25690168

Chen

P.-T.

Lin

C.-J.

Chieh

H.-F.

Kuo

L.-C.

Jou

I.-M.

F.-C

. (2016). The repeatability of digital force waveform during natural grasping with five digits. Measurement, 85, 124–131.doi:10.1016/j.measurement.2016.02.025

Chen

P.-T.

Lin

C.-J.

Jou

I.-M.

Chieh

H.-F.

F.-C.

Kuo

L.-C

. (2013). One digit interruption: The altered force patterns during functionally cylindrical grasping tasks in patients with trigger digits. PLoS One, 8, e83632.doi:10.1371/journal.pone.0083632

24391799

Crajé

Lukos

J. R.

Ansuini

Gordon

A. M.

Santello

. (2011). The effects of task and content on digit placement on a bottle. Experimental Brain Research, 212, 119–124.doi:10.1007/s00221-011-2704-1

21547559

Dale

A. M.

Gardner

B. T.

Zeringue

Strickland

Descatha

Franzblau

Evanoff

B. A

. (2014). Self-reported physical work exposures and incident carpal tunnel syndrome. American Journal of Industrial Medicine, 57, 1246–1254.doi:10.1002/ajim.22359

25223617

10.

Descatha

Albo

Leclerc

Carton

Godeau

Roquelaure

Petit

Aublet-Cuvelier

. (2016). Lateral epicondylitis and physical exposure at work? A review of prospective studies and meta-analysis. Arthritis Care & Research, 68, 1681–1687.doi:10.1002/acr.22874

26946473

11.

Dong

Loomer

Barr

Laroche

Young

Rempel

. (2007). The effect of tool handle shape on hand muscle load and pinch force in a simulated dental scaling task. Applied Ergonomics, 38, 525–531.doi:10.1016/j.apergo.2006.09.002

17156742

12.

Gorsche

Wiley

J. P.

Renger

Brant

Gemer

T. Y.

Sasyniuk

T. M

. (1998). Prevalence and incidence of stenosing flexor tenosynovitis (trigger finger) in a meat-packing plant. Journal of Occupational & Environmental Medicine, 40, 556–560.doi:10.1097/00043764-199806000-00008

9636936

13.

Grant

K. A.

Habes

D. J.

Steward

L. L

. (1992). An analysis of handle designs for reducing manual effort: The influence of grip diameter. International Journal of Industrial Ergonomics, 10, 199–206.doi:10.1016/0169-8141(92)90033-V

14.

Harih

Dolšak

. (2014). Comparison of subjective comfort ratings between anatomically shaped and cylindrical handles. Applied Ergonomics, 45, 943–954.doi:10.1016/j.apergo.2013.11.011

24332825

15.

Herbst

Zelnik-Manor

Wolf

. (2020). Analysis of subject specific grasping patterns. Plos One, 15, e0234969.doi:10.1371/journal.pone.0234969

32640003

16.

Jarque-Bou

Gracia-Ibáñez

Sancho-Bru

J. L.

Vergara

Pérez-González

Andrés

F. J

. (2016). Using kinematic reduction for studying grasping postures. An application to power and precision GRASP of cylinders. Applied Ergonomics, 56, 52–61.doi:10.1016/j.apergo.2016.03.003

27184310

17.

Kong

Y.-K.

Kim

D.-M.

Lee

K.-S.

Jung

M.-C

. (2012). Comparison of comfort, discomfort, and continuum ratings of force levels and hand regions during gripping exertions. Applied Ergonomics, 43, 283–289.doi:10.1016/j.apergo.2011.06.003

21696703

18.

Kong

Y.-K.

Lowe

B. D

. (2005). Optimal cylindrical handle diameter for grip force tasks. International Journal of Industrial Ergonomics, 35, 495–507.doi:10.1016/j.ergon.2004.11.003

19.

Kuijt-Evers

L. F. M.

Bosch

Huysmans

M. A.

de Looze

M. P.

Vink

. (2007). Association between objective and subjective measurements of comfort and discomfort in hand tools. Applied Ergonomics, 38, 643–654.doi:10.1016/j.apergo.2006.05.004

17010301

20.

Kuo

L.-C.

Chen

S.-W.

Lin

C.-J.

Lin

W.-J.

Lin

S.-C.

F.-C

. (2013). The force synergy of human digits in static and dynamic cylindrical grasps. PLoS One, 8, e60509.doi:10.1371/journal.pone.0060509

23544151

21.

Kuo

L. C.

Chang

J. H.

Lin

C. F.

Hsu

H. Y.

K. Y.

F. C

. (2009). Jar-opening challenges. Part 2: Estimating the force-generating capacity of thumb muscles in healthy young adults during jar-opening tasks. Proceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine, 223, 577–588.doi:10.1243/09544119JEIM504

19623911

22.

Z. M.

Latash

M. L.

Newell

K. M.

Zatsiorsky

V. M

. (1998). Motor redundancy during maximal voluntary contraction in four-finger tasks. Experimental Brain Research, 122, 71–78.doi:10.1007/s002210050492

9772113

23.

Lodha

Naik

S. K.

Coombes

S. A.

Cauraugh

J. H

. (2010). Force control and degree of motor impairments in chronic stroke. Clinical Neurophysiology, 121, 1952–1961.doi:10.1016/j.clinph.2010.04.005

20435515

24.

Lukos

Ansuini

Santello

. (2007). Choice of contact points during multidigit grasping: Effect of predictability of object center of mass location. Journal of Neuroscience, 27, 3894–3903.doi:10.1523/JNEUROSCI.4693-06.2007

17409254

25.

Marneweck

Lee-Miller

Santello

Gordon

A. M

. (2016). Digit position and forces covary during anticipatory control of whole-hand manipulation. Frontiers in Human Neuroscience, 10, 461.doi:10.3389/fnhum.2016.00461

27695406

26.

Muggleton

J. M.

Allen

Chappell

P. H

. (1999). Hand and arm injuries associated with repetitive manual work in industry: A review of disorders, risk factors and preventive measures. Ergonomics, 42, 714–739.doi:10.1080/001401399185405

10327893

27.

Rossi

de Monsabert

B. G.

Berton

Vigouroux

. (2014). Does handle shape influence prehensile capabilities and muscle coordination? Computer Methods in Biomechanics and Biomedical Engineering, 17, 172–173.doi:10.1080/10255842.2014.931657

25074220

28.

Rossi

Vigouroux

Barla

Berton

. (2014). Potential effects of racket grip size on lateral epicondilalgy risks. Scandinavian Journal of Medicine & Science in Sports, 24, e462–e470.doi:10.1111/sms.12204

24646202

29.

Sartori

Straulino

Castiello

. (2011). How objects are grasped: The interplay between affordances and end-goals. PLoS One, 6, e25203.doi:10.1371/journal.pone.0025203

21980396

30.

Seo

N. J.

Armstrong

T. J

. (2008). Investigation of grip force, normal force, contact area, hand size, and handle size for cylindrical handles. Human Factors, 50, 734–744.doi:10.1518/001872008X354192

19110833

31.

F.-C.

Chiu

H.-Y.

Chang

J.-H.

Lin

C.-F.

Hong

R.-F.

Kuo

L.-C

. (2009). Jar-opening challenges. Part 1: An apparatus for assessing hand and finger torques and forces in a jar-opening activity. Proceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine, 223, 121–129.doi:10.1243/09544119JEIM422

19239073

32.

Trejo

Jung

M.-C.

Oleynikov

Hallbeck

M. S

. (2007). Effect of handle design and target location on insertion and aim with a laparoscopic surgical tool. Applied Ergonomics, 38, 745–753.doi:10.1016/j.apergo.2006.12.004

17374356

33.

Zatsiorsky

V. M.

Gao

Latash

M. L

. (2003). Prehension synergies: Effects of object geometry and prescribed torques. Experimental Brain Research, 148, 77–87.doi:10.1007/s00221-002-1278-3

12478398

34.

Zatsiorsky

V. M.

Latash

M. L

. (2008). Multifinger prehension: An overview. Journal of Motor Behavior, 40, 446–476.doi:10.3200/JMBR.40.5.446-476

18782719