Mechanics of Type IV Tympanoplasty: Experimental Findings and Surgical Implications

Abstract

In a type IV tympanoplasty, the stapes footplate is directly exposed to incoming sound while the round window is “shielded,” usually with a fascia graft. Postoperative hearing results are quite variable, with air-bone gaps ranging from 10 to 60 dB. A cadaveric human temporal bone preparation was developed to investigate the middle ear mechanics of this operation to identify causes of variable results and to test predictions of a recently described theoretic model of type IV tympanoplasty. The ear canal, tympanic membrane, malleus, and incus were removed so as to expose the stapes and round window to the sound stimulus. A “cavum minor” chamber (air space adjacent to the round window) was constructed around the round window niche. The round window could be isolated from sound by placing an acoustic shield over this chamber. The mechanical properties of the shield, cavum minor, annular ligament, and round window membrane were varied experimentally. Stapes velocity as determined by an optical motion sensor was used as a measure of hearing level. The largest stapes velocity occurred with a mobile stapes and round window, a stiff shield, and a well-aerated cavum minor. Partial fixation of the stapes or round window caused a decrease in stapes velocity. Acoustic shields of conchal cartilage or Silastic silicone rubber sheeting (approximately 1 mm thick) provided near-optimal shielding. A temporalis fascia shield resulted in a stapes velocity 10 to 20 dB less than that seen with a cartilage or Silastic silicone rubber shield at low frequencies. A cavum minor air space as small as 16 μL was sufficient for unrestricted stapes motion, provided the air was in contact with the round window membrane. These results qualitatively matched predictions of our model, but there were some quantitative differences. The clinical implications of our results are that in order to optimize postoperative hearing, the surgeon should 1) preserve normal stapes mobility, preferably by covering the footplate with a very thin split-thickness skin graft, not a fascia graft; 2) reinforce a fascia shield with cartilage or Silastic silicone rubber; 3) create conditions that promote aeration of the round window niche; and 4) preserve the mobility of the round window membrane.